Printable · GCSE Higher · ages 14-16

Geometry and measures worksheet — GCSE Higher

Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.

Non-calculator

VersionsA only A + B A + B + Csame questions, different order

AnswersQuestions only With answer key Key only

CalculatorMixed Non-calculator (Paper 1)Calculator (Papers 2 and 3)

New sheet

Geometry and measures worksheet — GCSE Higher

Maths · GCSE Higher · Geometry and measures · Non-calculator · 15 questions

MathsUKwww.geekhero.co.uk

1.A garden designer describes a flower bed as a shape with four straight sides: exactly one pair of sides is parallel, those two parallel sides are different lengths, and the other two sides are equal in length to each other but not parallel to each other. Which shape should the designer draw?
(a)isosceles trapezium
(b)rhombus
(c)kite
(d)parallelogram
2.In a kite, one pair of opposite angles are equal in size. In kite WXYZ, angle X = 40° and angle Z = 100° are the two angles that are NOT equal to each other. The other two angles, W and Y, are equal to each other. Work out the size of angle W.
(a)110°
(b)40°
(c)220°
(d)140°
3.A shop stacks tins in a display block. The front elevation of the block is 4 tins wide and 3 tins high. The side elevation shows the block is 2 tins deep. Every position in the block is filled. How many tins are used in total?
(a)24
(b)6
(c)12
(d)9
4.The interior angles of a pentagon are 100°, 110°, 120°, x° and x°. Work out the size of each of the two angles marked x°.
(a)105°
(b)55°
(c)108°
(d)210°
5.A circular plate has a diameter of 20 cm. Work out the area of the plate. Use π = 3.14.
(a)314 cm²
(b)1256 cm²
(c)62.8 cm²
(d)628 cm²
6.A shop sells a scale model of a van. The model and the real van are similar shapes, with lengths in the ratio 1 : 24. The model is 18.5 cm long. Work out the length of the real van, giving your answer in metres.
(a)444 m
(b)44.4 m
(c)0.77 m
(d)4.44 m
7.From an external point P, two tangents PA and PB touch a circle with centre O at A and B. Angle AOB = 112°. Work out the size of angle APB.
(a)68°
(b)112°
(c)90°
(d)56°
8.A circle has two straight radii drawn from the centre to the edge, together with the arc between them. Write down the name of the region enclosed by these two radii and the arc.
(a)chord
(b)segment
(c)semicircle
(d)sector
9.A student says the reverse of the translation vector $(- 9 4)$ is $(9 4)$ . Write down the correct reverse translation vector.
(a) $(- 9 - 4)$
(b) $(- 9 4)$
(c) $(9 - 4)$
(d) $(9 4)$
10.Put sin 30°, tan 30° and cos 30° in order of size, starting with the smallest.
(a)sin 30°, cos 30°, tan 30°
(b)cos 30°, tan 30°, sin 30°
(c)tan 30°, sin 30°, cos 30°
(d)sin 30°, tan 30°, cos 30°
11.A rhombus has all four sides equal in length, but it is not a square — its angles are not all 90°. How many lines of symmetry does this rhombus have?
(a)2
(b)1
(c)4
(d)0
12.Line l1 has equation x = 2, and line l2 has equation y = x − 1. They intersect at a single point. A shape is reflected in l1, and the image is then reflected in l2. Which point is invariant under this combined transformation?
y = x − 1
(a)(2, 2)
(b)(1, 0)
(c)(2, 1)
(d)(2, 3)
13.Two triangles are proved congruent using the ASA condition. What can be concluded about the two remaining pairs of corresponding sides that were not part of the original ASA facts?
(a)They must be different
(b)They might be equal or not
(c)They must also be equal
(d)Not enough information to say
14.In geometry, which of the following best describes a 'plane'?
(a)A flat surface extending infinitely in two directions
(b)A straight line extending in one direction
(c)A single, fixed position with no size
(d)A flat, bounded face on a 3D shape
15.State whether the line segment joining A(−4, 3) and B(2, 6) is horizontal, vertical or neither, and give a reason for your answer.
(a)Horizontal, because both points have a y-coordinate
(b)Neither, because both coordinates differ
(c)Horizontal, because the x-coordinates increase from A to B
(d)Vertical, because both points have an x-coordinate

Build your own mix at the worksheet builder.