Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.In triangle OAB, OA = a and OB = b. M is the midpoint of OA, and N is the midpoint of OB. Express the vector MN in terms of a and b.
- 2.A chord divides a circle into two regions, one larger than the other. Write down the term used for the smaller of these two regions.
- 3.Two triangles are proved congruent using the ASA condition. What can be concluded about the two remaining pairs of corresponding sides that were not part of the original ASA facts?
- 4.A pinhole camera is set up at a pitch-side stand, with its aperture at the point O = (2, 1) on a grid. Light from the corner F of a triangular flag, at the point (4, 2), passes through the aperture and forms an inverted image on the film behind it. The projection is an enlargement of scale factor −1.5 centred at O. Work out the coordinates of the image of corner F.
- 5.A rhombus has all four sides equal in length, but it is not a square — its angles are not all 90°. How many lines of symmetry does this rhombus have?
- 6.A rectangle has vertices at (2, 1), (9, 1), (9, 5) and (2, 5). Work out the area of the rectangle.
- 7.A ramp is built from two straight metal supports that rest on the flat ground and meet each other at the top, forming a triangle with the ground. One support meets the ground at 34°. The angle between the two supports where they meet is 71°. Work out the angle between the second support and the ground.
- 8.Triangle A has vertices (2, 1), (5, 1) and (2, 4). It is translated by the vector (−3, 2) and the image is then reflected in the x-axis. Work out the coordinates of the image of (5, 1).
- 9.A trundle wheel has a diameter of 0.5 m. It is rolled along the ground and makes 20 complete turns. Using π = 3.14, work out the total distance rolled, in metres.
- 10.In quadrilateral WXYZ, which of the following correctly names the angle at vertex Y using standard notation?
- 11.A crane's hook starts at the point (3.4, 9.5) on a construction site plan measured in metres. It moves along the vector to pick up a beam, then along the vector to place it. Work out the single column vector that describes the hook's overall movement from its start position to where it places the beam.
- 12.A hexagon has interior angles of 130°, 142°, 125°, 150°, 135° and x°. Work out the value of x.
- 13.A student says the reverse of the translation vector is . Write down the correct reverse translation vector.
- 14.A builder props a straight plank against a vertical wall to reach a window ledge. The foot of the plank is 2.1 m from the base of the wall, and the plank is 3.5 m long. Work out how high up the wall the plank reaches.
- 15.A scale drawing shows a room that is 5 cm wide. The real room is 15 m wide. Write the scale of the drawing in the form 1 : n.
Build your own mix at the worksheet builder.