Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 124.1° — Method: use the sine rule AB/sin(ACB) = AC/sin(ABC), since AB is opposite angle ACB and AC is opposite angle ABC. Working: sin(ACB) = AB × sin(ABC) / AC = 13 × sin 35° / 9 = 0.8285, which gives angle ACB = 55.9° or its supplement 180 − 55.9 = 124.1°; both of these give a valid triangle, and since angle ACB is obtuse the answer is 124.1°. Reporting the acute solution instead, without checking the word 'obtuse' in the question, gives 55.9°; putting the sides the wrong way round in the ratio, sin(ACB) = 9 × sin 35° / 13, gives 23.4°; and subtracting the acute solution and the given 35° from 180° as if angle ACB were the remaining triangle angle gives 89.1°. A given SSA fact always has two possible angle solutions unless the stem states which one is meant.
- (d) SAS, vertically opposite angle included — AE equals CE and BE equals DE give two pairs of equal sides, and angle AEB equals angle CED because they are vertically opposite angles formed where AC and BD cross; vertically opposite angles are always equal without needing to be measured. This included angle sits between the two known sides in each triangle, giving SAS, so 'SAS, vertically opposite angle included' is correct. 'ASA, vertically opposite angle at E' is wrong because ASA needs two pairs of equal angles with the side between them, but only one angle is known in each triangle here, and the two other known facts are sides, not angles. 'SSS, three equal side pairs' is wrong because only two pairs of sides are given; there is no third pair of equal sides. 'Cannot prove — no angle measured' is wrong because vertically opposite angles are always equal automatically when two straight lines cross, so no separate measurement is needed.
- (d) 10 cm — For a triangle to exist, any two sides must add up to more than the third side. 9 + 10 = 19 > 15, and 15 − 9 = 6 < 10, so 10 cm satisfies the triangle inequality. The other lengths fail: 6 cm gives 9 + 6 = 15, which is not more than 15; 24 cm and 26 cm are each at least as large as 9 + 15 = 24.
- (a) 89.6° — Angle PQR is at vertex Q, so the side opposite it is PR = 13 cm. Using the cosine rule rearranged for an angle: cos(PQR) = (121 + 49 − 169) ÷ (2 × 11 × 7) = 1 ÷ 154 = 0.0065. Taking the inverse cosine, angle PQR = 89.6° (1 d.p.). Using PR as one of the enclosing sides instead of as the opposite side, finding angle P instead of angle Q, gives (121 + 169 − 49) ÷ (2 × 11 × 13) = 241 ÷ 286 = 0.8427, and angle = 32.6°. Swapping the sign inside the bracket, computing 169 − 121 − 49 instead, gives −1 ÷ 154 = −0.0065, and angle = 90.4°. Using PR in the denominator instead of QR gives (121 + 49 − 169) ÷ (2 × 11 × 13) = 1 ÷ 286 = 0.0035, and angle = 89.8°. Keep PR as the opposite side, QR and PQ as the enclosing sides, and angle PQR comes to 89.6°.
- (a) 310° — Method: give the two rotations opposite signs since they turn in opposite senses — clockwise positive, anticlockwise negative — combine them into a single signed turn, then convert that turn into an angle measured clockwise between 0° and 360°. Working: the first rotation is 200° clockwise, so +200. The second is 250° anticlockwise, so −250. Combined: 200 − 250 = −50, meaning the net effect is a 50° turn anticlockwise. Measured clockwise instead, that same turn is 360 − 50 = 310°. Answer: 310°. Give the two rotations opposite signs before combining them, and convert a negative (anticlockwise) result into a clockwise angle by subtracting it from 360°, not from 180°: taking 50° away from a half turn gives 130°, which is a different rotation altogether; adding the two sizes as if both were clockwise gives 450°, which reduces to 90°; and reporting the anticlockwise size without converting it gives 50°.
- (d) 53.2 cm² — Method: diagonal AC splits the kite into two congruent triangles, ABC and ADC, each with area 1/2 × AB × CB × sin(ABC), so the whole kite has area 2 × 1/2 × AB × CB × sin(ABC) = AB × CB × sin(ABC). Working: kite area = 6 × 9 × sin 100° = 53.2 cm². Reporting just one triangle's area, 1/2 × 6 × 9 × sin 100°, and forgetting to double it for the whole kite gives 26.6 cm²; multiplying the two sides together without any sine term at all gives 54.0 cm²; and doubling the triangle area twice, as if the kite were made of four congruent triangles instead of two, gives 106.4 cm². A kite split by its axis of symmetry always gives exactly two congruent triangles.
- (a) 10.4 cm — The scale factor from the smaller triangle to the larger triangle is 8 ÷ 5 = 1.6, so the larger side is 6.5 × 1.6 = 10.4 cm. The distractor 4.0625 cm comes from using the ratio the wrong way round, 6.5 × 5 ÷ 8 = 4.0625. The distractor 9.5 cm comes from adding the difference between the ratio numbers (8 − 5 = 3) to the given length, 6.5 + 3 = 9.5. The distractor 13 cm comes from doubling the given length, treating the scale factor as 2 instead of 1.6.
- (c) 22.3 km — The bearing of E from D is 065°, so the bearing of D from E (the back bearing) is 065° + 180° = 245°. The bearing of F from E is 165°, so the angle at E between ED and EF is 245° − 165° = 80°. Using the cosine rule, DF² = DE² + EF² − 2 × DE × EF × cos(80°) = 14² + 20² − 2 × 14 × 20 × cos(80°) = 196 + 400 − 560 × cos(80°). Since cos(80°) ≈ 0.17365, 560 × cos(80°) ≈ 97.24, so DF² ≈ 596 − 97.24 = 498.76. Taking the square root, DF ≈ 22.333, which rounds to 22.3 km. 26.3 km comes from using 100° as the angle at E — the difference between the two given bearings taken directly (165° − 65°) without converting to the back bearing first. 498.8 km is DF² itself, rounded, with the square root never taken. 23.4 km comes from leaving out the factor of 2 in the cosine rule formula, computing DF² = 196 + 400 − 14 × 20 × cos(80°) ≈ 547.38 instead.
- (b) (−2, −1) — Method: apply the reflection to the point first, then rotate the image about the given centre, in the order the question states them. Working: reflecting (3, 4) in the line y = 1 keeps x = 3 and puts the image as far below the line as the point is above it: 4 is 3 units above y = 1, so the image is 3 units below, at 1 − 3 = −2 (the same as 2 × 1 − 4 = −2). The reflected point is (3, −2). Rotating (3, −2) by 90° clockwise about (1, 1): subtracting the centre gives 3 − 1 = 2 and −2 − 1 = −3, the clockwise rule swaps and negates these to give −3 and −2, and adding the centre back gives 1 + (−3) = −2 and 1 + (−2) = −1. The final image is (−2, −1). Answer: (−2, −1). Reflect before you rotate, exactly as the design process is described, and rotate about the CENTRE (1, 1) given in the question rather than the origin: either mistake, or reversing the two steps, sends the tile to a different point.
- (d) £50 — Area = 1/2 × (3.5 + 6.5) × 4 = 1/2 × 10 × 4 = 20 m². Cost = 20 × £2.50 = £50. (£100 comes from forgetting to halve the trapezium area, giving 40 m² instead of 20 m²; £65 comes from using only the longer parallel side, 6.5 × 4 = 26 m², instead of the trapezium formula; £35 comes from adding all three given lengths, 3.5 + 6.5 + 4, and treating that total as the area in square metres.)
- (a) 33 — Method: total crates = (number of floor positions that actually have crates on them) × (the stack height). Working: there are 4 × 3 = 12 floor positions in the whole arrangement, but one corner position is left empty, leaving 11 filled positions; each filled position is stacked 3 crates high, so 11 × 3 = 33. Answer: 33. The distractors: 36 comes from forgetting to remove the empty corner and using all 12 positions (12 × 3). 35 comes from removing only one crate for the empty corner instead of the full stack of 3 (36 − 1). 11 comes from counting the filled floor positions and stopping there, forgetting that each one carries a stack 3 crates high.
- (b) 21 cm — By Pythagoras' theorem, the other side = √(29² − 20²) = √(841 − 400) = √441 = 21 cm. "9 cm" comes from subtracting the two given lengths directly, 29 − 20 = 9, instead of subtracting their squares. "441 cm" is the value under the square root sign, correct as far as it goes but with the final square root step left out. "35 cm" comes from adding the squares of the two given lengths instead of subtracting them, √(29² + 20²) = √1241 ≈ 35, treating both given lengths as if they were the two shorter sides rather than a shorter side and the hypotenuse.
- (c) They must also be equal — Once two triangles are proved congruent by any condition, including ASA, they are identical in every respect: every pair of corresponding sides and every pair of corresponding angles must be equal, not just the ones originally used to prove the congruence. So the two remaining pairs of corresponding sides must also be equal, making 'they must also be equal' correct. 'They might be equal or not' and 'not enough information to say' both wrongly suggest that congruence only guarantees the specific facts used to prove it, when congruence actually guarantees the triangles are identical overall. 'They must be different' is backwards: the triangles being identical is the entire point of proving congruence, not a reason for a side to differ.
- (b) (1/2)b − (1/2)a — Method: MN runs from M to N, so MN = ON − OM, with OM = (1/2)a and ON = (1/2)b. Working: MN = (1/2)b − (1/2)a. Answer: MN = (1/2)b − (1/2)a. Subtracting the other way round gives (1/2)a − (1/2)b, the reverse vector from N to M; subtracting the wrong way round AND forgetting to halve gives a − b, which is BA, not MN; and adding the two halved vectors instead of subtracting them gives (1/2)a + (1/2)b, which is the position vector of the midpoint of AB. Always subtract the START point's vector from the END point's vector, and halve OA and OB before you combine them, not after.
- (a) A square's diagonals are equal in length — A square has two pairs of parallel sides, four equal sides, and diagonals that are equal in length and cross at right angles. This tile's diagonals are not equal, so it is a rhombus that is not a square.
Build your own mix at the worksheet builder.