Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 82.8° — Method: angle ABC is opposite the given side AC, so rearrange the cosine rule to cos B = (AB² + BC² − AC²) / (2 × AB × BC). Working: cos B = (3.5² + 2.8² − 4.2²) / (2 × 3.5 × 2.8), so angle ABC = 82.8°. Forgetting the negative sign in the rearrangement gives the supplementary angle 97.2°; leaving out the factor of 2 in the denominator gives 75.5°; and using AB and AC (the pair either side of angle A, not angle B) gives 41.4°, which is angle BAC, not angle ABC. Always check which angle sits opposite the side you left out of the pair you are dividing by.
- (b) 21 cm — By Pythagoras' theorem, the other side = √(29² − 20²) = √(841 − 400) = √441 = 21 cm. "9 cm" comes from subtracting the two given lengths directly, 29 − 20 = 9, instead of subtracting their squares. "441 cm" is the value under the square root sign, correct as far as it goes but with the final square root step left out. "35 cm" comes from adding the squares of the two given lengths instead of subtracting them, √(29² + 20²) = √1241 ≈ 35, treating both given lengths as if they were the two shorter sides rather than a shorter side and the hypotenuse.
- (c) 460 g — Each division is 20 g, so three divisions past the mark is 3 × 20 = 60 g. Adding this to the 400 g mark gives 400 + 60 = 460 g. Treating each division as worth 1 g instead of 20 g gives 400 + 3 = 403 g. Working out the extra amount correctly but forgetting to add the 400 g mark gives just 60 g. Treating each division as worth 10 g instead of 20 g gives 400 + 30 = 430 g.
- (d) 240 cm² — Method: the area of a parallelogram is base × perpendicular height, and the perpendicular height is not the sloping side, so it must be found first from the right-angled triangle. Working: the sloping side is the hypotenuse, so the height squared is 13² − 5² = 169 − 25 = 144, giving a height of √144 = 12 cm; then 20 × 12 = 240. Answer: 240 cm². The distractors: 260 cm² comes from using the 13 cm sloping side as the height, 20 × 13, without going through the right-angled triangle at all; 120 cm² comes from finding the height of 12 cm correctly and then halving the product, (20 × 12) ÷ 2, which is the rule for a triangle and not for a parallelogram; 100 cm² comes from using the 5 cm along the base as the height, 20 × 5.
- (b) 32 cm² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the height. Add the parallel sides: 6 + 10 = 16. Multiply by the height: 16 × 4 = 64. Half of 64 is 32 cm². 64 cm² forgets to halve and just gives (6+10)×4. 8 cm² averages the two parallel sides, (6+10)÷2 = 8, but forgets to multiply by the height. 20 cm² treats it as a triangle using only the longer parallel side as the base: half of 10 × 4.
- (d) 53.2 cm² — Method: diagonal AC splits the kite into two congruent triangles, ABC and ADC, each with area 1/2 × AB × CB × sin(ABC), so the whole kite has area 2 × 1/2 × AB × CB × sin(ABC) = AB × CB × sin(ABC). Working: kite area = 6 × 9 × sin 100° = 53.2 cm². Reporting just one triangle's area, 1/2 × 6 × 9 × sin 100°, and forgetting to double it for the whole kite gives 26.6 cm²; multiplying the two sides together without any sine term at all gives 54.0 cm²; and doubling the triangle area twice, as if the kite were made of four congruent triangles instead of two, gives 106.4 cm². A kite split by its axis of symmetry always gives exactly two congruent triangles.
- (a) 225 — Method: find the interior angle of the regular octagon, then subtract it from 360° to find the reflex angle at the same vertex, since the interior angle and the reflex angle together make a full turn. Working: there are 8 − 2 = 6 triangles' worth of angle in the octagon, so the interior angle = 6 × 180 ÷ 8 = 135; reflex angle = 360 − 135 = 225. Answer: 225°. A candidate who stops after finding the interior angle gives 135. A candidate who works out the exterior angle instead, 360 ÷ 8 = 45, gives 45. A candidate who subtracts the exterior angle from 360° instead of the interior angle, working out 360 − 45, gets 315.
- (a) Parallel, since both gradients are 2 — Gradient of line 1 = (5 − 1) ÷ (2 − 0) = 4 ÷ 2 = 2. Gradient of line 2 = (6 − 2) ÷ (5 − 3) = 4 ÷ 2 = 2. The two gradients are equal, so the lines are parallel. "Not parallel, since the gradients are 2 and 4" uses 4 for line 2, which comes from dividing the change in y, 4, by 1 rather than by the change in x, 5 − 3 = 2. "Not parallel, since the two lines cross the y-axis at different points" confuses parallel lines with the same line repeated — parallel lines are distinct lines, and where a line crosses the y-axis has no effect on its gradient. "Parallel, since both lines pass through positive coordinates" reaches the right conclusion for the wrong reason: lines are parallel because their gradients are equal, not because the coordinates given happen to be positive.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (a) Triangular-based pyramid (tetrahedron) — A solid with 4 triangular faces, 4 vertices and 6 edges is a triangular-based pyramid, also called a tetrahedron. A triangular prism also has triangular faces, but it has 2 triangular faces plus 3 rectangular faces, 6 vertices and 9 edges — the extra rectangular faces and edges rule it out here. A square-based pyramid has 5 faces (one square, four triangles), 5 vertices and 8 edges, which does not match. A cube has 6 faces, 8 vertices and 12 edges, all much higher than the numbers given. The solid described is a triangular-based pyramid.
- (b) 63° — Method: a tangent meets the radius drawn to the point of contact at a right angle, so triangle OPT has a 90° angle at T; the three angles of the triangle then sum to 180°. Working: angle OTP = 90°, angle OPT = 27°, so angle POT = 180 − 90 − 27 = 63 degrees. Answer: 63°. The tangent-radius angle is a fixed 90°, not something to assume equal to another angle in the triangle, and the three angles of ANY triangle sum to 180°, never 360°: that total belongs to a quadrilateral, not a triangle.
- (a) 53.5° — Method: use the sine rule BC/sin A = AC/sin B, since BC is opposite angle A and AC is opposite angle B. Working: sin(ABC) = AC × sin(BAC) / BC = 10 × sin 40° / 8, which gives angle ABC = 53.5° or its supplement 180 − 53.5 = 126.5°; since angle ABC is acute, the answer is 53.5°. Taking the obtuse supplement instead gives 126.5°; putting the sides the wrong way round in the ratio (sin B = BC × sin A / AC instead of AC × sin A / BC) gives 30.9°; and using sin 50° in place of sin 40° gives 73.2°. Every sine-rule ratio has two possible angle solutions that add to 180° — the word 'acute' tells you which one to keep.
- (b) £5.00 — Perimeter of the kite = 25 + 25 + 40 + 40 = 130 cm = 1.3 m. The frame is sold only in whole metres, so 2 m must be bought. Cost = 2 × £2.50 = £5.00. A student who buys the exact 1.3 m instead of rounding up to whole metres gets 1.3 × £2.50 = £3.25. A student who never converts the perimeter from centimetres to metres and costs 130 × £2.50 gets £325.00.9 m, which rounds up to 3 whole metres, costing 3 × £2.50 = £7.50.
- (a) −2 — Let the centre be C = (c, 0). The vector from the centre to the image equals the scale factor k times the vector from the centre to the object: (7 − c, −4) = k(1 − c, 2). The y-coordinate gives −4 = 2k, so k = −2 — this doesn't depend on knowing c. (Checking: substituting k = −2 into the x-equation gives c = 3, consistent with a centre on the x-axis.) '2' comes from taking the magnitude of the ratio without noticing the image is on the opposite side of the centre from the object, so the sign should be negative. '−1/2' comes from inverting the scale factor, dividing the object's coordinate by the image's instead of the other way round. '3' is the x-coordinate of the centre, mistaken for the scale factor.
- (b) (12, −9) — Two enlargements one after the other combine into a single scale factor: 1.5 × 2 = 3. Multiplying a vector by a scalar means multiplying both the top number and the bottom number by it: top = 4 × 3 = 12, bottom = −3 × 3 = −9, giving (12, −9). A candidate who adds the scale factor to each number instead of multiplying gets (4 + 3, −3 + 3) = (7, 0). A candidate who multiplies the top number but leaves the bottom number unchanged gets (12, −3). A candidate who multiplies the bottom number but leaves the top number unchanged gets (4, −9). The correct column vector for the poster is (12, −9).
Build your own mix at the worksheet builder.