Geometry and measures worksheet — GCSE Higher

1.A drone flies from its base in three stages, each stage measured in metres east and north as a column vector. Stage 1 is the column vector with top number 30 and bottom number 40. Stage 2 is the column vector with top number −10 and bottom number 20. Stage 3 is the column vector with top number 15 and bottom number −5. Work out the column vector that would take the drone in a single straight flight back to its base from where it ends up.

2.Work out the exact value of (cos 45°)² + (sin 45°)².

3.In kite WXYZ, WX = WZ and XY = ZY (so at each of X and Z, one side from each of the two unequal pairs meets). Angle X = 100°. Work out angle Z.

4.A chord divides a circle into two segments of different sizes. Write down the name given to the smaller of the two segments.

5.Triangle ABC has AB = 8 cm, BC = 10 cm and CA = 6 cm. Triangle LMN has LM = 10 cm, MN = 6 cm and NL = 8 cm. The two triangles are congruent by SSS. Which of the following correctly matches the corresponding vertices?

6.A, B and C are points on a circle with centre O, and AC is a diameter of the circle. Work out the size of angle ABC.

7.Triangle T has an area of 6 cm². It is enlarged by scale factor −2 about the origin, and the image is then rotated 90° about the origin. Work out the area of the final image, and state whether it is the same way round as T or a mirror image of it.

8.Two similar triangles have lengths in the ratio 2 : 5. The sides of the smaller triangle are 4 cm, 6 cm and 8 cm. Work out the length of the longest side of the larger triangle.

9.A tangent to a circle with centre O touches the circle at point P, where OP = 5 cm. Point Q lies on the tangent so that PQ = 12 cm. Using the fact that a tangent is perpendicular to the radius at the point of contact, work out the length OQ.

10.A line passes through the points (1, 2) and (3, 6). The line is reflected in the x-axis, and the image is then translated by the vector (2, 0). Work out the gradient of the image line after both transformations.

11.A scale drawing of a bridge uses a scale of 1 : 25. A support beam on the drawing measures 4.4 cm. What is the real length of the beam, in metres?

12.A trapezium has vertices (0, 2), (4, 2), (3, 5) and (1, 5). It is rotated 180° about the point (2, 2), and the image is then translated by the vector (1, −5). Work out the coordinates of the image of (0, 2).

13.The bearing of a harbour B from a ferry's position A is 260°. What is the bearing of A from B?

14.A shop sells a scale model of a van. The model and the real van are similar shapes, with lengths in the ratio 1 : 24. The model is 18.5 cm long. Work out the length of the real van, giving your answer in metres.

15.A pinhole camera is set up at a pitch-side stand, with its aperture at the point O = (2, 1) on a grid. Light from the corner F of a triangular flag, at the point (4, 2), passes through the aperture and forms an inverted image on the film behind it. The projection is an enlargement of scale factor −1.5 centred at O. Work out the coordinates of the image of corner F.