Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (b) 320.3 cm³ — Cylinder volume = πr²h = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6 cm³. Cone volume = (1/3)πr²h = (1/3) × 3.14 × 9 × 4 = (1/3) × 113.04 = 37.68 cm³. Total = 282.6 + 37.68 = 320.28 cm³, which rounds to 320.3 cm³.
- (d) 4 — Method: a plane of symmetry must pass through the apex and cut the base along one of the base's own lines of symmetry. Working: a square has 4 lines of symmetry (2 through opposite edge midpoints, 2 through opposite corners), and each of these, combined with the apex, gives one plane of symmetry of the pyramid. A student who answers 2 has only found the planes through the edge midpoints, or only the ones through the corners, and missed the other pair. A student who answers 8 has doubled the correct count, perhaps confusing it with a different solid. A student who answers 1 has only spotted the one obvious front-to-back plane. Answer: 4.
- (a) Triangular prism — Count the given properties against each solid. A triangular prism has 5 faces (2 triangular ends + 3 rectangular sides), 9 edges and 6 vertices — this matches exactly, so the solid is a triangular prism. A square-based pyramid also has 5 faces, but 8 edges and 5 vertices, and only one face is a square rather than three rectangles — the edge and vertex counts don't match. A cuboid has 6 faces, 12 edges and 8 vertices, none of which match the numbers given. A tetrahedron has 4 faces, all triangles, with 6 edges and 4 vertices — too few faces, and no rectangular faces at all.
- (c) 10.4 cm — Method: rearrange Area = (1/2)ab sin C to make the unknown side the subject: b = 2 × Area ÷ (a × sin C). Working: b = 2 × 36 ÷ (9 × sin 50°) = 10.4 cm (1 d.p.). Answer: 10.4 cm. Forgetting to double the area before dividing gives b = 36 ÷ (9 × sin 50°) = 5.2 cm; using cos 50° instead of sin 50° gives b = 2 × 36 ÷ (9 × cos 50°) = 12.4 cm; and multiplying by sin 50° instead of dividing by it — inverting the rearrangement — gives b = 2 × 36 × sin 50° ÷ 9 = 6.1 cm. Always double the area before dividing, and check whether the unknown should be multiplied or divided by sin C once you've rearranged.
- (b) 340 — The real length of the path is 8.5 × 2000 = 17000 cm, which converts to 170 m by dividing by 100. The cyclist rides the path there and back, so the total distance is 170 × 2 = 340 m. A candidate who forgets the return journey gives only the one-way distance, 170 m. A candidate who halves the one-way distance instead of doubling it, reading “there and back” as splitting the journey, gets 85 m. A candidate who doubles the scale factor to 4000 by mistake, getting a one-way length of 340 m, and then doubles that for the return journey, gets 680 m. The total distance the cyclist travels is 340 m.
- (d) 7.21 units — Method: the diagonal AC is the hypotenuse of the right-angled triangle ABC, whose shorter sides are AB and BC, so Pythagoras' theorem gives its length. Working: AB runs from (0, 0) to (6, 0), so AB = 6; BC runs from (6, 0) to (6, 4), so BC = 4. Then AC² = 6² + 4² = 36 + 16 = 52, so AC = √52 = 7.2111…, which is 7.21 correct to 2 decimal places. Answer: 7.21 units. The distractors: 10.00 units comes from adding the two sides, 6 + 4, instead of adding their squares and taking the root; 4.47 units comes from subtracting the squares, √(36 − 16), which is the form of Pythagoras used to find a shorter side rather than the hypotenuse; 26.00 units comes from halving 52 in place of taking its square root.
- (c) 6.3 m — By Pythagoras' theorem, the height = √(7² − 3²) = √(49 − 9) = √40 = 6.32...≈ 6.3 m. "6.4 m" rounds 6.32...m up to 6.4 instead of correctly rounding it down to 6.3. "4.0 m" comes from subtracting the two given lengths directly, 7 − 3 = 4, instead of subtracting their squares. "10.0 m" comes from adding the two given lengths, 7 + 3 = 10, instead of using Pythagoras' theorem at all.
- (b) RHS - right angle, hypotenuse and one side equal — A right angle, the hypotenuse (13 cm) and one other side (5 cm) are equal in both triangles, so this is RHS. SAS would need the equal angle to be the one INCLUDED between the two equal sides, but the right angle at B is not between AB and the hypotenuse AC — it is opposite the hypotenuse instead, so SAS does not apply directly here. SSS needs all three sides, but only two sides are stated. ASA needs two angles, but only one angle (the right angle) is given.
- (a) 8,000,000 cm³ — Method: change the edge length into centimetres first and then cube it, because 1 m = 100 cm and a volume needs that conversion applied to all three dimensions. Working: 2 m = 2 × 100 = 200 cm, so the volume is 200 × 200 × 200. 200 × 200 = 40,000 and 40,000 × 200 = 8,000,000. Answer: 8,000,000 cm³. The distractors: 8,000 cm³ comes from converting 2 m to 20 cm and cubing that; 80,000 cm³ comes from cubing in metres to get 8 m³ and then multiplying by 10,000, the conversion factor for an area rather than the 1,000,000 a volume needs; 8 cm³ comes from cubing the 2 without converting at all and simply writing cm³ because the question asked for that unit.
- (c) 282.6 cm³ — Volume of a cylinder = πr²h = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6 cm³. (94.2 cm³ comes from using πrh and forgetting to square the radius; 90 cm³ comes from using r²h and leaving π out altogether; 1130.4 cm³ comes from using the diameter, 6 cm, in place of the radius.)
- (c) 27.7 cm — Arc length = (150 ÷ 360) × 2 × 3.14 × 6 = (5 ÷ 12) × 37.68 = 15.7 cm. The perimeter of a sector also includes the two straight radii, so perimeter = 15.7 + 6 + 6 = 27.7 cm. (15.7 cm comes from stopping after the arc length and forgetting the two straight edges; 21.7 cm comes from adding only one radius instead of two; 31.4 cm comes from doubling the arc length instead of adding the two straight edges.)
- (c) 12.4 cm — Using the cosine rule, BC² = AB² + AC² − 2 × AB × AC × cos(A) = 9² + 6² − 2 × 9 × 6 × cos(110°) = 81 + 36 − 108 × cos(110°). Since cos(110°) ≈ −0.34202, 108 × cos(110°) ≈ −36.94, so BC² ≈ 117 + 36.94 = 153.94. Taking the square root, BC ≈ 12.4072, which rounds to 12.4 cm. 8.9 cm comes from treating cos(110°) as if it were positive (using +0.342 instead of −0.342), which wrongly subtracts instead of adds and gives BC² ≈ 80.06. 153.9 cm is BC² itself, rounded, with the square root never taken. 11.6 cm comes from leaving out the factor of 2 in the formula, computing BC² = 81 + 36 − 9 × 6 × cos(110°) ≈ 135.47 instead.
- (d) Two angles and a side: sine rule finds other sides. — Method: match the data you are given to the rule that needs it. Working: the sine rule a/sin A = b/sin B = c/sin C needs a complete angle-side pair to set up its ratio, so the statement that two angles and a side (AAS or ASA) let the sine rule find the other sides is the correct one — the third angle comes from the angle sum, and each unknown side is then opposite a known angle. The statement that two sides and the angle between them (SAS) call for the sine rule is wrong: no angle-side pair is complete, so the cosine rule is what works there. The statement that the sine rule finds any angle from three sides (SSS) is wrong for the same reason in reverse — no angle is known at all, so the cosine rule must find the first one. The statement that the cosine rule finds a missing angle directly from two sides and a non-included angle (SSA) is wrong: the cosine rule reports the angle enclosed by the two sides it uses, so with SSA it is the sine rule that reaches the missing angle, and the ambiguous case is then settled from the wording of the question.
- (b) 62° — Because AT is a diameter, the radius OT lies along AT, and the tangent PT meets every radius at 90°, by the tangent–radius theorem. So PT meets AT at T at a right angle: angle ATP = 90°. The angles of triangle APT sum to 180°, so angle APT = 180° − 90° − 28° = 62°. Copying the given angle PAT straight across, as though the triangle were isosceles, gives 28°. Adding the two known angles instead of subtracting them from 180° gives 90° + 28° = 118°. Naming the right angle itself, angle ATP, instead of the angle that was actually asked for gives 90°. Subtract both known angles from 180°, and 62° is angle APT.
Build your own mix at the worksheet builder.