Geometry and measures worksheet — GCSE Higher

1.A trapezium has parallel sides of length 6 cm and 10 cm, and a perpendicular height of 4 cm. Work out its area.

2.A trapezium has vertices (0, 2), (4, 2), (3, 5) and (1, 5). It is rotated 180° about the point (2, 2), and the image is then translated by the vector (1, −5). Work out the coordinates of the image of (0, 2).

3.In triangle ABC the angle at C is 90° and the hypotenuse AB is 12 cm. H is the point on AB for which CH is perpendicular to AB, and AH = 3 cm. Work out the length of AC.

4.A hexagonal prism lies on a table. A flat cut is made straight across it, at right angles to its length (so the cut is parallel to the two identical end faces). What shape is the cross-section?

5.Triangle XYZ has angle X = 90°. Angle Y = 34°. Work out angle Z.

6.A, B and C are points on a circle with centre O. B is on the minor arc AC. Angle ABC = 100°. Work out the size of the non-reflex angle AOC.

7.A student is proving that opposite angles of a cyclic quadrilateral ABCD sum to 180°, letting a = angle DAB and c = angle BCD, and using the fact that the angle at the centre is twice the angle at the circumference. She has already written: 'By the angle at the centre theorem, the reflex angle BOD equals 2a and the non-reflex angle BOD equals 2c.' Which statement must come immediately after this one in a correct proof?

8.A chord divides a circle into two regions, one larger than the other. Write down the term used for the smaller of these two regions.

9.A tank holds 3.2 m³ of water. Work out this volume in litres.

10.A hexagon has interior angles of 130°, 142°, 125°, 150°, 135° and x°. Work out the value of x.

11.A solid pyramid has a square base of side 6 cm. Its apex is directly above the centre of the base, at a vertical height of 8 cm. Work out the volume of the pyramid.

12.A ramp's sloped surface crosses two horizontal parallel rails. At the top rail, the angle between the ramp and the rail on the right of the ramp is (3x + 10)°. At the bottom rail, the angle between the ramp and the rail on the left of the ramp is (5x − 30)°. Work out the value of x.

13.In geometry, which of the following best describes a 'plane'?

14.An engineer models a technical drawing on a coordinate grid. A component is reflected in the line x = 2, and the image is then reflected in the line x = 6. Which single transformation has the same overall effect as these two reflections, for every point on the drawing?

15.Line l1 has equation x = 2, and line l2 has equation y = x − 1. They intersect at a single point. A shape is reflected in l1, and the image is then reflected in l2. Which point is invariant under this combined transformation?