Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) £48 — Scale factor = new width ÷ original width = 40 ÷ 10 = 4. Poster height = 15 × 4 = 60 cm. Cost = 60 × £0.80 = £48. (£12 comes from forgetting to scale the height at all, and pricing the original 15 cm height; £15.20 comes from adding the scale factor 4 to the height instead of multiplying by it; £3 comes from dividing the height by the scale factor instead of multiplying by it.)
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (a) 1/3 — Method: since OABC is a parallelogram, B = OA + OC = a + c. M = (1/2)c, since M is the midpoint of OC. Since AN is twice NC, N is 2/3 of the way along AC from A, so N = a + 2/3(c − a) = (1/3)a + (2/3)c. Working: MN = N − M = (1/3)a + (1/6)c, and MB = B − M = a + (1/2)c. Comparing term by term, 1/3 × (a + (1/2)c) = (1/3)a + (1/6)c, which matches MN exactly. Answer: k = 1/3, so M, N and B lie on a straight line. Giving 2/3 instead is the scalar linking N to B (NB = (2/3)MB), not M to N; giving 1/6 is just MN's c-coefficient read off on its own, without comparing it to MB's c-coefficient at all; and giving 3 is the scalar the wrong way up — it is MB that equals 3 × MN, not the other way round, since MN = k × MB was what was asked for. Always match the direction of the scalar to the vectors exactly as the question states them.
- (c) 64.4 cm² — Method: with two sides and the angle between them, use Area = (1/2)ab sin C. Working: Area = 1/2 × 15.6 × 8.9 × sin 112° = 64.4 cm² (1 d.p.). Answer: 64.4 cm². Leaving out the 1/2 gives 128.7 cm²; using cos 112° instead of sin 112° gives a negative value, which a candidate who drops the minus sign reads as 26.0 cm²; and squaring one side instead of multiplying the two different given sides together gives 112.8 cm². Sin C is never negative for an angle between 0° and 180°, so a negative area is always a sign that cos was used by mistake — check you used sin before you trust your answer.
- (d) 6 cm — Volume = πr²h, so height = volume ÷ (πr²) = 471 ÷ (3.14 × 25) = 471 ÷ 78.5 = 6 cm. (30 cm comes from dividing by πr instead of πr², missing one factor of the radius; 150 cm comes from dividing by π only, without using r² at all; 24 cm comes from treating the given 5 cm as a diameter and using a radius of 2.5 cm instead.)
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (d) (6, 3) — For an enlargement centred at the origin, each coordinate is multiplied by the scale factor: (2, 1) → (2 × 3, 1 × 3) = (6, 3). ((5, 4) comes from adding the scale factor to each coordinate instead of multiplying; (6, 1) comes from multiplying only the x-coordinate by 3 and leaving the y-coordinate unchanged; (2, 3) comes from multiplying only the y-coordinate by 3 and leaving the x-coordinate unchanged.)
- (b) 2.8 m — Use Pythagoras' Theorem: the plank is the hypotenuse (3.5 m) of a right-angled triangle formed with the wall and the ground (2.1 m). height² = 3.5² − 2.1² = 12.25 − 4.41 = 7.84. height = √7.84 = 2.8 m. A student who subtracts the two given lengths directly instead of using Pythagoras gets 3.5 − 2.1 = 1.4 m. A student who doubles the distance from the wall by mistake gets 2.1 × 2 = 4.2 m.
- (c) 282.6 cm³ — Volume of a cylinder = πr²h = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6 cm³. (94.2 cm³ comes from using πrh and forgetting to square the radius; 90 cm³ comes from using r²h and leaving π out altogether; 1130.4 cm³ comes from using the diameter, 6 cm, in place of the radius.)
- (c) (1, 0) — To enlarge about a centre other than the origin, find the vector from the centre to the point, scale that vector, then add it back to the centre. The vector from (2, 2) to A(4, 6) is (2, 4). Scaling by −1/2 gives (−1, −2). Adding this to the centre (2, 2) gives the image point (1, 0). (3, 4) comes from using +1/2 instead of −1/2, so the image lands on the same side as A instead of the opposite side. (−2, −3) comes from scaling A's coordinates directly about the origin, ignoring that the centre is (2, 2). (−2, −6) comes from using a scale factor of −2 instead of −1/2.
- (a) (−1, 1) — Translating by $\binom{−2}{3}$ subtracts 2 from every x-coordinate and adds 3 to every y-coordinate. This gives image vertices (−1, 4), (3, 4), (3, 7) and (−1, 7). The point (−1, 1) is not one of these: it has the correct new x-coordinate (1 − 2 = −1) but keeps the original y-coordinate (1) instead of adding 3, as if only the horizontal part of the vector had been applied.
- (c) No — 50° is angle P, not between PQ and QR. — Method: 1/2ab sin C only gives the area when C is the angle between the two named sides. Working: PQ and QR meet at vertex Q, so the angle between them is angle PQR, not angle QPR (which is the angle at vertex P, between sides PQ and PR). Since angle QPR is not included between PQ and QR, the student's calculation 1/2 × 8 × 11 × sin 50° does not give the area of the triangle — the verdict is No. Claiming that any angle works with any two sides ignores that the formula is only true for the INCLUDED angle. Claiming the formula needs all three sides is a different, incorrect statement about the formula itself — Area = 1/2ab sin C is valid with exactly two sides and their included angle, when that angle is actually known.
- (b) 18.84 m² — The pond has radius 2.5 m (half of the 5 m diameter), so the outer edge of the path has radius 2.5 + 1 = 3.5 m. Path area = area of outer circle − area of pond = 3.14 × 3.5² − 3.14 × 2.5² = 38.465 − 19.625 = 18.84 m².
- (c) A rotation of 180° about the origin — An enlargement by scale factor −1 sends every point (x, y) to (−x, −y) — both coordinates change sign. A rotation of 180° about the origin does exactly the same thing to every point, so the two transformations have identical effect. A reflection in the x-axis only changes the sign of the y-coordinate, sending (x, y) to (x, −y), leaving the x-coordinate untouched. A reflection in the y-axis only changes the sign of the x-coordinate, sending (x, y) to (−x, y), leaving the y-coordinate untouched. Treating a negative scale factor as though it behaves like a positive one gives no transformation at all, but the minus sign is not decorative — it reverses both coordinates. Both signs flip together, which is exactly what a 180° rotation about the origin does.
- (b) 4 : 9 — The heights are in the ratio 4 : 6, which simplifies to 2 : 3. For similar solids, area scales with the square of the length ratio, so the surface area ratio is 2² : 3² = 4 : 9. 2 : 3 is just the simplified length ratio, before squaring has been done. 8 : 27 comes from cubing the ratio (2³ : 3³) instead of squaring it — that's the rule for volumes, not areas. 9 : 4 has the correct squared values but in the wrong order, giving the larger tin's area first instead of the smaller.
Build your own mix at the worksheet builder.