Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) £982.20 — Method: find the missing side BC with the cosine rule, add it to AB and AC for the perimeter, then multiply by the cost per metre. Working: BC² = 45² + 38² − 2 × 45 × 38 × cos 110° = 4638.71, so BC = 68.108 m, perimeter = 45 + 38 + 68.108 = 151.108 m, and cost = 151.108 × £6.50 = £982.20 — keep the unrounded perimeter, because the rounded 151.1 m would give £982.15. Forgetting the negative sign in the cosine rule gives BC = 48.0 m and a cost of £851.18; costing only the missing side BC and forgetting to include AB and AC gives £442.70; and stopping after finding the perimeter, without multiplying by the cost per metre, gives £151.11. The perimeter is only the halfway point of this question — the cost still has to be worked out.
- (c) 45° — Method: the tower, the ground and the line of sight form a right-angled triangle in which the 25 m height is opposite the angle of elevation and the 25 m along the ground is adjacent to it, so use tan θ = opposite ÷ adjacent. Working: tan θ = 25 ÷ 25 = 1, so θ = tan⁻¹(1). Answer: 45°. The distractors: 90° comes from using sin θ = 25 ÷ 25 = 1, which treats the 25 m along the ground as the hypotenuse when it is the side next to the angle; 1° comes from writing down the value of tan θ as though it were the angle itself; 50° comes from adding the two given lengths, 25 + 25, instead of comparing them.
- (c) 1.5 — The area scale factor is the length scale factor squared, so if n is the length factor, n² = 2.25. Taking the positive square root gives n = 1.5 (check: 1.5² = 2.25). 2.25 is just the area factor restated, with no root taken. 1.125 comes from halving 2.25 instead of taking its square root. 5.0625 comes from squaring 2.25 instead of rooting it.
- (d) 49° — Method: first combine the two given angles at the centre to find the whole central angle FOM, then apply the angle-at-the-centre theorem, which halves the central angle to give the angle at the circumference on the major arc. Working: angle FOM = angle FOP + angle POM = 55 + 43 = 98 degrees. Since S is on the major arc FM, angle FSM = 98 ÷ 2 = 49 degrees. Answer: 49°. Add BOTH given angles to find the whole angle FOM before you halve anything: halving only one of them, doubling the total instead of halving it, or subtracting from 180° all give the wrong angle for the programme.
- (b) Cuboid — not necessarily a cube — A solid with 6 faces, 12 edges and 8 vertices in which every face is a rectangle is a cuboid, but nothing here confirms that all the edges are the same length, so the box could be a cube or a non-cube cuboid; the most that can be concluded is that it is a cuboid, making 'Cuboid — not necessarily a cube' correct. 'Cube — only a cube fits this' is wrong because a cube is just one particular cuboid; a general cuboid with different length, width and height has exactly the same face, edge and vertex counts and rectangular faces. 'Triangular prism' is wrong because a triangular prism has 5 faces, 9 edges and 6 vertices, and two of its faces are triangles, so it matches neither the counts nor the face shape. 'Not enough information' is wrong because rectangular faces with these counts do pin the solid down to the cuboid family, even though they cannot pin down a cube specifically.
- (d) 8.8 km — Method: turn each bearing into an angle of triangle ABC, find the third angle from the angle sum, then use the sine rule. Working: B is due east of A, so AB itself lies on a bearing of 090°, and the angle at A between AB and AC is 090° − 062° = 28°. From B, station A lies due west on a bearing of 270°, and C lies on 315°, so the angle at B is 315° − 270° = 45°. The third angle is 180° − 28° − 45° = 107°. The side BC faces the 28° angle and AB = 18 km faces the 107° angle, so BC = 18 × sin 28° ÷ sin 107° = 8.4505 ÷ 0.95630 = 8.8366. Answer: the boat is 8.8 km from B, to 1 decimal place. The distractors: 13.3 km comes from pairing BC with the 45° angle at B instead of the 28° angle it faces, which gives the distance AC; 12.0 km comes from never working out the third angle and dividing by sin 45° instead of sin 107°; 16.6 km comes from using the bearing 062° itself as the angle at A, instead of the 28° between AC and AB.
- (b) It is the longest of the three chords — Method: in any circle the length of a chord is decided by how far the chord lies from the centre, because a chord passing nearer the centre cuts further across the circle. Working: the chord through O lies at a distance of zero from the centre, and no chord can lie closer than that, so no chord of the circle can be longer than it; a chord through the centre is a diameter. The other two chords lie at some distance greater than zero, so each of them falls short of that maximum. Answer: It is the longest of the three chords. The distractors: It is the shortest of the three chords comes from reversing the rule and picturing a chord near the centre as a short line tucked inside; It is the same length as the other two chords comes from carrying the fact that all radii of a circle are equal across to chords, which are not all equal; It is half the length of each of the other two chords comes from confusing a chord through the centre with a radius, which really is half a diameter.
- (c) (4, 3) — Method: the midpoint of a segment is the mean of its two end points, so its x-coordinate is the mean of the two x-coordinates and its y-coordinate is the mean of the two y-coordinates. Working: for x, (1 + 7) ÷ 2 = 8 ÷ 2 = 4. For y, (3 + 3) ÷ 2 = 6 ÷ 2 = 3. The midpoint is therefore (4, 3). Answer: (4, 3). The distractors: (3, 3) comes from halving the difference of the x-coordinates, (7 − 1) ÷ 2 = 3, which measures half the distance instead of locating the point; (3.5, 3) comes from halving only the larger x-coordinate and leaving the smaller one out of the working; (4, 0) comes from averaging the x-coordinates correctly but then subtracting the y-coordinates, 3 − 3, rather than averaging them.
- (c) A rotation of 180° about the origin — An enlargement by scale factor −1 sends every point (x, y) to (−x, −y) — both coordinates change sign. A rotation of 180° about the origin does exactly the same thing to every point, so the two transformations have identical effect. A reflection in the x-axis only changes the sign of the y-coordinate, sending (x, y) to (x, −y), leaving the x-coordinate untouched. A reflection in the y-axis only changes the sign of the x-coordinate, sending (x, y) to (−x, y), leaving the y-coordinate untouched. Treating a negative scale factor as though it behaves like a positive one gives no transformation at all, but the minus sign is not decorative — it reverses both coordinates. Both signs flip together, which is exactly what a 180° rotation about the origin does.
- (b) 166.3 cm² — Method: split the regular hexagon into 6 identical triangles meeting at the centre, each with two sides of 8 cm and a 60° angle between them, and use Area = (1/2)ab sin C on just one of them. Working: one triangle's area = 1/2 × 8 × 8 × sin 60° = 27.7 cm² (1 d.p.); the hexagon is 6 of these, so its area is 6 × 27.7 = 166.3 cm² (1 d.p.). Answer: 166.3 cm². Reporting just one triangle's area, without multiplying by 6, gives 27.7 cm²; treating the angle at the centre as a right angle instead of 60°, using 1/2 × 8 × 8 with no sine factor at all, gives 6 × 32 = 192.0 cm²; and multiplying by 5 instead of 6, miscounting the triangles in the hexagon, gives 5 × 27.7 = 138.6 cm². A regular hexagon always splits into exactly 6 triangles at its centre — count them before you multiply.
- (d) (6, 2) — Applying the first vector: (2, 1) + (5, −3) = (7, −2), which is the warehouse. Applying the second vector: (7, −2) + (−1, 4) = (6, 2), the delivery address. '(7, −2)' stops at the warehouse and forgets the second flight. '(8, −6)' comes from adding (1, −4) instead of (−1, 4) for the second vector, getting both signs wrong. '(11, −3)' comes from swapping the components of the second vector to (4, −1) before adding.
- (a) 314 cm² — Method: the area of a circle is πr², and the radius is half the diameter, so halve the 20 cm before squaring. Working: r = 20 ÷ 2 = 10 cm, so the area is 3.14 × 10² = 3.14 × 100 = 314. Answer: 314 cm². The distractors: 1256 cm² comes from putting the diameter straight into πr² without halving it, 3.14 × 20²; 628 cm² comes from halving correctly but then using 2πr², a mixture of the circumference and area formulae; 62.8 cm² comes from working out πd = 3.14 × 20, which is the circumference of the plate rather than its area.
- (b) 320° — A bearing is always measured clockwise from north. An angle measured anticlockwise must be converted by subtracting it from 360°: 360 − 40 = 320°, so the bearing is 320°. Choosing 040° treats the anticlockwise angle as if it were already a clockwise bearing, without converting it. Choosing 220° adds 180° to the angle, mixing this up with a back-bearing calculation (40 + 180 = 220). Choosing 400° adds the angle to 360° instead of subtracting it (40 + 360 = 400), giving a bearing greater than a full turn.
- (c) 13 — Area of the trapezium = 1/2 × (8 + 12) × 5 = 1/2 × 100 = 50 m². Number of bags = 50 ÷ 4 = 12.5, which rounds up to 13 bags since seed is sold only in whole bags. A student who mistakenly uses 2 m² of coverage per bag instead of 4 m² finds 50 ÷ 2 = 25 bags.
- (b) 8 cm — Area = base × height, so height = area ÷ base = 136 ÷ 17 = 8 cm. (16 cm comes from using the triangle formula, thinking area = 1/2 × base × height and so height = 2 × area ÷ base; 2312 cm comes from multiplying the area by the base instead of dividing; 119 cm comes from subtracting the base from the area instead of dividing the area by the base.)
Build your own mix at the worksheet builder.