Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 320.3 cm³ — Cylinder volume = πr²h = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6 cm³. Cone volume = (1/3)πr²h = (1/3) × 3.14 × 9 × 4 = (1/3) × 113.04 = 37.68 cm³. Total = 282.6 + 37.68 = 320.28 cm³, which rounds to 320.3 cm³.
- (a) 118° — When two straight lines cross, the angles that are vertically opposite each other are always equal. So the angle vertically opposite 118° is also 118°. A candidate who instead finds the angle next to it on the straight line, using 180° − 118° = 62°, has found the adjacent angle, not the vertically opposite one. A candidate who answers 180° has confused the rule with angles on a straight line. A candidate who doubles the angle, giving 236°, has applied no valid angle rule at all. The vertically opposite angle is 118°.
- (c) 152.2 cm² — Method: find the area of one of the 5 isosceles triangles with 1/2ab sin C, then multiply by 5 for the whole pentagon. Working: one triangle has area 1/2 × 8 × 8 × sin 72° = 30.4338 cm², so the pentagon's area = 5 × 30.4338 = 152.2 cm² — keep the unrounded triangle area, since 5 × 30.4 would give 152.0. Reporting the area of a single triangle and forgetting to multiply by 5 gives 30.4 cm²; multiplying by 6 instead of 5, as for a hexagon, gives 182.6 cm²; and leaving out the 1/2 from each triangle before multiplying by 5 gives 304.3 cm². A regular pentagon splits into exactly 5 triangles at its centre, each with a 72° angle, since 360° ÷ 5 = 72°.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (b) £26.25 — First multiply the base and height: 2.4 × 1.75 = 4.2. The area of the triangular sail is half of that: half of 4.2 is 2.1 m². Then multiply by the cost per m²: 2.1 × £12.50 = £26.25. £52.50 forgets to halve in the area formula, giving an area of 4.2 m² and doubling the true cost. £30.00 multiplies the base length by the cost per m² (2.4 × £12.50) without ever finding the area. £25.00 rounds the area to 2 m² before multiplying by the cost, losing accuracy.
- (b) 124.1° — Method: use the sine rule AB/sin(ACB) = AC/sin(ABC), since AB is opposite angle ACB and AC is opposite angle ABC. Working: sin(ACB) = AB × sin(ABC) / AC = 13 × sin 35° / 9 = 0.8285, which gives angle ACB = 55.9° or its supplement 180 − 55.9 = 124.1°; both of these give a valid triangle, and since angle ACB is obtuse the answer is 124.1°. Reporting the acute solution instead, without checking the word 'obtuse' in the question, gives 55.9°; putting the sides the wrong way round in the ratio, sin(ACB) = 9 × sin 35° / 13, gives 23.4°; and subtracting the acute solution and the given 35° from 180° as if angle ACB were the remaining triangle angle gives 89.1°. A given SSA fact always has two possible angle solutions unless the stem states which one is meant.
- (c) 58° — In an isosceles triangle, the base angles opposite the equal sides are equal. Since DE = DF, angle F is the base angle equal to angle E, so angle F = 58°.
- (d) Triangle 2, by 3.6 cm² — Method: find both areas with 1/2ab sin C, then compare them. Working: area of triangle 1 = 1/2 × 10 × 13 × sin 64° = 58.4 cm²; area of triangle 2 = 1/2 × 11 × 12 × sin 70° = 62.0 cm²; triangle 2 is larger, by 62.0 − 58.4 = 3.6 cm². Getting the right difference but naming triangle 1 as the larger one, the subtraction done the wrong way round, gives 'Triangle 1, by 3.6 cm²'; leaving out the 1/2 when finding triangle 1's area (giving 116.8 cm² instead of 58.4 cm²) and then subtracting gives 'Triangle 1, by 54.8 cm²'; and using cos 64° instead of sin 64° for triangle 1 (giving 28.5 cm² instead of 58.4 cm²) gives 'Triangle 2, by 33.5 cm²'. Work out both areas fully and correctly before comparing which is bigger.
- (c) 49.5 m² — Method: the area formula needs two sides and the angle between them, and only sides are given, so find one angle with the cosine rule first and then use the two sides that enclose it. Working: angle ABC lies between AB = 14 m and BC = 9 m, so cos ABC = (14² + 9² − 11²) ÷ (2 × 14 × 9) = (196 + 81 − 121) ÷ 252 = 156 ÷ 252 = 0.61905, giving angle ABC = 51.753° and sin ABC = 0.78535. The area is then 1/2 × 14 × 9 × 0.78535 = 63 × 0.78535 = 49.477. Answer: the area is 49.5 m² to 1 decimal place. The distractors: 60.5 m² comes from using the correct angle at B with the sides 14 m and 11 m, which do not both meet at B, so the angle is no longer the one they enclose; 63.0 m² comes from leaving the sine out and treating the two sides as a base and a perpendicular height; 40.5 m² comes from working out angle BAC = 39.98° instead and using its sine with the sides that meet at B, so that the angle used is not the angle between them.
- (b) £33.60 — The area of the parallelogram flower bed is base × height = 3.5 × 2 = 7 m². The cost is 7 × £4.80 = £33.60. £16.80 comes from using the triangle formula instead of the parallelogram formula: 3.5 × 2 = 7, and half of 7 is 3.5 m², then 3.5 × £4.80 = £16.80. £26.40 comes from adding the base and height, 3.5+2 = 5.5, instead of multiplying them, then multiplying by £4.80. £7.00 correctly finds the area, 7 m², but forgets to multiply it by the cost per m².
- (d) 2 — Method: a point is invariant under a reflection exactly when it lies on the mirror line, so check each vertex's coordinate against the line's equation. Working: the line of reflection is x = 3, so a vertex is invariant only if its x-coordinate equals 3. (3, 1) has x = 3, so it is invariant. (3, 5) has x = 3, so it is also invariant. (6, 1) has x = 6, so it is not invariant, since 6 is not equal to 3. Two of the three vertices are invariant. Answer: 2. Check EVERY vertex against the mirror line's equation rather than assuming a shape either keeps all its vertices fixed or none of them: a vertex is invariant only when it sits exactly on the line, and here two do and one does not.
- (d) SSS, using shared side QS — PQ equals RQ and PS equals RS are two given pairs of equal sides, and QS is common to both triangles, so QS equals itself and gives a third pair of equal sides. Three pairs of equal sides is exactly the SSS condition, so 'SSS, using shared side QS' is correct. 'SAS, using the angle at Q' is wrong because no angle is given anywhere in this question; angle PQS and angle RQS are not stated to be equal, and assuming they are would be assuming the very thing being proved. 'Only two pairs of sides — not enough' is wrong because it forgets that the shared side QS is itself a third pair of equal sides. 'Cannot prove — no angle given' is wrong because SSS is one of the four basic congruence conditions and specifically requires no angle at all.
- (b) 5 cm by 3 cm — The plan view looks straight down on the cuboid's footprint, so it shows the length (5 cm, left to right) and the depth (3 cm, front to back) — the two dimensions that do not involve height. "5 cm by 2 cm" repeats the front elevation's dimensions, pairing the length with the height instead of the depth. "3 cm by 2 cm" repeats the side elevation's dimensions, again pairing the depth with the height rather than with the length. "5 cm by 5 cm" comes from mistakenly assuming the plan must be a square, pairing the length with itself instead of with the depth.
- (c) 9 : 16 — Method: in similar solids the ratio of the surface areas is the square of the ratio of corresponding lengths. Working: the radii are in the ratio 3 : 4, so the surface areas are in the ratio 3² : 4² = 9 : 16. Answer: 9 : 16. The distractors: 27 : 64 is 3³ : 4³, the ratio of the volumes, which cubes the length ratio instead of squaring it; 3 : 4 leaves the length ratio untouched, as though surface area scaled in the same way as a length; 81 : 256 comes from squaring a second time, applying the rule to the ratio 9 : 16 rather than to the radii.
- (c) $\binom{2}{7}$ — First find the character's position after the first move: (−5 + 6, 2 + (−9)) = (1, −7). The second move takes it from (1, −7) to (3, 0), so subtract the current position from the target: (3 − 1, 0 − (−7)) = $\binom{2}{7}$. $\binom{8}{−2}$ works from the starting point (−5, 2) and ignores the first move — (3 − (−5), 0 − 2) = $\binom{8}{−2}$. $\binom{−2}{−7}$ subtracts the wrong way round, current position minus target, instead of target minus current position — (1 − 3, −7 − 0) = $\binom{−2}{−7}$. $\binom{4}{−7}$ adds the target's coordinates to the current position instead of subtracting — (1 + 3, −7 + 0) = $\binom{4}{−7}$.
Build your own mix at the worksheet builder.