Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 9 : 16 — Method: in similar solids the ratio of the surface areas is the square of the ratio of corresponding lengths. Working: the radii are in the ratio 3 : 4, so the surface areas are in the ratio 3² : 4² = 9 : 16. Answer: 9 : 16. The distractors: 27 : 64 is 3³ : 4³, the ratio of the volumes, which cubes the length ratio instead of squaring it; 3 : 4 leaves the length ratio untouched, as though surface area scaled in the same way as a length; 81 : 256 comes from squaring a second time, applying the rule to the ratio 9 : 16 rather than to the radii.
- (b) 8 cm — Area = base × height, so height = area ÷ base = 136 ÷ 17 = 8 cm. (16 cm comes from using the triangle formula, thinking area = 1/2 × base × height and so height = 2 × area ÷ base; 2312 cm comes from multiplying the area by the base instead of dividing; 119 cm comes from subtracting the base from the area instead of dividing the area by the base.)
- (c) An L-shape — Method: to find the front elevation, trace the outline of the solid seen from directly in front. Working: the low, wide cuboid gives a wide rectangle across the bottom, and the taller, narrower cuboid sitting on one end adds a narrower rectangle rising above only that end of the base, so the outline steps up on one side only. Answer: an L-shape. The distractors: a rectangle comes from taking the outline of the box the whole solid would just fit inside, ignoring the step created by the taller block. A T-shape comes from placing the taller block in the middle of the base instead of at one end, so that the base would show on both sides of it. A parallelogram comes from copying a face as it is drawn in the sketch — the top of the taller block is drawn as a sloping parallelogram because the solid is drawn at an angle — instead of drawing the true outline seen looking straight at the front.
- (b) 30 cm — The perpendicular from the centre of a circle to a chord bisects the chord, so this line, half the chord and the radius form a right-angled triangle. Using Pythagoras' theorem, half the chord = √(17² − 8²) = √(289 − 64) = √225 = 15 cm. The full chord AB is twice this length: AB = 2 × 15 = 30 cm. Stopping after finding the half-chord, without doubling it for the whole chord, gives 15 cm. Adding the radius and the perpendicular distance directly, 17 + 8 = 25 cm, ignores that these two lengths are the two shorter sides of a right-angled triangle, not parts of a straight line. Subtracting instead, 17 − 8 = 9 cm, makes the same mistake in the other direction.
- (d) 6 m — The horizontal distance is adjacent to the 60° angle and the zip-wire is the hypotenuse, so horizontal distance = 12 × cos 60° = 12 × 1/2 = 6 m. 6√3 m comes from using sin 60° = √3/2 instead of cos 60°, which would give the vertical drop, not the horizontal distance. 4√3 m comes from treating 12 as the side adjacent to a tangent ratio and dividing by tan 60° = √3. 24 m comes from dividing 12 by cos 60° instead of multiplying by it.
- (a) a line parallel to both, 3 cm from each — Being equidistant from two parallel lines 6 cm apart means being exactly halfway between them all along their length, tracing out a third line, parallel to both, at 3 cm from each — half of the 6 cm gap. "a line parallel to both, 6 cm from each" repeats the full gap instead of halving it, which puts those points past one of the lines entirely. "a circle of radius 3 cm, centred midway" applies to a locus equidistant from a single fixed POINT, not from two parallel lines running the full length. "the perpendicular bisector of the gap" crosses the gap at right angles and meets each line at only one point — it is not the whole locus, which runs parallel to the lines, not across them.
- (c) 5 hours — The distance from the origin to (7, 24) is √(7² + 24²) = √(49 + 576) = √625 = 25 km. Travelling at 5 km per hour, the time taken is 25 ÷ 5 = 5 hours. 25 hours mistakes the distance itself for the time, forgetting to divide by the speed. 125 hours comes from multiplying the distance by the speed, 25 × 5, instead of dividing. 0.2 hours comes from dividing the speed by the distance, 5 ÷ 25, the wrong way round.
- (c) base angles of an isosceles triangle are equal — Because AB = AC, triangle ABC is isosceles, and the base angles of an isosceles triangle — the two angles opposite the equal sides — are always equal, which is why angle C equals angle B, 70°. Angles in a triangle adding up to 180° is a true fact about the triangle as a whole, but it is not the reason two specific angles are equal to each other. Corresponding angles are equal is a fact about parallel lines cut by a transversal, which does not apply inside a single triangle like this. Vertically opposite angles are equal is a fact about two lines crossing, not about a triangle's base angles.
- (b) 124.1° — Method: use the sine rule AB/sin(ACB) = AC/sin(ABC), since AB is opposite angle ACB and AC is opposite angle ABC. Working: sin(ACB) = AB × sin(ABC) / AC = 13 × sin 35° / 9 = 0.8285, which gives angle ACB = 55.9° or its supplement 180 − 55.9 = 124.1°; both of these give a valid triangle, and since angle ACB is obtuse the answer is 124.1°. Reporting the acute solution instead, without checking the word 'obtuse' in the question, gives 55.9°; putting the sides the wrong way round in the ratio, sin(ACB) = 9 × sin 35° / 13, gives 23.4°; and subtracting the acute solution and the given 35° from 180° as if angle ACB were the remaining triangle angle gives 89.1°. A given SSA fact always has two possible angle solutions unless the stem states which one is meant.
- (b) (5, −3) — Method: rotate the point about the given centre first, then translate the image, in the stated order. Working: rotating (0, 2) by 180° about (2, 2) uses the rule (x, y) → (4 − x, 4 − y), since the centre doubles in each coordinate. This gives 4 − 0 = 4 and 4 − 2 = 2, so (0, 2) maps to (4, 2). Translating (4, 2) by the vector (1, −5) gives 4 + 1 = 5 and 2 − 5 = −3, so the final image is (5, −3). Answer: (5, −3). Rotate about the centre GIVEN in the question, (2, 2), not about the origin, and translate the rotated image afterwards, in that order: rotating about the wrong centre, swapping the order, or stopping after one step all give a different point.
- (c) 68° — Since PA and PB are both tangents from the external point P, PA = PB, so triangle PAB is isosceles with equal base angles at A and B. The angles of triangle PAB sum to 180°, so angle PAB + angle PBA = 180° − 44° = 136°, and since the two base angles are equal, angle PAB = 136° ÷ 2 = 68°. Angle PAB is the angle between the tangent at A and the chord AB, so by the alternate segment theorem it equals the angle in the alternate segment, angle ACB = 68°. Using angle APB directly as angle ACB, without using the isosceles triangle to find angle PAB first, gives 44°. Halving angle APB directly, rather than subtracting it from 180° before halving, gives 22°. Finding 180° − 44° = 136° correctly but forgetting to divide by 2 for one base angle leaves 136°.
- (c) 2 — A point 4 cm from A lies on a circle of radius 4 cm centred at A; a point 3 cm from B lies on a circle of radius 3 cm centred at B. Since AB = 5 cm, and 4 + 3 = 7 is greater than 5 while 4 − 3 = 1 is less than 5, the two circles genuinely cross each other, at two separate points, one on each side of line AB. "1" comes from wrongly assuming the circles only touch rather than cross, which would need 4 + 3 to equal exactly 5. "0" comes from wrongly assuming the circles miss each other completely. "4" comes from counting where each circle crosses the line AB itself (two points each) instead of counting where the two circles cross each other.
- (b) 22 — Method: add the two drawn lengths together first, then apply the scale to the total. Working: 3 cm + 2.5 cm = 5.5 cm; 5.5 cm × 4 = 22 m. A student who answers 10 has only converted one of the two sections (2.5 cm × 4) and forgotten the other. A student who answers 5.5 has added the two drawn lengths but forgotten to apply the scale at all. A student who answers 44 has doubled the correct answer, effectively applying the scale twice. Answer: 22 m.
- (b) 320° — A bearing is always measured clockwise from north. An angle measured anticlockwise must be converted by subtracting it from 360°: 360 − 40 = 320°, so the bearing is 320°. Choosing 040° treats the anticlockwise angle as if it were already a clockwise bearing, without converting it. Choosing 220° adds 180° to the angle, mixing this up with a back-bearing calculation (40 + 180 = 220). Choosing 400° adds the angle to 360° instead of subtracting it (40 + 360 = 400), giving a bearing greater than a full turn.
- (b) £33.60 — The area of the parallelogram flower bed is base × height = 3.5 × 2 = 7 m². The cost is 7 × £4.80 = £33.60. £16.80 comes from using the triangle formula instead of the parallelogram formula: 3.5 × 2 = 7, and half of 7 is 3.5 m², then 3.5 × £4.80 = £16.80. £26.40 comes from adding the base and height, 3.5+2 = 5.5, instead of multiplying them, then multiplying by £4.80. £7.00 correctly finds the area, 7 m², but forgets to multiply it by the cost per m².
Build your own mix at the worksheet builder.