Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 13 — Area of the trapezium = 1/2 × (8 + 12) × 5 = 1/2 × 100 = 50 m². Number of bags = 50 ÷ 4 = 12.5, which rounds up to 13 bags since seed is sold only in whole bags. A student who mistakenly uses 2 m² of coverage per bag instead of 4 m² finds 50 ÷ 2 = 25 bags.
- (b) 62° — Because AT is a diameter, the radius OT lies along AT, and the tangent PT meets every radius at 90°, by the tangent–radius theorem. So PT meets AT at T at a right angle: angle ATP = 90°. The angles of triangle APT sum to 180°, so angle APT = 180° − 90° − 28° = 62°. Copying the given angle PAT straight across, as though the triangle were isosceles, gives 28°. Adding the two known angles instead of subtracting them from 180° gives 90° + 28° = 118°. Naming the right angle itself, angle ATP, instead of the angle that was actually asked for gives 90°. Subtract both known angles from 180°, and 62° is angle APT.
- (d) 15 cm — Arc length = (angle ÷ 360) × 2 × π × r. Here 120 ÷ 360 = 1/3, and 2 × 3.14 = 6.28, so 31.4 = (1/3) × 6.28 × r. Multiplying both sides by 3 gives 6.28 × r = 94.2, so r = 94.2 ÷ 6.28 = 15 cm. (5 cm comes from forgetting the angle fraction altogether and dividing the arc length by 2 × π alone: 31.4 ÷ 6.28 = 5; 30 cm comes from leaving out the factor of 2, dividing by (1/3) × 3.14 = 1.0467 instead of (1/3) × 6.28: 31.4 ÷ 1.0467 = 30; 7.5 cm comes from correctly finding a radius of 15 cm but then treating that 15 cm as a diameter and halving it.)
- (b) £709 — Method: first find the area of the triangular platform with Area = (1/2)ab sin C, then multiply by the cost per square metre. Working: Area = 1/2 × 11.5 × 8.2 × sin 72° = 44.8 m² (1 d.p.); cost = area × £15.80, which rounds to £709 to the nearest pound. Answer: £709. Leaving out the 1/2 in the area formula doubles the area, giving a cost of £1417; using cos 72° instead of sin 72° gives a much smaller area and a cost of £230; and squaring the 11.5 m side instead of multiplying the two different given sides together gives a cost of £994. Find the exact area first — don't round it early — then multiply by the cost per square metre and round only the final answer.
- (b) (1, 6) — Method: when a square is set square-on to the grid, so that its sides run parallel to the axes, each vertex shares its x-coordinate with one neighbour and its y-coordinate with the other, and the missing vertex then borrows one coordinate from each of the two vertices it is joined to; so the first job is to check from the given points that the sides really do run parallel to the axes. Working: A(1, 2) and B(5, 2) share y = 2, so AB is a horizontal side; B(5, 2) and C(5, 6) share x = 5, so BC is a vertical side, which confirms that this square lies square-on to the axes and that the rule may be used. In square ABCD the vertex D is joined to C and to A. DC must be horizontal like AB, so D takes the y-coordinate of C, which is 6; DA must be vertical like CB, so D takes the x-coordinate of A, which is 1. D is therefore (1, 6), and checking confirms every side is 4 long. Answer: (1, 6). The distractors: (1, 5) comes from lifting the first number out of each of A and C, pairing the x-coordinate of A with the x-coordinate of C; (6, 1) comes from finding the right two numbers but writing them the wrong way round, height before sideways position; (9, 6) comes from stepping a further 4 to the right from C instead of closing the square back to the column A stands in.
- (a) (4, −4) — A point is invariant under a reflection only if it lies exactly on the mirror line. The line y = −x consists of every point where the y-coordinate is the negative of the x-coordinate: (4, −4) satisfies this, since −4 = −(4), so it is invariant. (5, 5) lies on the line y = x, a different line altogether, not y = −x. (4, 4) has equal coordinates, but that alone does not put it on y = −x; it would need y = −4, not 4. (−4, −4) also has equal coordinates and lies on y = x, not y = −x — its coordinates would need opposite signs to sit on the given mirror line. Only a point whose coordinates are negatives of each other stays fixed under this reflection.
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (c) 14 units — Method: the perimeter of a rectangle is the distance all the way round its outside, 2 × (length + width), so the two side lengths must be found first; on a coordinate grid a side's length is the difference between the coordinates that change along it. Working: along AB, from (1, 1) to (4, 1), only x changes, so AB = 4 − 1 = 3. Along BC, from (4, 1) to (4, 5), only y changes, so BC = 5 − 1 = 4. Perimeter = 2 × (3 + 4) = 2 × 7 = 14. Answer: 14 units. The distractors: 18 units comes from reading the vertex numbers 4 and 5 as the side lengths instead of subtracting, giving 2 × (4 + 5); 12 units comes from working out the area, 3 × 4, in place of the perimeter; 7 units comes from adding one length to one width and stopping there, without doubling for the opposite pair of sides.
- (b) (−1, −2) — To translate R(−6, 9) by $\binom{5}{−11}$, add 5 to the x-coordinate and −11 to the y-coordinate: (−6 + 5, 9 + (−11)) = (−1, −2). (−1, 9) applies only the x-component and leaves the y-coordinate unchanged. (−6, −2) applies only the y-component and leaves the x-coordinate unchanged. (−11, 20) comes from subtracting the vector instead of adding it.
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
- (b) It is the longest of the three chords — Method: in any circle the length of a chord is decided by how far the chord lies from the centre, because a chord passing nearer the centre cuts further across the circle. Working: the chord through O lies at a distance of zero from the centre, and no chord can lie closer than that, so no chord of the circle can be longer than it; a chord through the centre is a diameter. The other two chords lie at some distance greater than zero, so each of them falls short of that maximum. Answer: It is the longest of the three chords. The distractors: It is the shortest of the three chords comes from reversing the rule and picturing a chord near the centre as a short line tucked inside; It is the same length as the other two chords comes from carrying the fact that all radii of a circle are equal across to chords, which are not all equal; It is half the length of each of the other two chords comes from confusing a chord through the centre with a radius, which really is half a diameter.
- (a) 615.44 cm² — Method: the surface area of a sphere is 4πr². Square the radius, multiply by π, then multiply by 4. Working: r² = 7² = 49, then 3.14 × 49 = 153.86, then 4 × 153.86 = 615.44. Answer: 615.44 cm². The distractors: 153.86 cm² comes from stopping at πr², which is the area of a flat circle of radius 7 cm and leaves out the factor of 4 that a curved surface needs; 87.92 cm² comes from 4 × 3.14 × 7, using the radius itself where the formula asks for its square; 1436.03 cm³ comes from working out the volume of the ball with (4 ÷ 3) × π × r³ instead of its surface area, which is a different measure and carries a cubic unit.
- (c) Translation by the vector (8, 0) — Method: reflecting twice in two parallel vertical lines is always equivalent to a single translation, at right angles to the lines, of twice the distance between them. Working: the two lines are 5 − 1 = 4 units apart, so the translation is 2 × 4 = 8 units in the positive x-direction. Answer: translation by the vector (8, 0). Using just the gap itself, without doubling it, gives (4, 0); translating in the negative x-direction, from the second line back towards the first, gives (−8, 0); and describing the combination as a single reflection in the line halfway between them, x = 3, confuses this combination with the effect of a single reflection — two reflections in parallel lines are always equivalent to a translation, never to another reflection. Always double the gap between the lines, and translate in the direction from the first line towards the second.
- (a) the lens-shaped region where the two circles overlap — The region within 30 km of the ship is a circle of radius 30 km around the ship; the region within 20 km of the lighthouse is a circle of radius 20 km around the lighthouse. Since 30 + 20 = 50 km is more than the 40 km between them, and 30 − 20 = 10 km is less than 40 km, the two circles genuinely overlap, in a lens-shaped region where both conditions hold at once. "the whole smaller circle, since it fits inside the larger one" would only be true if the 40 km distance between the centres were small enough for one circle to swallow the other, which it is not here. "no overlap — 30 km and 20 km don't add to 40 km" wrongly assumes the two radii must add up to exactly the distance between the centres for an overlap to exist; any total greater than that distance is enough. "a straight strip, exactly halfway between the two" confuses this with an equidistant locus, which is a different problem from the one asked here.
- (a) 180 cm³ — Method: the volume of a right prism is the area of its cross-section multiplied by its length, and the area of a triangle is half the base multiplied by the perpendicular height. Working: the cross-section has area (6 × 5) ÷ 2 = 15 cm², and 15 × 12 = 180. Answer: 180 cm³. The distractors: 360 cm³ comes from taking the cross-section as 6 × 5 = 30 and never halving it, which measures the rectangle around the triangular face rather than the face itself; 66 cm³ comes from adding the base and the perpendicular height and halving, (6 + 5) ÷ 2 = 5.5, which is the trapezium rule used where the triangle rule is needed, and then multiplying by the 12 cm length; 15 cm³ comes from working out the triangular cross-section correctly and stopping there, so the 12 cm length is never used and an area is handed in as a volume.
Build your own mix at the worksheet builder.