Geometry and measures worksheet — GCSE Higher

1.In triangle ABC, AB = 13 cm, AC = 9 cm and angle ABC = 35°. Given that angle ACB is obtuse, work out its size. Give your answer to 1 decimal place.

2.A running track has a straight section and a semicircular bend. The bend is a semicircle with radius 32 m. Work out the length of the curved part of the bend, to 1 decimal place. (Use π = 3.14.)

3.A sector of a circle has radius 12 cm and angle 45°. Using π = 3.14, work out the area of the sector.

4.PT is a tangent to a circle with centre O, touching the circle at T. OT is a radius. Angle OPT = 27°, where P is a point outside the circle. Work out the size of angle POT.

5.A window is made from a rectangle with a semicircle on top. The rectangle is 40 cm wide and 60 cm tall. The semicircle has the same width as the rectangle. Work out the total area of the window. Use π = 3.14. Give your answer to the nearest whole number.

6.A shop sells a scale model of a van. The model and the real van are similar shapes, with lengths in the ratio 1 : 24. The model is 18.5 cm long. Work out the length of the real van, giving your answer in metres.

7.A television cable runs in a straight line from the edge of a flat roof 20 m above the ground to a bracket on a wall 5 m above the ground. The horizontal distance between the roof edge and the bracket is 15 m. Work out the length of the cable. Give your answer to 1 decimal place.

8.A shopkeeper builds a display from two cuboid boxes, shown in the diagram. She wants to cover the front of the display with coloured paper. Work out the total area of the front elevation, in square centimetres.

9.A ramp is built from two straight metal supports that rest on the flat ground and meet each other at the top, forming a triangle with the ground. One support meets the ground at 34°. The angle between the two supports where they meet is 71°. Work out the angle between the second support and the ground.

10.A sailmaker cuts two triangular sail panels from a pattern. Panel X has a 10 m side, with angles of 50° and 75° at its two ends. Panel Y also has a 10 m side, with angles of 50° and 75° at its two ends, in the same arrangement. The sailmaker wants to check the panels will match exactly, without cutting a third measurement. Which condition proves the two panels are congruent?

11.The angle between north and a cycle path is 40°, but it is measured anticlockwise from north. What is the three-figure bearing of the cycle path?

12.A composite solid is made from a cylinder of radius 3 cm and height 10 cm, with a cone of the same radius and vertical height 4 cm fixed on top, apex upward. Work out the total volume of the solid. Use π = 3.14 and give your answer correct to 1 decimal place.

13.A footpath is 3750 m long. Work out this distance in kilometres.

15.A scale drawing uses a scale of 1 : 60. A path on the drawing is measured as 9.8 cm long. What is the real length of the path, in metres, to 1 decimal place?