Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) It is the longest of the three chords — Method: in any circle the length of a chord is decided by how far the chord lies from the centre, because a chord passing nearer the centre cuts further across the circle. Working: the chord through O lies at a distance of zero from the centre, and no chord can lie closer than that, so no chord of the circle can be longer than it; a chord through the centre is a diameter. The other two chords lie at some distance greater than zero, so each of them falls short of that maximum. Answer: It is the longest of the three chords. The distractors: It is the shortest of the three chords comes from reversing the rule and picturing a chord near the centre as a short line tucked inside; It is the same length as the other two chords comes from carrying the fact that all radii of a circle are equal across to chords, which are not all equal; It is half the length of each of the other two chords comes from confusing a chord through the centre with a radius, which really is half a diameter.
- (b) 5 cm by 3 cm — The plan view looks straight down on the cuboid's footprint, so it shows the length (5 cm, left to right) and the depth (3 cm, front to back) — the two dimensions that do not involve height. "5 cm by 2 cm" repeats the front elevation's dimensions, pairing the length with the height instead of the depth. "3 cm by 2 cm" repeats the side elevation's dimensions, again pairing the depth with the height rather than with the length. "5 cm by 5 cm" comes from mistakenly assuming the plan must be a square, pairing the length with itself instead of with the depth.
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (c) AB means the segment or its length, shown by context — Method: recall the standard convention for a two-letter label such as AB. Working: AB names the segment AND its length; the sentence around it shows which is meant — 'draw AB' means the segment, 'AB = 5 cm' means the length. Options: 'a different symbol is needed' and 'must be written as |AB|' both describe stricter rules than the convention GCSE actually uses; 'AB can only mean the segment' ignores that the same label is also used for the length. Answer: AB means the segment or its length, shown by context.
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (c) 78° — The angles in any quadrilateral add up to 360°. Add the three given angles: 92° + 84° + 106° = 282°. Angle S = 360° − 282° = 78°. A pupil who only adds angle P and angle Q, forgetting angle R, gets 360° − (92° + 84°) = 184°. A pupil who only adds angle Q and angle R, forgetting angle P, gets 360° − (84° + 106°) = 170°. A pupil who makes a carrying slip adding the three angles, getting 292° instead of 282°, gets 360° − 292° = 68°. The correct answer is 78°.
- (a) 8 — A cylinder has two flat circular faces (the top and the base) and one curved surface, so only its 2 flat faces are wrapped. A cuboid has 6 faces and all of them are flat, so all 6 are wrapped. Adding these: 2 + 6 = 8, so 8 is correct. 9 comes from wrongly counting the cylinder's curved surface as a flat face. 6 comes from counting only the cuboid and forgetting the cylinder's two flat circular faces. 3 comes from counting only the cylinder and including its curved surface in that total.
- (b) 12 m — sin 30° = opposite ÷ hypotenuse, where the opposite side is the height (6 m) and the hypotenuse is the string. So string = height ÷ sin 30° = 6 ÷ (1/2) = 12 m. The distractor 3 m comes from multiplying by sin 30° instead of dividing (6 × 1/2 = 3). The distractor 6√3 m comes from using tan 30° = 1/√3 instead of sin 30° (6 ÷ (1/√3) = 6√3). The distractor 4√3 m comes from using cos 30° = √3/2 instead of sin 30° (6 ÷ (√3/2) = 12/√3 = 4√3).
- (b) Cuboid — not necessarily a cube — A solid with 6 faces, 12 edges and 8 vertices in which every face is a rectangle is a cuboid, but nothing here confirms that all the edges are the same length, so the box could be a cube or a non-cube cuboid; the most that can be concluded is that it is a cuboid, making 'Cuboid — not necessarily a cube' correct. 'Cube — only a cube fits this' is wrong because a cube is just one particular cuboid; a general cuboid with different length, width and height has exactly the same face, edge and vertex counts and rectangular faces. 'Triangular prism' is wrong because a triangular prism has 5 faces, 9 edges and 6 vertices, and two of its faces are triangles, so it matches neither the counts nor the face shape. 'Not enough information' is wrong because rectangular faces with these counts do pin the solid down to the cuboid family, even though they cannot pin down a cube specifically.
- (d) (4, −2) — Method: apply the rotation to the point first, then reflect the rotated image, in the order stated. Working: rotating (4, 2) by 90° anticlockwise about the origin sends (x, y) to (−y, x), so (4, 2) becomes (−2, 4). Reflecting (−2, 4) in the line y = x swaps its coordinates, giving (4, −2). Answer: (4, −2). Rotate before you reflect, exactly as the question orders them: these two maps do not commute, so reflecting first, only rotating without swapping the coordinates afterwards, or forgetting to negate the coordinate when rotating anticlockwise all send you to a different point.
- (c) An L-shape — Method: to find the front elevation, trace the outline of the solid seen from directly in front. Working: the low, wide cuboid gives a wide rectangle across the bottom, and the taller, narrower cuboid sitting on one end adds a narrower rectangle rising above only that end of the base, so the outline steps up on one side only. Answer: an L-shape. The distractors: a rectangle comes from taking the outline of the box the whole solid would just fit inside, ignoring the step created by the taller block. A T-shape comes from placing the taller block in the middle of the base instead of at one end, so that the base would show on both sides of it. A parallelogram comes from copying a face as it is drawn in the sketch — the top of the taller block is drawn as a sloping parallelogram because the solid is drawn at an angle — instead of drawing the true outline seen looking straight at the front.
- (c) The scale factor is 2, not 1, so the sides are not equal — Congruent shapes must be exactly the same size as well as the same shape, which means a scale factor of 1. Here the scale factor between the triangles is 2, so the sides are different lengths and the triangles cannot be congruent, even though they are similar. 'Similar triangles are never congruent' is too strong — a scale factor of exactly 1 would make them both similar and congruent. 'The angles are not necessarily equal' is wrong, since similar triangles always have equal matching angles. 'Congruent triangles must have a right angle' is an unrelated, false fact about congruence.
- (a) 310° — Method: give the two rotations opposite signs since they turn in opposite senses — clockwise positive, anticlockwise negative — combine them into a single signed turn, then convert that turn into an angle measured clockwise between 0° and 360°. Working: the first rotation is 200° clockwise, so +200. The second is 250° anticlockwise, so −250. Combined: 200 − 250 = −50, meaning the net effect is a 50° turn anticlockwise. Measured clockwise instead, that same turn is 360 − 50 = 310°. Answer: 310°. Give the two rotations opposite signs before combining them, and convert a negative (anticlockwise) result into a clockwise angle by subtracting it from 360°, not from 180°: taking 50° away from a half turn gives 130°, which is a different rotation altogether; adding the two sizes as if both were clockwise gives 450°, which reduces to 90°; and reporting the anticlockwise size without converting it gives 50°.
- (a) 3 : 5 — Method: for similar figures the ratio of the areas is the square of the ratio of the lengths, so the length ratio is found by taking the square root of each part of the area ratio. Working: the areas are in the ratio 36 : 100, and taking square roots gives √36 : √100 = 6 : 10, which cancels to 3 : 5. Answer: 3 : 5. The distractors: 9 : 25 is 36 : 100 in its simplest form, so it is still the ratio of the areas and the square roots were never taken; 5 : 3 takes the roots correctly but writes the parts the wrong way round, giving DEF to ABC when ABC to DEF was asked for; 25 : 9 makes both mistakes at once, leaving the area ratio and reversing it.
- (d) Opposite angles in a cyclic quadrilateral sum to 180° — ABCD is a cyclic quadrilateral, and angle ABC and angle ADC are a pair of opposite angles in it — they don't sit next to each other around the quadrilateral. The theorem that fixes the sum of a cyclic quadrilateral's opposite angles at 180° is exactly the one needed here. The other three theorems don't apply to this figure at all: the angle-in-a-semicircle theorem gives a 90° angle only when one side is a diameter, and no diameter is mentioned; the angle-at-the-centre theorem needs a centre point and an inscribed angle on the same arc, and no centre is given here; the tangent–radius theorem gives a 90° angle only where a tangent line touches the circle, and there is no tangent in this figure. Only the cyclic-quadrilateral theorem fits what is actually drawn.
Build your own mix at the worksheet builder.