Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 4 m — The sloping slide is the hypotenuse of a right-angled triangle with the other two sides 2.4 m and 3.2 m. By Pythagoras' Theorem, hypotenuse² = 2.4² + 3.2² = 5.76 + 10.24 = 16. Square root: √16 = 4 m. Adding the two sides instead of squaring them gives 2.4 + 3.2 = 5.6 m. Truncating each squared side to a whole number before adding (5.76 to 5 and 10.24 to 10) gives √15 ≈ 3.87 m. Forgetting to take the square root and leaving the sum of the squares as the answer gives 5.76 + 10.24 = 16, written as 16 m.
- (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.
- (b) (−2, −1) — Method: apply the reflection to the point first, then rotate the image about the given centre, in the order the question states them. Working: reflecting (3, 4) in the line y = 1 keeps x = 3 and puts the image as far below the line as the point is above it: 4 is 3 units above y = 1, so the image is 3 units below, at 1 − 3 = −2 (the same as 2 × 1 − 4 = −2). The reflected point is (3, −2). Rotating (3, −2) by 90° clockwise about (1, 1): subtracting the centre gives 3 − 1 = 2 and −2 − 1 = −3, the clockwise rule swaps and negates these to give −3 and −2, and adding the centre back gives 1 + (−3) = −2 and 1 + (−2) = −1. The final image is (−2, −1). Answer: (−2, −1). Reflect before you rotate, exactly as the design process is described, and rotate about the CENTRE (1, 1) given in the question rather than the origin: either mistake, or reversing the two steps, sends the tile to a different point.
- (d) Two angles and a side: sine rule finds other sides. — Method: match the data you are given to the rule that needs it. Working: the sine rule a/sin A = b/sin B = c/sin C needs a complete angle-side pair to set up its ratio, so the statement that two angles and a side (AAS or ASA) let the sine rule find the other sides is the correct one — the third angle comes from the angle sum, and each unknown side is then opposite a known angle. The statement that two sides and the angle between them (SAS) call for the sine rule is wrong: no angle-side pair is complete, so the cosine rule is what works there. The statement that the sine rule finds any angle from three sides (SSS) is wrong for the same reason in reverse — no angle is known at all, so the cosine rule must find the first one. The statement that the cosine rule finds a missing angle directly from two sides and a non-included angle (SSA) is wrong: the cosine rule reports the angle enclosed by the two sides it uses, so with SSA it is the sine rule that reaches the missing angle, and the ambiguous case is then settled from the wording of the question.
- (d) 36.9° — sin θ = opposite/hypotenuse = 6/10 = 0.6, so θ = sin⁻¹(0.6) = 36.86...° ≈ 36.9°. "53.1°" finds the OTHER acute angle in the triangle, 90° − 36.9°, instead of θ itself, as if the two acute angles had been swapped. "31.0°" comes from using the tangent ratio instead of sine, working out tan⁻¹(6/10) = 31.0° with the wrong ratio for the two sides given. "36.8°" rounds sin⁻¹(0.6) = 36.86...° down to 36.8° instead of correctly rounding it up to 36.9°.
- (c) Equal sides and equal interior angles — Method: recall the full definition of 'regular' as applied to a polygon. Working: a regular polygon must have both equal side lengths and equal interior angles at the same time. Options: 'all sides equal' alone describes an equilateral but not necessarily equiangular shape, such as a rhombus, which is not regular; 'all angles equal' alone describes an equiangular but not necessarily equilateral shape, such as a rectangle, which is not regular; 'at least one line of symmetry' is a much weaker condition that many irregular shapes also satisfy. Answer: equal sides and equal interior angles.
- (b) 104 — Method: angles on a straight line add up to 180°. Working: 180° − 76° = 104°. A student who answers 76 has mistaken this for the vertically opposite angle, which is equal, rather than the adjacent angle on a straight line. A student who answers 90 has wrongly assumed the two paths must be perpendicular. A student who answers 14 has subtracted 76° from 90° instead of from 180°. Answer: 104°.
- (d) (6, 2) — Applying the first vector: (2, 1) + (5, −3) = (7, −2), which is the warehouse. Applying the second vector: (7, −2) + (−1, 4) = (6, 2), the delivery address. '(7, −2)' stops at the warehouse and forgets the second flight. '(8, −6)' comes from adding (1, −4) instead of (−1, 4) for the second vector, getting both signs wrong. '(11, −3)' comes from swapping the components of the second vector to (4, −1) before adding.
- (a) 32 m — The scale factor from the larger pond to the smaller pond is 4 ÷ 11, so the smaller perimeter is 88 × 4 ÷ 11 = 32 m. The distractor 242 m comes from using the ratio the wrong way round, 88 × 11 ÷ 4 = 242. The distractor 84 m comes from subtracting the smaller ratio number, 88 − 4 = 84, instead of scaling. The distractor 121 m comes from multiplying 11 × 11 = 121, ignoring the given perimeter altogether.
- (c) (1/3)b − (1/3)a — Method: PQ runs from P to Q, so PQ = OQ − OP. Working: PQ = (1/3)b − (1/3)a. Answer: PQ = (1/3)b − (1/3)a. Subtracting the other way round gives (1/3)a − (1/3)b, the same vector pointing back from Q to P instead of P to Q; using 2/3 instead of the 1/3 that OP and OQ were actually given as gives (2/3)b − (2/3)a; and using the full vectors a and b with no scaling at all gives b − a, which is AB, not PQ. Always subtract START from END, OQ − OP, and carry the fraction given in the question through to your final vector.
- (c) No — 50° is angle P, not between PQ and QR. — Method: 1/2ab sin C only gives the area when C is the angle between the two named sides. Working: PQ and QR meet at vertex Q, so the angle between them is angle PQR, not angle QPR (which is the angle at vertex P, between sides PQ and PR). Since angle QPR is not included between PQ and QR, the student's calculation 1/2 × 8 × 11 × sin 50° does not give the area of the triangle — the verdict is No. Claiming that any angle works with any two sides ignores that the formula is only true for the INCLUDED angle. Claiming the formula needs all three sides is a different, incorrect statement about the formula itself — Area = 1/2ab sin C is valid with exactly two sides and their included angle, when that angle is actually known.
- (b) £709 — Method: first find the area of the triangular platform with Area = (1/2)ab sin C, then multiply by the cost per square metre. Working: Area = 1/2 × 11.5 × 8.2 × sin 72° = 44.8 m² (1 d.p.); cost = area × £15.80, which rounds to £709 to the nearest pound. Answer: £709. Leaving out the 1/2 in the area formula doubles the area, giving a cost of £1417; using cos 72° instead of sin 72° gives a much smaller area and a cost of £230; and squaring the 11.5 m side instead of multiplying the two different given sides together gives a cost of £994. Find the exact area first — don't round it early — then multiply by the cost per square metre and round only the final answer.
- (c) The scale factor is 2, not 1, so the sides are not equal — Congruent shapes must be exactly the same size as well as the same shape, which means a scale factor of 1. Here the scale factor between the triangles is 2, so the sides are different lengths and the triangles cannot be congruent, even though they are similar. 'Similar triangles are never congruent' is too strong — a scale factor of exactly 1 would make them both similar and congruent. 'The angles are not necessarily equal' is wrong, since similar triangles always have equal matching angles. 'Congruent triangles must have a right angle' is an unrelated, false fact about congruence.
- (b) (−1, −2) — To translate R(−6, 9) by $\binom{5}{−11}$, add 5 to the x-coordinate and −11 to the y-coordinate: (−6 + 5, 9 + (−11)) = (−1, −2). (−1, 9) applies only the x-component and leaves the y-coordinate unchanged. (−6, −2) applies only the y-component and leaves the x-coordinate unchanged. (−11, 20) comes from subtracting the vector instead of adding it.
- (a) 3 times the size, opposite side, rotated 180° — Method: for any enlargement, the MAGNITUDE of the scale factor gives the size ratio between image and object, while the SIGN decides which side of the centre the image falls on; a negative scale factor puts the image on the opposite side, which is equivalent to a 180° rotation about the centre. Working: the scale factor is −3, so the size ratio is the magnitude, which is 3, and the negative sign puts the image on the opposite side of the centre, rotated 180° relative to the original. Answer: 3 times the size, opposite side, rotated 180°. The magnitude of the scale factor controls the SIZE only: do not let the sign leak into it and turn 3 into 1/3. The sign controls the SIDE and orientation, which a positive-only view of enlargement, just 'further away' with the same orientation, misses entirely.
Build your own mix at the worksheet builder.