Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 10 — Corresponding angles are equal, so 5x + 4 = 3x + 24. Subtracting 3x from both sides gives 2x + 4 = 24, then subtracting 4 gives 2x = 20, so x = 10. 14 comes from adding the constants, 4 + 24, instead of subtracting them when rearranging. 19 comes from treating the angles as co-interior (summing to 180°): 5x + 4 + 3x + 24 = 180 gives 8x = 152, so x = 19. 20 correctly reaches 2x = 20 but stops without dividing by 2.
- (b) 31.4 cm — Circumference = π × diameter, so 3.14 × 10 = 31.4 cm. 15.7 cm comes from using the radius, 5 cm, in place of the diameter: 3.14 × 5 = 15.7, which is only half the circumference. 78.5 cm comes from using the area formula π × radius² instead of the circumference formula: 3.14 × 5² = 3.14 × 25 = 78.5. 62.8 cm comes from keeping the 2 from the radius form of the formula, C = 2 × π × radius, but putting the full diameter into it: 2 × 3.14 × 10 = 62.8.
- (a) 5√2 cm — Method: the angles of a triangle add to 180°, so the third angle is 45° as well and the two shorter sides are equal. Take one of them as the side opposite a 45° angle and use sin 45° = opposite ÷ hypotenuse. Working: the exact value of sin 45° is √2/2, so the shorter side = 10 × √2 ÷ 2, and half of 10 is 5. Answer: 5√2 cm, which is about 7.07 cm. Remembering sin 45° as √2 rather than as √2 halved gives 10√2 cm, which is longer than the hypotenuse. Halving the hypotenuse because 45° is half of 90° gives 5 cm. Taking the value from the other special triangle, sin 60° = √3/2, gives 5√3 cm.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (a) 44.7 m — Method: the line joining the two tops is the hypotenuse of a right-angled triangle whose horizontal side is the gap between the masts and whose vertical side is the difference in their heights, so Pythagoras' theorem applies. Working: the difference in heights is 50 − 30 = 20 m, so d² = 40² + 20² = 1600 + 400 = 2000 and d = √2000 = 44.721…, which is 44.7 m to 1 decimal place. Answer: 44.7 m. The distractors: 34.6 m comes from subtracting the squares, √(40² − 20²), instead of adding them; 60.0 m comes from adding the two sides of the triangle, 40 + 20, rather than using Pythagoras' theorem; 50.0 m is the height of the taller mast, copied from the question in place of the distance asked for.
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (c) 27.7 cm — Arc length = (150 ÷ 360) × 2 × 3.14 × 6 = (5 ÷ 12) × 37.68 = 15.7 cm. The perimeter of a sector also includes the two straight radii, so perimeter = 15.7 + 6 + 6 = 27.7 cm. (15.7 cm comes from stopping after the arc length and forgetting the two straight edges; 21.7 cm comes from adding only one radius instead of two; 31.4 cm comes from doubling the arc length instead of adding the two straight edges.)
- (b) 8.64 m — The real length is 240 times the model length: 3.6 × 240 = 864 cm. Converting to metres, 864 cm ÷ 100 = 8.64 m. The distractor 864 m comes from finding the length correctly in centimetres but forgetting to convert to metres. The distractor 0.0864 m comes from dividing by 100 a second time, converting 864 cm to metres twice over (864 ÷ 10 000) instead of once. The distractor 86.4 m comes from converting centimetres to metres by dividing by 10 instead of 100.
- (b) 320° — A bearing is always measured clockwise from north. An angle measured anticlockwise must be converted by subtracting it from 360°: 360 − 40 = 320°, so the bearing is 320°. Choosing 040° treats the anticlockwise angle as if it were already a clockwise bearing, without converting it. Choosing 220° adds 180° to the angle, mixing this up with a back-bearing calculation (40 + 180 = 220). Choosing 400° adds the angle to 360° instead of subtracting it (40 + 360 = 400), giving a bearing greater than a full turn.
- (b) 35° — Method: angle CBE and angle ABC lie on a straight line at B, so they are supplementary; angle ABC then equals angle ADC because B and D are both on the major arc AC (angles in the same segment). Working: angle ABC = 180 − 145 = 35 degrees, using angles on a straight line. Since B and D are both on the major arc AC, angle ADC = angle ABC = 35°. Answer: 35°. Find angle ABC FIRST from the straight line at B before applying the circle theorem: using the given 145° directly, doubling or halving it, or subtracting it from 180° a second time all give the wrong angle.
- (c) 32 — Method: alternate angles between parallel lines are equal, so 2x + 10 = 74. Working: subtracting 10 from both sides gives 2x = 64; dividing by 2 gives x = 32. Answer: x = 32. A candidate who forgets to subtract 10 first and divides 74 by 2 directly gets 37. A candidate who treats the angles as co-interior instead of alternate, so that the two expressions add to 180° rather than being equal, gets 48 after solving. A candidate who makes a sign error and treats the equation as 2x equalling 10 minus 74 instead of 74 minus 10 gets −32.
- (a) a line parallel to both, 3 cm from each — Being equidistant from two parallel lines 6 cm apart means being exactly halfway between them all along their length, tracing out a third line, parallel to both, at 3 cm from each — half of the 6 cm gap. "a line parallel to both, 6 cm from each" repeats the full gap instead of halving it, which puts those points past one of the lines entirely. "a circle of radius 3 cm, centred midway" applies to a locus equidistant from a single fixed POINT, not from two parallel lines running the full length. "the perpendicular bisector of the gap" crosses the gap at right angles and meets each line at only one point — it is not the whole locus, which runs parallel to the lines, not across them.
- (b) $\binom{-0.4}{-7}$ — The overall movement is the sum of the two vectors: (−1.2 + 0.8, −4.5 + (−2.5)) = (−0.4, −7). '$\binom{-2}{-2}$' comes from subtracting the second vector from the first instead of adding them. '$\binom{-0.4}{7}$' gets the top number right but drops the negative sign on the bottom number. '$\binom{2}{-7}$' comes from treating −1.2 + 0.8 as if the signs did not matter, giving +2 instead of −0.4.
- (a) 2.40m — Method: a cost found from a rate is the rate multiplied by the amount bought. Working: the rate is £2.40 per kilogram and the amount is m kilograms, so the cost is 2.40 × m. Answer: 2.40m. A candidate who divides the amount by the rate instead of multiplying writes m/2.40. A candidate who adds the rate to the amount instead of multiplying writes 2.40 + m. A candidate who subtracts the rate from the amount instead of multiplying writes m − 2.40.
- (d) 6 — The plan view shows every square of the base footprint, whether or not there is a taller stack above it — the base layer alone already covers a 3 by 2 rectangle of cubes, which is 6 squares. The extra cube on top of a corner cube sits directly above a square that is already counted, so it adds no NEW square to the plan — height does not show up in a plan view, only footprint does. "7" comes from wrongly counting the extra cube as an additional square. "5" comes from missing one square of the base rectangle, perhaps forgetting a corner. "3" comes from counting only one row of the base rectangle and forgetting that the base is two rows deep.
Build your own mix at the worksheet builder.