Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 96 cm² — Method: a cube has six identical square faces, so the total surface area is six times the area of one face. Working: one face has area 4 × 4 = 16 cm², and 6 × 16 = 96. Answer: 96 cm². The distractors: 16 cm² is the area of a single face, from stopping before multiplying by the six faces; 64 cm³ comes from working out the volume, 4 × 4 × 4, which is a different measure and carries a different unit; 24 cm² comes from multiplying the six faces by the edge length, 6 × 4, instead of by the area of a face.
- (c) 9 : 16 — Method: in similar solids the ratio of the surface areas is the square of the ratio of corresponding lengths. Working: the radii are in the ratio 3 : 4, so the surface areas are in the ratio 3² : 4² = 9 : 16. Answer: 9 : 16. The distractors: 27 : 64 is 3³ : 4³, the ratio of the volumes, which cubes the length ratio instead of squaring it; 3 : 4 leaves the length ratio untouched, as though surface area scaled in the same way as a length; 81 : 256 comes from squaring a second time, applying the rule to the ratio 9 : 16 rather than to the radii.
- (c) (1/3)b − (1/3)a — Method: PQ runs from P to Q, so PQ = OQ − OP. Working: PQ = (1/3)b − (1/3)a. Answer: PQ = (1/3)b − (1/3)a. Subtracting the other way round gives (1/3)a − (1/3)b, the same vector pointing back from Q to P instead of P to Q; using 2/3 instead of the 1/3 that OP and OQ were actually given as gives (2/3)b − (2/3)a; and using the full vectors a and b with no scaling at all gives b − a, which is AB, not PQ. Always subtract START from END, OQ − OP, and carry the fraction given in the question through to your final vector.
- (b) (3, −3) — Subtracting column vectors means subtracting the top numbers and subtracting the bottom numbers, in the order given: top = 5 − 2 = 3, bottom = 1 − 4 = −3, giving (3, −3). A candidate who works out v − u instead of u − v, reversing the order, gets (−3, 3). A candidate who makes a sign error on the bottom number, treating 1 − 4 as 3 instead of −3, gets (3, 3). A candidate who adds the vectors instead of subtracting gets (7, 5). Because the question asks for u − v, not v − u, the correct answer is (3, −3).
- (c) 80 cm² — Method: a composite shape made of two rectangles that do not overlap has an area equal to the sum of the two rectangle areas, so work out each area and add them. Working: the first rectangle has area 12 × 4 = 48 cm² and the second has area 4 × 8 = 32 cm², so the total is 48 + 32 = 80. Answer: 80 cm². The distractors: 48 cm² comes from working out the larger rectangle only and treating it as the whole shape; 32 cm² comes from working out the smaller rectangle only; 28 cm comes from adding the four given lengths, 12 + 4 + 4 + 8, which is a distance rather than an area and so carries a plain centimetre unit.
- (c) cos 45° — cos 45° = √2/2, and √2 cannot be written as an exact fraction, so this value is irrational. tan 0° = 0, sin 90° = 1 and sin 30° = 1/2 are all rational, since each can be written as an exact whole number or fraction.
- (b) Kite — Method: name a quadrilateral by matching what is given — which sides are equal, whether those equal sides lie next to each other or opposite each other, and whether any sides are parallel — against the definitions of the special quadrilaterals. Working: the two 6 cm sides meet at B and the two 9 cm sides meet at D, so each pair of equal sides is a pair of neighbours rather than a pair of opposites, and the stem rules out any parallel sides. The quadrilateral with two pairs of equal adjacent sides and no parallel sides is a kite. Answer: kite. The distractors: a rhombus is chosen by candidates who see two pairs of equal sides and read that as all four sides being equal, which the two different lengths of 6 cm and 9 cm rule out; a parallelogram is chosen by candidates who remember that a parallelogram has two pairs of equal sides but not that in a parallelogram the equal sides are the opposite ones, and who pass over the statement that nothing is parallel; an isosceles trapezium is chosen by candidates who notice that the shape is symmetrical about the line BD and treat symmetry on its own as the mark of a trapezium, when a trapezium needs a pair of parallel sides.
- (a) Translation by the vector (0, 6) — Method: reflecting twice in two parallel horizontal lines is always equivalent to a single translation, at right angles to the lines, of twice the distance between them. Working: the two lines are 4 − 1 = 3 units apart, so the translation is 2 × 3 = 6 units in the positive y-direction. Answer: translation by the vector (0, 6). Using just the gap itself, without doubling it, gives (0, 3); translating in the negative y-direction, from the second line back towards the first, gives (0, −6); and describing the combination as a single reflection in the line halfway between them, y = 2.5, confuses this combination with the effect of a single reflection — two reflections in parallel lines are always equivalent to a translation, never to another reflection. Always double the gap between the lines, and translate in the direction from the first line towards the second.
- (d) (−2, 6) — Method: add the top numbers of both vectors to the starting x-coordinate, and the bottom numbers of both vectors to the starting y-coordinate. Working: x-coordinate 2 + 3 + (−7) = −2; y-coordinate −1 + 5 + 2 = 6. Answer: (−2, 6). A candidate who only applies vector u and forgets v gets (5, 4). A candidate who only applies vector v and forgets u gets (−5, 1). A candidate who works out the combined vector u + v but forgets to add it to the starting point gets (−4, 7).
- (d) 24 cm²; same way round as T — An enlargement scales area by the square of the scale factor, whatever its sign: area factor = (−2)² = 4, so the image's area is 6 × 4 = 24 cm². A negative scale factor is equivalent to an enlargement by the positive scale factor together with a rotation of 180°, so it does not create a mirror image — it is still a direct transformation, and combining it with a further rotation cannot create one either, since rotations never change a shape's orientation. Using the scale factor itself rather than its square gives area 6 × 2 = 12 cm², which is too small. Believing that a negative scale factor reflects the shape gives 'a mirror image of T' alongside the correct area of 24 cm², and combining both mistakes gives 12 cm² together with 'a mirror image of T'.
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (d) 10 cm — For a triangle to exist, any two sides must add up to more than the third side. 9 + 10 = 19 > 15, and 15 − 9 = 6 < 10, so 10 cm satisfies the triangle inequality. The other lengths fail: 6 cm gives 9 + 6 = 15, which is not more than 15; 24 cm and 26 cm are each at least as large as 9 + 15 = 24.
- (d) 7.21 units — Method: the diagonal AC is the hypotenuse of the right-angled triangle ABC, whose shorter sides are AB and BC, so Pythagoras' theorem gives its length. Working: AB runs from (0, 0) to (6, 0), so AB = 6; BC runs from (6, 0) to (6, 4), so BC = 4. Then AC² = 6² + 4² = 36 + 16 = 52, so AC = √52 = 7.2111…, which is 7.21 correct to 2 decimal places. Answer: 7.21 units. The distractors: 10.00 units comes from adding the two sides, 6 + 4, instead of adding their squares and taking the root; 4.47 units comes from subtracting the squares, √(36 − 16), which is the form of Pythagoras used to find a shorter side rather than the hypotenuse; 26.00 units comes from halving 52 in place of taking its square root.
- (a) 118° — When two straight lines cross, the angles that are vertically opposite each other are always equal. So the angle vertically opposite 118° is also 118°. A candidate who instead finds the angle next to it on the straight line, using 180° − 118° = 62°, has found the adjacent angle, not the vertically opposite one. A candidate who answers 180° has confused the rule with angles on a straight line. A candidate who doubles the angle, giving 236°, has applied no valid angle rule at all. The vertically opposite angle is 118°.
- (a) Triangular prism — Count the given properties against each solid. A triangular prism has 5 faces (2 triangular ends + 3 rectangular sides), 9 edges and 6 vertices — this matches exactly, so the solid is a triangular prism. A square-based pyramid also has 5 faces, but 8 edges and 5 vertices, and only one face is a square rather than three rectangles — the edge and vertex counts don't match. A cuboid has 6 faces, 12 edges and 8 vertices, none of which match the numbers given. A tetrahedron has 4 faces, all triangles, with 6 edges and 4 vertices — too few faces, and no rectangular faces at all.
Build your own mix at the worksheet builder.