Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 6 cm — Method: CH cuts the triangle into two smaller right-angled triangles, so Pythagoras' theorem can be written in each of the three right-angled triangles and the results combined. Working: HB = 12 − 3 = 9 cm. In triangle ACH, CH² = AC² − 3² = AC² − 9; in triangle CHB, CH² = CB² − 9² = CB² − 81. Setting those equal gives AC² − 9 = CB² − 81. In triangle ABC, AC² + CB² = 12² = 144, so CB² = 144 − AC². Substituting gives AC² − 9 = 144 − AC² − 81, so 2 × AC² = 72 and AC² = 36, giving AC = 6. Answer: 6 cm. The distractors: 36 cm comes from stopping at AC² = 36 and never taking the square root; 9 cm is HB, the other part of the hypotenuse, written down in place of AC; 4 cm comes from working out 12 ÷ 3, treating AH as a scale factor between the two triangles rather than as a length.
- (a) 3 — Method: find the sail's area with Area = (1/2)ab sin C, then divide by how much one litre covers, and round up to a whole number of tins since paint can only be bought by the tin. Working: Area = 1/2 × 4.2 × 3.6 × sin 115° = 6.85 m² (2 d.p.); 6.85 ÷ 3 = 2.28 tins, which rounds up to 3 tins. Answer: 3. Rounding 2.28 to the nearest whole number instead of rounding up gives 2, which is not enough paint to finish the sail; forgetting the 1/2 in the area formula gives an area of 13.7 m², needing 5 tins; and assuming one litre covers exactly 1 m² of sail, ignoring the coverage rate given, rounds the area itself up to 7 tins. Whenever a quantity can only be bought in whole units, round up even when the decimal part is small — 2.28 tins means you need a third tin.
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (d) £982.20 — Method: find the missing side BC with the cosine rule, add it to AB and AC for the perimeter, then multiply by the cost per metre. Working: BC² = 45² + 38² − 2 × 45 × 38 × cos 110° = 4638.71, so BC = 68.108 m, perimeter = 45 + 38 + 68.108 = 151.108 m, and cost = 151.108 × £6.50 = £982.20 — keep the unrounded perimeter, because the rounded 151.1 m would give £982.15. Forgetting the negative sign in the cosine rule gives BC = 48.0 m and a cost of £851.18; costing only the missing side BC and forgetting to include AB and AC gives £442.70; and stopping after finding the perimeter, without multiplying by the cost per metre, gives £151.11. The perimeter is only the halfway point of this question — the cost still has to be worked out.
- (a) 2.40m — Method: a cost found from a rate is the rate multiplied by the amount bought. Working: the rate is £2.40 per kilogram and the amount is m kilograms, so the cost is 2.40 × m. Answer: 2.40m. A candidate who divides the amount by the rate instead of multiplying writes m/2.40. A candidate who adds the rate to the amount instead of multiplying writes 2.40 + m. A candidate who subtracts the rate from the amount instead of multiplying writes m − 2.40.
- (a) 2√3/3 — tan 30° = √3/3, so tan 30° + tan 30° = 2 × √3/3 = 2√3/3. √3 comes from wrongly treating tan 30° + tan 30° as tan(30° + 30°) = tan 60° = √3 — adding angles is not the same as adding ratios. √3/3 comes from forgetting to double the value and just writing down tan 30° on its own. 2√3 comes from doubling the numerator of √3/3 but forgetting to keep the denominator of 3.
- (a) Triangular prism — Count the given properties against each solid. A triangular prism has 5 faces (2 triangular ends + 3 rectangular sides), 9 edges and 6 vertices — this matches exactly, so the solid is a triangular prism. A square-based pyramid also has 5 faces, but 8 edges and 5 vertices, and only one face is a square rather than three rectangles — the edge and vertex counts don't match. A cuboid has 6 faces, 12 edges and 8 vertices, none of which match the numbers given. A tetrahedron has 4 faces, all triangles, with 6 edges and 4 vertices — too few faces, and no rectangular faces at all.
- (b) 8 : 27 — The heights are in the ratio 6 : 9, which simplifies to 2 : 3. For similar solids, volume scales with the cube of the length ratio, so the volume ratio is 2³ : 3³ = 8 : 27. 2 : 3 is only the simplified length ratio, without cubing. 4 : 9 comes from squaring instead of cubing — that's the rule for areas, not volumes. 27 : 8 has the correct cubed values but in the wrong order, giving the larger cone's volume first instead of the smaller.
- (c) 72° — Method: opposite angles in a cyclic quadrilateral always sum to 180°. Working: angle DAB and angle BCD are opposite angles of the cyclic quadrilateral ABCD, so angle BCD = 180 − 108 = 72 degrees. Answer: 72°. Opposite angles in a cyclic quadrilateral are SUPPLEMENTARY, not equal, so do not simply copy the given angle; and do not subtract from 360°, which is the rule for angles round a point, or confuse this with the angle-in-a-semicircle theorem, which gives a fixed 90° that has nothing to do with this quadrilateral.
- (c) 140° — Method: OAPB is a quadrilateral whose angles sum to 360°; the tangent-radius angles at A and B are each 90°, and angle APB is given, so angle AOB is whatever is left. Working: angle OAP = angle OBP = 90°, so angle AOB = 360 − 90 − 90 − 40 = 140 degrees. Answer: 140°. Both tangent-radius angles are 90° each and must both be subtracted, not just one, and the quadrilateral's angles sum to 360°, not 180°: do not assume angle AOB simply matches angle APB, which is a different angle in a different part of the figure.
- (d) B is the reverse of A — Every component of vector B is the negative of the matching component of vector A (−2 is the negative of 2, and 5 is the negative of −5), so B undoes the translation that A performs — B is the reverse of A. 'B is the same as A' ignores that both signs have flipped. 'B is twice A' confuses a sign change with a scale-factor change; the sizes of the components have not changed, only their signs. 'B is unrelated to A in direction' misses that the two vectors are directly linked, just in opposite directions.
- (b) segment — The region enclosed between a chord and the arc it cuts off is called a segment. A sector is the different region already named in the question, enclosed by the two radii and the arc, not by the chord. A tangent is a straight line that touches the circle at one point, not an enclosed region at all. The circumference is the total distance around the whole circle, a length, not a region.
- (a) 105° — The interior angles of a pentagon add up to (5 − 2) × 180° = 540°. Subtracting the three known angles, 540 − 100 − 110 − 120 = 210°, and this 210° is shared equally between the two angles marked x°, so each one is 210 ÷ 2 = 105°. 210° stops one step early, giving the total of the two unknown angles instead of one of them. 108° is the interior angle of a regular pentagon, which does not apply here since this pentagon's angles are not all equal. 55° comes from halving one of the given angles, 110°, instead of halving the remaining total.
- (c) (−3, 1) — Method: for an enlargement about a centre, first find the vector from the centre to the point, multiply it by the scale factor, INCLUDING its sign, then add the result back onto the centre. Working: the vector from the centre (1, 1) to A(3, 1) is (3 − 1, 1 − 1) = (2, 0). Multiplying by the scale factor −2 gives −2 × 2 = −4 and −2 × 0 = 0, so the scaled vector is (−4, 0). Adding this to the centre gives 1 + (−4) = −3 and 1 + 0 = 1, so the image is (−3, 1). Answer: (−3, 1). A NEGATIVE scale factor keeps its sign all the way through the calculation: do not treat −2 as +2, and do not treat it as a fraction like 1/2, which is the rule for a scale factor between 0 and 1, not a negative one. Always measure the vector from the CENTRE of enlargement, never from the origin, unless the two happen to coincide.
- (b) 104 — Method: angles on a straight line add up to 180°. Working: 180° − 76° = 104°. A student who answers 76 has mistaken this for the vertically opposite angle, which is equal, rather than the adjacent angle on a straight line. A student who answers 90 has wrongly assumed the two paths must be perpendicular. A student who answers 14 has subtracted 76° from 90° instead of from 180°. Answer: 104°.
Build your own mix at the worksheet builder.