Geometry and measures worksheet — GCSE Higher

1.A sector of a circle has radius 8 cm and takes up three-quarters of the full circle. Work out the perimeter of the sector, in terms of π.

2.A ship sails 12 km on a bearing of 070° from a harbour to a buoy. It then sails a further 9 km, still on a bearing of 070°, from the buoy to a lighthouse. How far is the lighthouse from the harbour, in kilometres?

4.A builder lays a low wall made from identical bricks. The diagram shows the plan of the wall's footprint on a grid, where each square is one brick. The wall is built up to a height of 4 bricks everywhere. Work out the total number of bricks used.

5.A pinhole camera is set up at a pitch-side stand, with its aperture at the point O = (2, 1) on a grid. Light from the corner F of a triangular flag, at the point (4, 2), passes through the aperture and forms an inverted image on the film behind it. The projection is an enlargement of scale factor −1.5 centred at O. Work out the coordinates of the image of corner F.

6.A pop-up canopy has two sloping supports that meet at the top. Each support makes an angle of 30° with the ground and is 6 m long. Using the exact value of cos 30°, work out the total width of the canopy's base.

7.a is the column vector with top number 3 and bottom number −2. b is the column vector with top number −1 and bottom number 5. Work out 2a + b, giving your answer as a column vector in the form (top, bottom).

8.OABC is a parallelogram, with OA = a and OC = c. X is the point on AC such that AX is a third of XC. Express the vector OX in terms of a and c.

9.A roof has two triangular sections, P and Q. Section P has a sloping edge of 3.6 m and a base edge of 2.4 m, with an angle of 70° between them. Section Q has a sloping edge of 3.6 m and a base edge of 2.4 m, with an angle of 70° between them, arranged the same way round. A roofer wants to cut identical triangular felt panels for both sections without measuring Section Q separately. Which condition confirms that the two sections are congruent?

10.Two straight roads cross at a junction. The angle between them, measured with a protractor, is 118°. What is the size of the angle vertically opposite to it?

11.A scale drawing of a bridge uses a scale of 1 : 25. A support beam on the drawing measures 4.4 cm. What is the real length of the beam, in metres?

12.PT is a tangent to a circle with centre O, touching the circle at T. C is a point on the circle such that C lies inside angle OTP (the right angle between the radius OT and the tangent PT), and OC is a radius. Angle TOC = 130°. Work out the size of angle PTC, the angle between the tangent PT and the chord TC.

13.Triangle D has vertices (3, 1), (3, 5) and (6, 1). It is reflected in the line x = 3. Write down the number of vertices of the triangle that are invariant under this reflection.

14.Lines GH and JK are parallel. A straight line crosses GH at point M and crosses JK at point N. Angle HMN = 71°. Angle HMN and angle MNK are alternate angles. Work out angle MNK.

15.A carpenter cuts two triangular metal brackets for a shelf. Bracket P has sides of 12 cm, 16 cm and 20 cm. Bracket Q has sides of 16 cm, 20 cm and 12 cm, listed in a different order. Before fitting them as a matching pair, the carpenter wants to check they are exactly the same shape and size. Which of the following correctly justifies this?