Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 320° — A bearing is always measured clockwise from north. An angle measured anticlockwise must be converted by subtracting it from 360°: 360 − 40 = 320°, so the bearing is 320°. Choosing 040° treats the anticlockwise angle as if it were already a clockwise bearing, without converting it. Choosing 220° adds 180° to the angle, mixing this up with a back-bearing calculation (40 + 180 = 220). Choosing 400° adds the angle to 360° instead of subtracting it (40 + 360 = 400), giving a bearing greater than a full turn.
- (d) XP is the shortest distance from X to the line — The perpendicular from a point to a line always gives the shortest possible distance to that line — joining X to any other point on the line forms the hypotenuse of a right-angled triangle with XP as one of the shorter sides, and a hypotenuse is always longer than either of the other two sides. So XP is shorter than the distance to every other point on the line. "XP is the longest distance from X to the line" reverses this relationship. "XP equals every other distance from X to the line" would only be true if X were equidistant from every point on the line, which is impossible for a point and a straight line. "XP cannot be compared without knowing the line's length" is false — the shortest-distance fact holds whatever the line's length, since only the local right angle matters.
- (b) 13.3 cm — The apex is directly above the centre of the square base, so the height, half the base diagonal, and a slant edge form a right-angled triangle with the slant edge as the hypotenuse. Half the base diagonal is 14 ÷ 2 = 7 cm. Using Pythagoras' theorem, height = √(15² − 7²) = √(225 − 49) = √176 = 13.3 cm (1 d.p.). Using the slant edge itself as the height, without applying Pythagoras' theorem at all, gives 15 cm. Using the full base diagonal (14 cm) instead of half of it gives √(15² − 14²) = √(225 − 196) = √29 = 5.4 cm (1 d.p.), far too short for a pyramid this size. Adding the two squares instead of subtracting them, √(15² + 7²) = √(225 + 49) = √274 = 16.6 cm (1 d.p.), gives a length longer than the slant edge itself, which cannot be the height.
- (a) 28.6 m — The perimeter of a sector is the two straight radii plus the curved arc. This sector's 90° angle is one quarter of a full turn, so its arc length is one quarter of the full circle's circumference. The full circumference is 2 × 3.14 × 8 = 50.24 m, and one quarter of that is 50.24 ÷ 4 = 12.56 m. Add the two 8 m radii: 12.56 + 8 + 8 = 28.56 m, which rounds to 28.6 m. Choosing 12.6 m gives the arc length alone (rounded), forgetting the two straight edges of the sector. Choosing 20.6 m adds only one radius to the arc length instead of two, missing one of the two straight sides. Choosing 41.1 m comes from using the diameter, 16 m, as if it were the radius when working out the arc length (2 × 3.14 × 16 = 100.48, one quarter of which is 25.12), then adding the two correct 8 m radii (25.12 + 8 + 8 = 41.12).
- (b) 56.52 cm — Arc length = (216 ÷ 360) × 2 × 3.14 × 15 = 0.6 × 94.2 = 56.52 cm. (28.26 cm comes from leaving out the factor of 2, using πr instead of 2πr; 94.2 cm comes from finding the full circumference and forgetting the angle fraction; 113.04 cm comes from using the diameter, 30 cm, instead of the radius.)
- (d) Similar, by SAS — Method: read off whether the given sides are equal or only in the same ratio, and where the given angle sits. Sides in proportion point to similarity; sides equal in length would be needed for congruence. Working: AB ÷ DE = AC ÷ DF gives two pairs of corresponding sides in the same ratio, and the equal angle at A and D lies between AB and AC in the first triangle and between DE and DF in the second, so it is the included angle. Two pairs of sides in proportion with the included angle equal is the SAS condition for similarity. Answer: similar, by SAS. The distractors: 'Similar, by AA' quotes a condition that needs two pairs of equal angles, while only one pair is given here; 'Congruent, by SAS' reads AB ÷ DE = AC ÷ DF as AB = DE and AC = DF, turning a statement about proportion into one about equal lengths; 'Congruent, by SSS' makes that same misreading and adds an assumption that the third pair of sides is equal too, which nothing in the question says.
- (b) 10 cm — Arc length = (angle ÷ 360) × 2 × π × r, so 15.7 = (90 ÷ 360) × 2 × 3.14 × r = 1.57r, giving r = 15.7 ÷ 1.57 = 10 cm. (2.5 cm comes from forgetting the angle fraction and dividing by 2π alone; 20 cm comes from leaving out the factor of 2 in the arc length formula before dividing; 5 cm comes from dividing the arc length by π alone, ignoring both the angle fraction and the factor of 2.)
- (b) 60 units² — Method: the area of a triangle is half the base times the perpendicular height, so choose a side to act as the base and measure the perpendicular distance from the opposite vertex to it. Working: A(0, 0) and B(10, 0) both lie on the x-axis, so AB is horizontal and AB = 10 − 0 = 10. The perpendicular height is the distance of C from the x-axis, which is its y-coordinate, 12. Area = (10 × 12) ÷ 2 = 120 ÷ 2 = 60. Answer: 60 units². The distractors: 120 units² comes from multiplying base by height and forgetting to halve; 65 units² comes from using the slanting side AC, which is 13 long, as the height in place of the perpendicular distance 12; 30 units² comes from halving the base to 5 before multiplying and then halving the product as well, so the halving is done twice.
- (a) SSS – all three corresponding sides are equal — All three pairs of corresponding sides are stated as equal — LM = XY, MN = YZ and LN = XZ — with no angle mentioned. This matches the SSS condition, so triangle LMN is congruent to triangle XYZ.
- (a) Translation by the vector (0, 6) — Method: reflecting twice in two parallel horizontal lines is always equivalent to a single translation, at right angles to the lines, of twice the distance between them. Working: the two lines are 4 − 1 = 3 units apart, so the translation is 2 × 3 = 6 units in the positive y-direction. Answer: translation by the vector (0, 6). Using just the gap itself, without doubling it, gives (0, 3); translating in the negative y-direction, from the second line back towards the first, gives (0, −6); and describing the combination as a single reflection in the line halfway between them, y = 2.5, confuses this combination with the effect of a single reflection — two reflections in parallel lines are always equivalent to a translation, never to another reflection. Always double the gap between the lines, and translate in the direction from the first line towards the second.
- (c) 22.3 km — The bearing of E from D is 065°, so the bearing of D from E (the back bearing) is 065° + 180° = 245°. The bearing of F from E is 165°, so the angle at E between ED and EF is 245° − 165° = 80°. Using the cosine rule, DF² = DE² + EF² − 2 × DE × EF × cos(80°) = 14² + 20² − 2 × 14 × 20 × cos(80°) = 196 + 400 − 560 × cos(80°). Since cos(80°) ≈ 0.17365, 560 × cos(80°) ≈ 97.24, so DF² ≈ 596 − 97.24 = 498.76. Taking the square root, DF ≈ 22.333, which rounds to 22.3 km. 26.3 km comes from using 100° as the angle at E — the difference between the two given bearings taken directly (165° − 65°) without converting to the back bearing first. 498.8 km is DF² itself, rounded, with the square root never taken. 23.4 km comes from leaving out the factor of 2 in the cosine rule formula, computing DF² = 196 + 400 − 14 × 20 × cos(80°) ≈ 547.38 instead.
- (a) (9, −5) — Method: multiply every part of q by 2, then subtract the matching part from p. Working: 2q = (−4, 6); p − 2q gives top 5 − (−4) = 9 and bottom 1 − 6 = −5. Answer: p − 2q = (9, −5). A candidate who forgets to double q first, working out p − q instead, gets (7, −2). A candidate who doubles p instead of q, working out 2p − q, gets (12, −1). A candidate who adds 2q instead of subtracting it gets (1, 7).
- (b) £2.94 — Method: the price is quoted for each kilogram, so the mass has to be written in kilograms before it is multiplied by the price. Working: 1 kg = 1000 g, so 350 ÷ 1000 = 0.35 and the piece weighs 0.35 kg. The cost is then 8.40 × 0.35 = 2.94. Answer: £2.94. Treating 350 g as 3.5 kg, a division by 100 rather than by 1000, gives 8.40 × 3.5 = 29.40. Multiplying the price by the number of grams gives 8.40 × 350 = 2940. Dividing the price by the mass instead of multiplying gives 8.40 ÷ 0.35 = 24.
- (b) 5 cm by 3 cm — The plan view looks straight down on the cuboid's footprint, so it shows the length (5 cm, left to right) and the depth (3 cm, front to back) — the two dimensions that do not involve height. "5 cm by 2 cm" repeats the front elevation's dimensions, pairing the length with the height instead of the depth. "3 cm by 2 cm" repeats the side elevation's dimensions, again pairing the depth with the height rather than with the length. "5 cm by 5 cm" comes from mistakenly assuming the plan must be a square, pairing the length with itself instead of with the depth.
- (d) B is the reverse of A — Every component of vector B is the negative of the matching component of vector A (−2 is the negative of 2, and 5 is the negative of −5), so B undoes the translation that A performs — B is the reverse of A. 'B is the same as A' ignores that both signs have flipped. 'B is twice A' confuses a sign change with a scale-factor change; the sizes of the components have not changed, only their signs. 'B is unrelated to A in direction' misses that the two vectors are directly linked, just in opposite directions.
Build your own mix at the worksheet builder.