Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 7.7 m — AB is parallel to DC, so those two sides are each parallel to another side. BC and AD are stated to be not parallel to each other, so neither one is parallel to any other side — these are the two sides that need edging. Adding these: 3.2 + 4.5 = 7.7 m, so 7.7 m is correct. 7.6 m comes from an arithmetic slip when adding 3.2 and 4.5. 15.4 m comes from doubling the correct total, mistakenly assuming edging strip is needed along both faces of each side. 4.5 m comes from using only the longer of the two non-parallel sides and forgetting to add the shorter one.
- (b) Rhombus — A rhombus has exactly two lines of symmetry, formed by its two diagonals, and both pairs of opposite angles are equal, but its diagonals are unequal in length. A square also has opposite angles equal, but it has four lines of symmetry and its diagonals ARE equal, so it does not fit. A kite normally has only one line of symmetry and only one pair of opposite angles equal, so it does not fit. A general parallelogram has no lines of symmetry at all, so it does not fit. The correct answer is rhombus.
- (c) 460 g — Each division is 20 g, so three divisions past the mark is 3 × 20 = 60 g. Adding this to the 400 g mark gives 400 + 60 = 460 g. Treating each division as worth 1 g instead of 20 g gives 400 + 3 = 403 g. Working out the extra amount correctly but forgetting to add the 400 g mark gives just 60 g. Treating each division as worth 10 g instead of 20 g gives 400 + 30 = 430 g.
- (c) 9 cm — The scale factor from triangle ABC to triangle PQR is PQ ÷ AB = 12 ÷ 8 = 1.5. So PR = AC × 1.5 = 6 × 1.5 = 9 cm. (4 cm comes from using the scale factor upside down, AB ÷ PQ; 10 cm comes from adding the difference between AB and PQ, 4 cm, to AC instead of scaling; 16 cm comes from multiplying PQ by the ratio AB : AC instead of scaling AC by the correct scale factor.)
- (a) 1260° — The sum of the interior angles of a polygon with n sides is (n − 2) × 180°. For a nonagon, n = 9, so the sum is (9 − 2) × 180° = 7 × 180° = 1260°. 1620° uses 9 × 180° without subtracting 2 from n first. 140° is the size of a single interior angle of a regular nonagon (1260° ÷ 9), not the sum of all nine. 1440° uses (n − 1) × 180° = 8 × 180° instead of (n − 2) × 180°.
- (a) 44.7 m — Method: the line joining the two tops is the hypotenuse of a right-angled triangle whose horizontal side is the gap between the masts and whose vertical side is the difference in their heights, so Pythagoras' theorem applies. Working: the difference in heights is 50 − 30 = 20 m, so d² = 40² + 20² = 1600 + 400 = 2000 and d = √2000 = 44.721…, which is 44.7 m to 1 decimal place. Answer: 44.7 m. The distractors: 34.6 m comes from subtracting the squares, √(40² − 20²), instead of adding them; 60.0 m comes from adding the two sides of the triangle, 40 + 20, rather than using Pythagoras' theorem; 50.0 m is the height of the taller mast, copied from the question in place of the distance asked for.
- (c) 15 — The exterior angle is 180° − 156° = 24°, and the number of sides of a regular polygon is 360° divided by the exterior angle, so 360 ÷ 24 = 15. 24° is the exterior angle itself, stopping one step before the final division. 17 comes from finding 15 correctly and then adding 2, muddling the exterior angle rule with the (n − 2) that appears in the interior angle sum formula. 7.5 comes from dividing 180 by the exterior angle instead of 360, using the angles on a straight line rather than the total of the exterior angles of a polygon.
- (c) Rectangle — A rectangle has two pairs of parallel sides and four right angles, but does not require all sides to be equal — this matches exactly, so Rectangle is correct. A square also has four right angles and parallel sides, but additionally requires all four sides to be equal, which contradicts 'not all the same length', so it is wrong. A rhombus has two pairs of parallel sides and all four sides equal, but its angles are not generally 90° unless it is also a square, so it does not match the right-angle condition here. A kite has no pairs of parallel sides at all, so it does not match the first condition given.
- (d) (2/5)a + (3/5)b — Method: OP = OA + AP, and since AP : PB = 3 : 2 splits AB into 5 equal parts, AP is 3/5 of the whole of AB, with AB = b − a. Working: OP = a + 3/5(b − a) = a − (3/5)a + (3/5)b = (2/5)a + (3/5)b. Answer: OP = (2/5)a + (3/5)b. Using the ratio the wrong way round, as though it read AP : PB = 2 : 3, gives (3/5)a + (2/5)b; adding (3/5)b onto the whole of a without subtracting a inside the bracket first gives a + (3/5)b; and treating the ratio as 1 : 1 gives the midpoint, (1/2)a + (1/2)b. Convert the ratio to a fraction of AB measured from A, matching the ORDER the ratio is stated in, and subtract before you scale.
- (a) 28.6 m — The perimeter of a sector is the two straight radii plus the curved arc. This sector's 90° angle is one quarter of a full turn, so its arc length is one quarter of the full circle's circumference. The full circumference is 2 × 3.14 × 8 = 50.24 m, and one quarter of that is 50.24 ÷ 4 = 12.56 m. Add the two 8 m radii: 12.56 + 8 + 8 = 28.56 m, which rounds to 28.6 m. Choosing 12.6 m gives the arc length alone (rounded), forgetting the two straight edges of the sector. Choosing 20.6 m adds only one radius to the arc length instead of two, missing one of the two straight sides. Choosing 41.1 m comes from using the diameter, 16 m, as if it were the radius when working out the arc length (2 × 3.14 × 16 = 100.48, one quarter of which is 25.12), then adding the two correct 8 m radii (25.12 + 8 + 8 = 41.12).
- (d) No — angles must be equal too — A regular polygon must have both all sides equal and all angles equal. This tile has all six sides equal, but its interior angles are not all equal, so it fails the angle condition and is not regular — 'No — angles must be equal too' is correct. 'Yes — all sides are equal' is wrong because equal sides alone are not enough; a shape can have equal sides but unequal angles, as here. 'Yes — six equal sides means regular' is wrong for the same reason: equal sides do not automatically guarantee equal angles. 'No — hexagons can't be regular' is wrong because regular hexagons certainly exist (six equal sides and six equal 120° angles); it is this particular tile that fails to be regular, not hexagons in general.
- (b) 75.1 cm² — Method: a segment is a sector with its triangle cut away, so find the sector area and the triangle area (using Area = (1/2)r² sin C on the two radii) and subtract. Working: sector area = (130 ÷ 360) × π × 10² = 113.4 cm² (1 d.p.); triangle area = 1/2 × 10 × 10 × sin 130° = 38.3 cm² (1 d.p.); segment area = 113.4 − 38.3 = 75.1 cm². Answer: 75.1 cm². Reporting the sector area on its own, without subtracting the triangle, gives 113.4 cm²; reporting the triangle area on its own gives 38.3 cm²; and using the reflex angle, 360° − 130° = 230°, in the sector but still subtracting the triangle gives 162.4 cm², which is neither segment — the major segment would be the 230° sector PLUS the triangle, 239.0 cm². The minor segment is the smaller piece, cut off by the shorter arc, so use the angle actually given, 130°, and subtract the triangle from that sector.
- (c) 1.5 — The area scale factor is the length scale factor squared, so if n is the length factor, n² = 2.25. Taking the positive square root gives n = 1.5 (check: 1.5² = 2.25). 2.25 is just the area factor restated, with no root taken. 1.125 comes from halving 2.25 instead of taking its square root. 5.0625 comes from squaring 2.25 instead of rooting it.
- (c) 45° — Method: the tower, the ground and the line of sight form a right-angled triangle in which the 25 m height is opposite the angle of elevation and the 25 m along the ground is adjacent to it, so use tan θ = opposite ÷ adjacent. Working: tan θ = 25 ÷ 25 = 1, so θ = tan⁻¹(1). Answer: 45°. The distractors: 90° comes from using sin θ = 25 ÷ 25 = 1, which treats the 25 m along the ground as the hypotenuse when it is the side next to the angle; 1° comes from writing down the value of tan θ as though it were the angle itself; 50° comes from adding the two given lengths, 25 + 25, instead of comparing them.
- (d) 240 cm² — Method: the area of a parallelogram is base × perpendicular height, and the perpendicular height is not the sloping side, so it must be found first from the right-angled triangle. Working: the sloping side is the hypotenuse, so the height squared is 13² − 5² = 169 − 25 = 144, giving a height of √144 = 12 cm; then 20 × 12 = 240. Answer: 240 cm². The distractors: 260 cm² comes from using the 13 cm sloping side as the height, 20 × 13, without going through the right-angled triangle at all; 120 cm² comes from finding the height of 12 cm correctly and then halving the product, (20 × 12) ÷ 2, which is the rule for a triangle and not for a parallelogram; 100 cm² comes from using the 5 cm along the base as the height, 20 × 5.
Build your own mix at the worksheet builder.