Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 31.4 — Method: first find the circumference of one turn using π × diameter, then multiply by the number of turns. Working: circumference = 3.14 × 0.5 = 1.57 m; total distance = 1.57 × 20 = 31.4 m. A student who answers 15.7 has mistakenly halved the diameter again before multiplying, using 0.25 m instead of 0.5 m. A student who answers 3.14 has simply written down π itself, without completing the circumference or multiplying by the number of turns. A student who answers 62.8 has mistakenly doubled the diameter to 1 m before multiplying, treating the given length as a radius. Answer: 31.4 m.
- (d) No — the volume factor is 2³ = 8, not the area factor 4. — For similar solids, area scales with the square of the length scale factor and volume scales with its cube — different powers of the same number, so they are not usually equal. The length scale factor here is 2, so the area scale factor is 2² = 4 (Priya's figure) but the volume scale factor is 2³ = 8. Priya is wrong: the correct volume scale factor is 8, not 4. The option claiming area and volume always scale by the same factor treats the two as interchangeable, which is only true for the length factor itself. The option giving 6 comes from multiplying the length factor by the number of dimensions (2 × 3) rather than cubing it. The option repeating '4' for volume simply reuses Priya's own area calculation.
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (d) (6, 3) — For an enlargement centred at the origin, each coordinate is multiplied by the scale factor: (2, 1) → (2 × 3, 1 × 3) = (6, 3). ((5, 4) comes from adding the scale factor to each coordinate instead of multiplying; (6, 1) comes from multiplying only the x-coordinate by 3 and leaving the y-coordinate unchanged; (2, 3) comes from multiplying only the y-coordinate by 3 and leaving the x-coordinate unchanged.)
- (c) minor segment — A chord splits a circle into two segments; the smaller of the two is called the minor segment and the larger one the major segment. "major segment" names the larger region, the opposite of what is asked for. "sector" is a different region altogether, enclosed by two radii and an arc, not by a chord. "arc" is a curved length along the circumference, not an enclosed region at all.
- (c) An L-shape — Method: to find the front elevation, trace the outline of the solid seen from directly in front. Working: the low, wide cuboid gives a wide rectangle across the bottom, and the taller, narrower cuboid sitting on one end adds a narrower rectangle rising above only that end of the base, so the outline steps up on one side only. Answer: an L-shape. The distractors: a rectangle comes from taking the outline of the box the whole solid would just fit inside, ignoring the step created by the taller block. A T-shape comes from placing the taller block in the middle of the base instead of at one end, so that the base would show on both sides of it. A parallelogram comes from copying a face as it is drawn in the sketch — the top of the taller block is drawn as a sloping parallelogram because the solid is drawn at an angle — instead of drawing the true outline seen looking straight at the front.
- (d) 10.3 m — By Pythagoras' theorem, the hypotenuse = √(5² + 9²) = √(25 + 81) = √106 = 10.29...≈ 10.3 m. "106 m" is the value under the square root sign, correct as far as it goes but with the final square root step left out. "14 m" comes from adding the two shorter sides, 5 + 9, instead of using Pythagoras' theorem at all. "10.2 m" comes from rounding 10.29...m down to 10.2 instead of correctly rounding it up to 10.3.
- (c) 3028 cm² — Split the window into a rectangle and a semicircle. Rectangle area = 40 × 60 = 2400 cm². The semicircle has radius 40 ÷ 2 = 20 cm, so its area = 0.5 × 3.14 × 20² = 628 cm². Total area = 2400 + 628 = 3028 cm². A student who uses a full circle instead of a semicircle on top of the rectangle gets 3.14 × 20² = 1256 cm² for the circle, plus 2400 cm² for the rectangle, totalling 3656 cm². A student who uses the rectangle's full width (40 cm) as the radius instead of halving it gets 0.5 × 3.14 × 40² = 2512 cm² for the semicircle, plus 2400 cm² for the rectangle, totalling 4912 cm².
- (a) No — the angle is not between the two sides — Method: check whether the given angle sits between the two given sides. Working: the 35° angle is marked away from the corner where the 40 cm and 65 cm edges meet, so it is not the included angle — this is SSA, which is not one of the four basic congruence conditions, so it does not guarantee congruence. Options: 'Yes — SAS' wrongly treats any two sides plus any angle as SAS, without checking the angle's position; 'Yes — SSS' wrongly counts the angle as if it were a third side; 'No — only two sides measured' is not the real reason, since SAS itself only needs two sides, so this reasoning is beside the point. Answer: no, the angle is not between the two sides.
- (c) (6, −5) — Method: the translation has already happened, so it must be undone: reverse the vector and apply the reverse to the point that is given. Working: reversing $\binom{-2}{6}$ gives $\binom{2}{-6}$, so the x-coordinate is 4 + 2 = 6 and the y-coordinate is 1 − 6 = −5. Check: from (6, −5) the given vector gives 6 − 2 = 4 and −5 + 6 = 1, which is the point named in the question. Answer: (6, −5). Applying the vector forwards instead of backwards gives (2, 7). Reversing the horizontal movement but not the vertical one gives (6, 7), and reversing the vertical movement but not the horizontal one gives (2, −5).
- (a) A rotation of 180° about the origin — Method: composing two reflections in lines that cross is always a single rotation about the point where the lines meet, through twice the angle between them. Working: the x-axis and y-axis meet at the origin at an angle of 90°, so the combined transformation is a rotation about the origin through 2 × 90 = 180 degrees. Answer: a rotation of 180° about the origin. The rotation angle is TWICE the angle between the mirror lines, not the angle itself, and the centre is always where the two lines cross, not some other point, and the result of two reflections in intersecting lines is a rotation, never another reflection.
- (c) 9.9 cm — Method: the 7 cm side is opposite the 45° angle and the hypotenuse is wanted, so use sin θ = opposite ÷ hypotenuse and rearrange it for the hypotenuse. Working: sin 45° = 7 ÷ h, so h = 7 ÷ sin 45° = 9.899…, which is 9.9 to 1 decimal place. Answer: 9.9 cm. The distractors: 5.0 cm comes from multiplying by sin 45° instead of dividing by it; 14.0 cm comes from doubling the 7 cm side, which is the rule for a side opposite 30° and not one opposite 45°; 7.0 cm comes from reading the two equal sides of a 45° right-angled triangle as including the hypotenuse, when the equal pair is the two shorter sides.
- (a) 2 — Method: recall that the diagonals of a rhombus are always lines of symmetry, whatever its angles are. Working: a rhombus (all sides equal) always has its two diagonals as lines of symmetry, giving 2 lines of symmetry, whether or not the angles are 90°. Options: 0 wrongly assumes a non-square rhombus has no symmetry at all; 4 comes from the number of lines of symmetry a square has, mistaking this rhombus for a square; 1 comes from treating the rhombus like a kite, which has only one diagonal as a line of symmetry. Answer: 2.
- (b) A semicircle of radius 4 m, away from the wall. — Every point the dog can reach is at most 4 m from the fixed ring, so without any wall the region would be a full circle of radius 4 m. The wall runs straight through the ring and blocks the dog from crossing it, and since the wall extends further than the lead in both directions, exactly half of that circle is cut off — leaving a semicircle of radius 4 m on the side of the wall the dog is tied on. (A full circle of radius 4 m ignores that the wall blocks half of the region; a quarter circle of radius 4 m would only be correct if the ring were fixed at a corner where two walls met, not along a single straight wall; a rectangle 4 m wide along the wall ignores that the lead lets the dog swing round in a curve, not stay a fixed distance out from the wall.)
- (b) (7, 3) — Reflecting in the line y = x swaps the x- and y-coordinates: (3, 7) → (7, 3). A pupil who reflects in the x-axis instead gets (3, −7). A pupil who reflects in the y-axis instead gets (−3, 7). A pupil who confuses y = x with y = −x, swapping the coordinates and changing both signs, gets (−7, −3). The correct image is (7, 3).
Build your own mix at the worksheet builder.