Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) An L-shape — Method: to find the front elevation, trace the outline of the solid seen from directly in front. Working: the low, wide cuboid gives a wide rectangle across the bottom, and the taller, narrower cuboid sitting on one end adds a narrower rectangle rising above only that end of the base, so the outline steps up on one side only. Answer: an L-shape. The distractors: a rectangle comes from taking the outline of the box the whole solid would just fit inside, ignoring the step created by the taller block. A T-shape comes from placing the taller block in the middle of the base instead of at one end, so that the base would show on both sides of it. A parallelogram comes from copying a face as it is drawn in the sketch — the top of the taller block is drawn as a sloping parallelogram because the solid is drawn at an angle — instead of drawing the true outline seen looking straight at the front.
- (c) (1, 0) — To enlarge about a centre other than the origin, find the vector from the centre to the point, scale that vector, then add it back to the centre. The vector from (2, 2) to A(4, 6) is (2, 4). Scaling by −1/2 gives (−1, −2). Adding this to the centre (2, 2) gives the image point (1, 0). (3, 4) comes from using +1/2 instead of −1/2, so the image lands on the same side as A instead of the opposite side. (−2, −3) comes from scaling A's coordinates directly about the origin, ignoring that the centre is (2, 2). (−2, −6) comes from using a scale factor of −2 instead of −1/2.
- (d) 12 cm — Since DE is parallel to BC, triangle ADE is similar to triangle ABC (the two triangles share angle A, and the parallel lines make the angles at D and E equal to the angles at B and C). The whole side AB = AD + DB = 3 + 6 = 9 cm. The scale factor from the small triangle to the large triangle is AB ÷ AD = 9 ÷ 3 = 3, so BC = DE × 3 = 4 × 3 = 12 cm. Scaling by DB ÷ AD instead of AB ÷ AD gives 4 × (6 ÷ 3) = 8 cm. Adding DB directly onto DE, instead of scaling, gives 4 + 6 = 10 cm. Treating the triangles as congruent rather than similar, so assuming corresponding sides are simply equal, gives BC = DE = 4 cm.
- (d) SAS — Method: a congruence condition is named by the parts that are given equal and the order in which they sit round the triangle, so count the sides and the angles first. Working: AB = DE and AC = DF are two pairs of equal sides, and the equal angle at A and D lies between AB and AC, so the given parts read side, included angle, side. Answer: SAS. The distractors: SSS needs three pairs of equal sides, and the third pair, BC and EF, is not given — it follows from the proof rather than being part of it; ASA reads the two equal sides as two equal angles, swapping which facts are which; RHS applies only when the triangles contain a right angle and the equal pair includes the hypotenuse, and nothing here says the angle at A is 90°.
- (c) 78° — The angles in any quadrilateral add up to 360°. Add the three given angles: 92° + 84° + 106° = 282°. Angle S = 360° − 282° = 78°. A pupil who only adds angle P and angle Q, forgetting angle R, gets 360° − (92° + 84°) = 184°. A pupil who only adds angle Q and angle R, forgetting angle P, gets 360° − (84° + 106°) = 170°. A pupil who makes a carrying slip adding the three angles, getting 292° instead of 282°, gets 360° − 292° = 68°. The correct answer is 78°.
- (b) 3 — A cuboid with all different edge lengths has three planes of symmetry: one parallel to each pair of opposite faces, cutting the solid exactly in half. Choosing 9 is the number of planes of symmetry a CUBE has (where all edges are equal) — this cuboid's edges are all different, so it has fewer. Choosing 1 counts only one of the three planes and forgets the other two, each parallel to a different pair of faces. Choosing 6 double-counts each of the three planes, as if counting each one from both sides.
- (c) 5 cm — Volume of a cylinder = πr²h, so r² = V ÷ (πh) = 942 ÷ (3.14 × 12) = 942 ÷ 37.68 = 25, and r = √25 = 5 cm. A pupil who finds r² = 25 but forgets to take the square root gives 25 cm. A pupil who forgets to divide by π, using r² = 942 ÷ 12 = 78.5, gets r = √78.5 ≈ 8.9 cm. A pupil who forgets to divide by the height, using r² = 942 ÷ 3.14 = 300, gets r = √300 ≈ 17.3 cm. The correct radius is 5 cm.
- (d) sin 30°, tan 30°, cos 30° — sin 30° = 1/2 = 0.5, tan 30° = √3/3 ≈ 0.577 and cos 30° = √3/2 ≈ 0.866, so the correct order from smallest to largest is sin 30°, tan 30°, cos 30°. 'sin 30°, cos 30°, tan 30°' swaps the last two, wrongly putting cos 30° before tan 30°. 'cos 30°, tan 30°, sin 30°' is the correct list written backwards, from largest to smallest. 'tan 30°, sin 30°, cos 30°' wrongly swaps sin 30° and tan 30° at the start.
- (d) 4 — Method: a plane of symmetry must pass through the apex and cut the base along one of the base's own lines of symmetry. Working: a square has 4 lines of symmetry (2 through opposite edge midpoints, 2 through opposite corners), and each of these, combined with the apex, gives one plane of symmetry of the pyramid. A student who answers 2 has only found the planes through the edge midpoints, or only the ones through the corners, and missed the other pair. A student who answers 8 has doubled the correct count, perhaps confusing it with a different solid. A student who answers 1 has only spotted the one obvious front-to-back plane. Answer: 4.
- (c) 152.2 cm² — Method: find the area of one of the 5 isosceles triangles with 1/2ab sin C, then multiply by 5 for the whole pentagon. Working: one triangle has area 1/2 × 8 × 8 × sin 72° = 30.4338 cm², so the pentagon's area = 5 × 30.4338 = 152.2 cm² — keep the unrounded triangle area, since 5 × 30.4 would give 152.0. Reporting the area of a single triangle and forgetting to multiply by 5 gives 30.4 cm²; multiplying by 6 instead of 5, as for a hexagon, gives 182.6 cm²; and leaving out the 1/2 from each triangle before multiplying by 5 gives 304.3 cm². A regular pentagon splits into exactly 5 triangles at its centre, each with a 72° angle, since 360° ÷ 5 = 72°.
- (d) Opposite angles in a cyclic quadrilateral sum to 180° — ABCD is a cyclic quadrilateral, and angle ABC and angle ADC are a pair of opposite angles in it — they don't sit next to each other around the quadrilateral. The theorem that fixes the sum of a cyclic quadrilateral's opposite angles at 180° is exactly the one needed here. The other three theorems don't apply to this figure at all: the angle-in-a-semicircle theorem gives a 90° angle only when one side is a diameter, and no diameter is mentioned; the angle-at-the-centre theorem needs a centre point and an inscribed angle on the same arc, and no centre is given here; the tangent–radius theorem gives a 90° angle only where a tangent line touches the circle, and there is no tangent in this figure. Only the cyclic-quadrilateral theorem fits what is actually drawn.
- (b) 58° — Method: the angle at the centre is TWICE the angle at the circumference when both stand on the same arc. Working: angle AOC is the angle at the centre standing on arc AC, and angle ABC is the angle at the circumference standing on the same arc AC, with B on the major arc, so angle AOC = 2 × angle ABC. Rearranging, angle ABC = 116 ÷ 2 = 58 degrees. Answer: 58°. Halve the centre angle, do not double it, and use the angle AOC exactly as given, 116°: you do not need its reflex angle here, because B sits on the major arc, which is precisely the arrangement the theorem is stated for.
- (a) Reflect in the x-axis, then translate by (0, 7). — Reflecting in the x-axis sends (x, y) to (x, −y); applied to S's vertices (2, 2), (5, 2) and (2, 5) this gives (2, −2), (5, −2) and (2, −5). Translating this image by the vector (0, 7) adds 7 to every y-coordinate, giving (2, 5), (5, 5) and (2, 2), which matches S′ exactly. Using the correct reflection but translating by (7, 0) instead moves the image sideways rather than upwards, giving (9, −2), (12, −2) and (9, −5) — nowhere near S′. Reflecting in the y-axis instead of the x-axis changes the sign of the x-coordinate rather than the y-coordinate, so translating that image by (0, 7) gives (−2, 9), (−5, 9) and (−2, 12), the wrong shape entirely. Rotating 180° about the origin instead of reflecting sends every coordinate to its negative, so translating by (0, 7) gives (−2, 5), (−5, 5) and (−2, 2) — the y-coordinates match S′ but the x-coordinates do not.
- (b) No — the angle given is not the included angle — Method: check whether the given angle sits between the two given sides, since SAS requires the included angle. Working: sides AB and BC meet at vertex B, so the angle between them is angle B — but the angle given is angle A, which is not between the two given sides, and the same mismatch happens in triangle DEF. Options: 'two sides and one angle match' restates SAS's ingredients without checking their positions, which is exactly Meera's mistake; 'SSS needs three equal sides' is a true fact about a different condition, but it is not the reason Meera is wrong here; 'SAS allows any equal angle' states a rule that is not how SAS works, since the angle must be the included one. Answer: no, the angle given is not the included angle.
- (d) 82.8° — Method: angle ABC is opposite the given side AC, so rearrange the cosine rule to cos B = (AB² + BC² − AC²) / (2 × AB × BC). Working: cos B = (3.5² + 2.8² − 4.2²) / (2 × 3.5 × 2.8), so angle ABC = 82.8°. Forgetting the negative sign in the rearrangement gives the supplementary angle 97.2°; leaving out the factor of 2 in the denominator gives 75.5°; and using AB and AC (the pair either side of angle A, not angle B) gives 41.4°, which is angle BAC, not angle ABC. Always check which angle sits opposite the side you left out of the pair you are dividing by.
Build your own mix at the worksheet builder.