Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 2√3/3 — tan 30° = √3/3, so tan 30° + tan 30° = 2 × √3/3 = 2√3/3. √3 comes from wrongly treating tan 30° + tan 30° as tan(30° + 30°) = tan 60° = √3 — adding angles is not the same as adding ratios. √3/3 comes from forgetting to double the value and just writing down tan 30° on its own. 2√3 comes from doubling the numerator of √3/3 but forgetting to keep the denominator of 3.
- (c) 11.2 cm — Method: two angles and a side are given, so use the sine rule, a/sin A = b/sin B = c/sin C, taking care that each side is paired with the angle it faces. Working: BC faces angle BAC = 42°, and AC faces angle ABC = 63°, so AC/sin 63° = 8.4/sin 42°. Multiplying up, AC = 8.4 × sin 63° ÷ sin 42° = 7.4845 ÷ 0.6691 = 11.185. Answer: AC = 11.2 cm to 1 decimal place. The distractors: 6.3 cm comes from writing the ratio upside down, 8.4 × sin 42° ÷ sin 63°, which pairs each side with the angle beside it rather than the angle opposite it; 12.1 cm comes from using the third angle, 180° − 42° − 63° = 75°, in the numerator, which gives the length of AB instead of AC; 12.6 cm comes from assuming the sides are in the same ratio as the angles and working out 8.4 × 63 ÷ 42, which is true for arcs of a circle but never for the sides of a triangle.
- (b) Kite — Method: name a quadrilateral by matching what is given — which sides are equal, whether those equal sides lie next to each other or opposite each other, and whether any sides are parallel — against the definitions of the special quadrilaterals. Working: the two 6 cm sides meet at B and the two 9 cm sides meet at D, so each pair of equal sides is a pair of neighbours rather than a pair of opposites, and the stem rules out any parallel sides. The quadrilateral with two pairs of equal adjacent sides and no parallel sides is a kite. Answer: kite. The distractors: a rhombus is chosen by candidates who see two pairs of equal sides and read that as all four sides being equal, which the two different lengths of 6 cm and 9 cm rule out; a parallelogram is chosen by candidates who remember that a parallelogram has two pairs of equal sides but not that in a parallelogram the equal sides are the opposite ones, and who pass over the statement that nothing is parallel; an isosceles trapezium is chosen by candidates who notice that the shape is symmetrical about the line BD and treat symmetry on its own as the mark of a trapezium, when a trapezium needs a pair of parallel sides.
- (b) 12 cm — Method: in similar shapes every length is multiplied by the same scale factor, and a ratio of 1 : 3 means that factor is 3 going from the smaller shape to the larger one. Working: 4 × 3 = 12. Answer: 12 cm. The distractors: 7 cm comes from adding 3 to the side instead of multiplying by it, which is what happens when a ratio is read as a difference; 36 cm comes from multiplying by 3² = 9, the factor that scales areas, and applying it to a length; 4 cm comes from treating the two shapes as congruent, so that corresponding sides stay equal — similar shapes have equal angles, but their sides are in proportion.
- (c) A line has no endpoints; a segment has two — A line extends without end in both directions, whereas a line segment is the part of a line between two specific fixed endpoints, so 'a line has no endpoints; a segment has two' is correct. 'A line has two endpoints; a segment has none' reverses these two definitions, so it is wrong. 'A line segment is always curved' is wrong because a line segment is straight, not curved, and does not extend infinitely. 'A line segment is a closed shape' is wrong because a line segment is a straight length between two points, not a polygon.
- (b) 113.04 cm² — Sector area is (angle ÷ 360) × π × radius², and radius means the RADIUS, not the diameter: here the diameter is 24 cm, so the radius is 12 cm. The fraction is 90 ÷ 360 = 1/4, and 12² = 144, so the area is 0.25 × 3.14 × 144 = 113.04 cm². Using the diameter itself as if it were the radius gives 0.25 × 3.14 × 576 = 452.16 cm². Using the arc-length formula, 2 × π × radius, instead of the area formula gives 0.25 × 2 × 3.14 × 12 = 18.84 cm². Using the radius instead of its square gives 0.25 × 3.14 × 12 = 9.42 cm².
- (a) 62° — Angle KPQ and angle MQP are co-interior (allied) angles between parallel lines, so they add up to 180°: angle MQP = 180° − 118° = 62°. 118° comes from treating the angles as equal, as if this were a corresponding or alternate angle pair, instead of using the co-interior rule. 90° comes from wrongly assuming the crossing line meets JK and LM at right angles. 59° comes from halving 118° instead of subtracting it from 180°.
- (c) 8 — Method: the exterior angles of a polygon add up to 360°, so divide 360° by the size of one exterior angle. Working: 360 ÷ 45 = 8. Answer: 8 sides. A candidate who divides into a half turn instead of a full turn, working out 180 ÷ 45, gets 4. A candidate who reads off the given exterior angle as if it were the number of sides gets 45. A candidate who subtracts instead of dividing, working out 360 − 45, gets 315.
- (d) 21.2 m — Method: the cable is the hypotenuse of a right-angled triangle whose vertical side is the drop from the roof to the bracket and whose horizontal side is 15 m, so use Pythagoras' theorem. Working: the drop is 20 − 5 = 15 m, so c² = 15² + 15² = 225 + 225 = 450 and c = √450 = 21.213…, which is 21.2 m to 1 decimal place. Answer: 21.2 m. The distractors: 25.0 m comes from using the whole 20 m height of the roof as the vertical side and forgetting that the bracket is already 5 m up; 30.0 m comes from adding the two sides of the triangle, 15 + 15, instead of using Pythagoras' theorem; 15.0 m is the horizontal distance on its own, which would be the length of the cable only if it ran level.
- (b) (−1, −1) — An enlargement by scale factor −1, centre (2, 1), sends a point P to the point on the opposite side of the centre, the same distance away: the image is 2 × centre − P. For the vertex (5, 3), this gives (2 × 2 − 5, 2 × 1 − 3) = (4 − 5, 2 − 3) = (−1, −1). Treating the centre as though it were the origin, and simply negating the point's coordinates, gives (−5, −3) — this ignores that the true centre is (2, 1), not (0, 0). Using scale factor +1 instead of −1 leaves the point exactly where it started, at (5, 3). Adding the point's displacement from the centre instead of subtracting it gives (2 × 2 + 5, 2 × 1 + 3) = (9, 5). Double the centre and subtract the point, and the image is (−1, −1).
- (a) Isosceles trapezium: base angles are equal — WX is parallel to ZY and the two non-parallel sides WZ and XY are equal in length, so WXYZ is an isosceles trapezium. In an isosceles trapezium the two angles at each of the parallel sides are equal, so angle W = angle X (and angle Z = angle Y). A student who answers with the parallelogram property has quoted a fact that is true of a parallelogram, but WZ and XY are given as non-parallel so WXYZ is not a parallelogram — and in a parallelogram "opposite angles" pairs W with Y, not W with X. A student who answers with the kite property has again taken a true fact about the wrong shape: a kite's equal sides are two pairs of adjacent sides, not the two non-parallel sides of a trapezium. A student who answers with the rhombus property has used something no rhombus has — a rhombus has two pairs of parallel sides and only two pairs of equal angles; all four angles are equal only in a square.
- (d) 8.75 cm — The scale factor of the enlargement is 11.2 ÷ 3.2 = 3.5. Applying this to the second line, 2.5 × 3.5 = 8.75 cm. The distractor 10.50 cm comes from adding the difference between the first line's two lengths (11.2 − 3.2 = 8) to the second line's original length, 2.5 + 8 = 10.5. The distractor 0.71 cm comes from using the scale factor the wrong way round, 2.5 × (3.2 ÷ 11.2) = 0.71 (to 2 d.p.). The distractor 8.70 cm comes from directly subtracting 11.2 − 2.5 = 8.7, muddling the two different lines instead of scaling the second one.
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (a) 3 m — Height = sloping length × sin 45° = 3√2 × √2/2 = (3 × 2)/2 = 3 m, since √2 × √2 = 2. 3√2 m comes from forgetting to multiply by sin 45° at all. 3√2/2 m comes from using sin 30° = 1/2 instead of sin 45° = √2/2. 6 m comes from using √2 instead of √2/2 for sin 45°, dropping the denominator of the exact value: 3√2 × √2 = 6.
- (a) £94.58 — Method: find the area with 1/2ab sin C, then multiply by the cost per square metre. Working: area = 1/2 × 1.8 × 1.3 × sin 72° = 1.11274 m², so cost = 1.11274 × £85 = £94.58. Leaving out the 1/2 gives an area of 2.22547 m² and a cost of £189.17; using cos 72° instead of sin 72° gives a cost of £30.73; and rounding the area to 1 decimal place (1.1 m²) before multiplying by the cost per square metre gives £93.50, which loses accuracy that the final answer needs. Even rounding to 1.113 m² is enough to shift the cost to £94.61 — keep the unrounded area in your calculator until the very last step.
Build your own mix at the worksheet builder.