Printable · GCSE Higher · ages 14-16
Limits of accuracy and bounds worksheet — GCSE Higher
Fifteen questions on "limits of accuracy and bounds" — DfE statement N16. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
part HigherCalculator
Answer key: Limits of accuracy and bounds worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) the nearest whole number — The error intervals are 23.5 ≤ p < 24.5 and 5.5 ≤ q < 6.5. The minimum of p ÷ q is 23.5 ÷ 6.5 ≈ 3.615, and the maximum is 24.5 ÷ 5.5 ≈ 4.455. Both of these round to 4 at the nearest whole number, so the answer is guaranteed correct to the nearest whole number — but not to the nearest 0.1, since 3.615 rounds to 3.6 while 4.455 rounds to 4.5, which do not agree. Claiming the nearest 0.1 assumes every figure a calculator shows is trustworthy, without checking whether the bounds actually agree that far. Claiming only the nearest 10 badly understates how much can be guaranteed here, since both bounds already round to 4, not merely to 0. Saying no degree of accuracy can be guaranteed gives up before checking whether the bounds agree at any level at all.
- (d) £4.80 — Method: find the error interval, then check which value falls outside it. Working: half of 20p is 10p, so the actual cost, c, satisfies £4.50 ≤ c < £4.70. £4.80 is above £4.70, so it could not be the actual cost. Answer: £4.80. (£4.50 is a genuine possible cost — it sits at the included lower boundary. £4.65 is a genuine possible cost, below the £4.70 upper boundary. £4.55 is a genuine possible cost, well inside the interval.)
- (b) Yes — the actual mass could be as low as 995 g — Method: a mass shown to the nearest 10 g lies within half of 10 g, that is 5 g, of the figure on the display, so compare the smallest mass the bag can have with the checker's limit of 996 g. Working: 1,000 − 5 = 995, so the actual mass of the bag can be as low as 995 g, and 995 g is below the 996 g limit, so a bag showing 1,000 g on the machine can still be rejected. Answer: Yes — the actual mass could be as low as 995 g. The distractors: 990 g comes from going a whole 10 g below the display instead of half of it; 999.5 g comes from treating the display as being to the nearest gram, when it is to the nearest 10 g; the claim that the mass is exactly 1,000 g treats a rounded display as an exact measurement.
- (b) 1.45 ≤ m < 1.55 — The flour's mass is labelled 1.5 kg, correct to the nearest 0.1 kg, so half of 0.1 kg is added to and subtracted from 1.5 kg to find the interval: 1.5 − 0.05 = 1.45 and 1.5 + 0.05 = 1.55, giving 1.45 ≤ m < 1.55. '1.4 ≤ m < 1.6' comes from taking the whole 0.1 kg as the margin either side, instead of half of it. '1.45 < m ≤ 1.55' comes from writing the inequality signs the wrong way round — the lower bound should be included and the upper bound excluded, not the other way round. '1.45 ≤ m ≤ 1.55' comes from including the upper bound, when the convention is that the upper bound is never actually reached.
- (a) 1,850 — Method: find the error interval, then check which value falls outside it. Working: half of 100 is 50, so the actual number of visitors, v, satisfies 1,750 ≤ v < 1,850. 1,850 sits exactly on the excluded upper boundary, since a value of 1,850 would round to 1,900, not 1,800. Answer: 1,850. (1,750 is a genuine possible value — it sits at the included lower boundary. 1,799 is a genuine possible value, just below the upper boundary. 1,760 is a genuine possible value, well inside the interval.)
- (c) 62.35 ≤ r < 62.45 — Method: with a value rounded to 1 decimal place, the error interval reaches half of 0.1 either side. Working: half of 0.1 is 0.05, so the interval runs from 62.4 − 0.05 to 62.4 + 0.05. Answer: 62.35 ≤ r < 62.45. (62 ≤ r < 63 comes from rounding to the nearest whole number instead of 1 decimal place. 62.35 ≤ r ≤ 62.45 comes from including the upper bound with ≤ instead of excluding it with <. 62.3 ≤ r < 62.5 comes from using 0.1 either side instead of half of it.)
- (b) 18.5 ≤ T < 18.7 — Method: the error interval reaches half the rounding unit either side of the recorded value. Working: half of 0.2 is 0.1, so the interval runs from 18.6 − 0.1 to 18.6 + 0.1. Answer: 18.5 ≤ T < 18.7. (18.4 ≤ T < 18.8 comes from using the full rounding unit, 0.2, either side instead of half of it. 18.5 ≤ T ≤ 18.7 comes from including the upper bound with ≤ instead of excluding it with <. 18.6 ≤ T < 18.8 comes from treating the recorded value as the start of the interval and adding the whole rounding unit, 0.2, above it.)
- (b) No, the true mass could be as high as 852.5 kg — Method: find the upper bound of the true mass and compare it with the weight limit. Working: the display is correct to the nearest 5 kg, so half of 5 kg is 2.5 kg, and the true mass, m kg, satisfies 847.5 ≤ m < 852.5. Part of that interval lies above 850 kg, so the parcels are not definitely within the limit. Answer: the true mass could be as high as 852.5 kg, which is above the limit. ("Yes, the display reads 850 kg, which is not above the limit" compares the limit with the displayed value instead of with the largest value the true mass could take. "Yes, the true mass is at least 847.5 kg and at most 850 kg" uses the correct half unit below but caps the interval at the limit instead of at 852.5 kg. "No, 850 kg on the display rounds up to 855 kg" wrongly treats the displayed value as if it rounds again.)
- (c) 12.44 — The error intervals are 155.5 ≤ mass < 156.5 and 11.5 ≤ volume < 12.5. To make a quotient as small as possible, use the SMALLEST possible numerator together with the LARGEST possible denominator: 155.5 ÷ 12.5 = 12.44 g/cm³. Using the lower bound for both mass and volume, 155.5 ÷ 11.5 ≈ 13.52, forgets that dividing by a smaller number makes the result bigger, not smaller — that pairing does not give a minimum at all. Dividing the two given rounded values directly, 156 ÷ 12 = 13, ignores that both measurements have their own error interval. Using the upper bound of mass with the upper bound of volume, 156.5 ÷ 12.5 = 12.52, takes both bounds the same way round; it is neither the minimum nor the maximum, since the maximum needs the largest mass with the smallest volume, 156.5 ÷ 11.5 ≈ 13.61.
- (b) 93.9975 — Each measurement was rounded to 1 decimal place, so the error is half of 0.1: length is 12.35 ≤ L < 12.45, and width is 7.45 ≤ W < 7.55. The upper bound for the area comes from multiplying the upper bounds of both dimensions: 12.45 × 7.55 = 93.9975 m². Using the lower bound of both dimensions instead, 12.35 × 7.45 = 92.0075 m², gives the lower bound of the area rather than the upper one. Multiplying the two given rounded values directly, 12.4 × 7.5 = 93, forgets that a rounded measurement is not exact and needs its own error interval. Bounding only the length and leaving the width at its given value, 12.45 × 7.5 = 93.375, misses that the width also has an upper bound of its own.
- (a) The tape can only give the length to the nearest centimetre — Method: a measurement should never be written to a finer degree of accuracy than the instrument used can read. Working: the tape is marked in centimetres, so the smallest division Leah can read is 1 cm, which is 0.01 m and two decimal places in metres; writing 7.3157 m claims the length to the nearest tenth of a millimetre, four decimal places, which the markings cannot support. A record of 7.32 m, to the nearest centimetre, is what this tape justifies. Answer: The tape can only give the length to the nearest centimetre. The distractors: the nearest millimetre contradicts the markings described in the question, which are centimetres, and would still claim more accuracy than the tape offers; the rule that a length in metres must be written to 2 decimal places borrows the habit of writing money to the penny, when the accuracy of a length depends on the instrument; rounding to the nearest metre would throw away accuracy the tape genuinely provides.
- (d) 50 km/h — The error intervals are 99.5 ≤ distance < 100.5 and 1.95 ≤ time < 2.05. The minimum speed is 99.5 ÷ 2.05 ≈ 48.54 km/h, and the maximum speed is 100.5 ÷ 1.95 ≈ 51.54 km/h. These two bounds round to different whole numbers, 49 and 52, so the speed cannot be guaranteed to the nearest whole number — but every value between them rounds to 50 at the nearest 10, so 50 km/h is the value that can safely be guaranteed. Quoting 49 km/h uses only the minimum bound's rounding, without checking that the maximum bound rounds to something different. Quoting 52 km/h makes the same mistake using only the maximum bound instead. Quoting 48.54 km/h states one bound to the full accuracy a calculator shows, as if the smallest possible speed were the answer, when the true speed could be anything up to 51.54 km/h.
- (a) 33.5 mph — Method: the smallest possible actual value is half the rounding unit below the given value. Working: half of 1 mph is 0.5 mph, so the smallest possible speed is 34 − 0.5 = 33.5 mph. Answer: 33.5 mph. (33 mph comes from subtracting the whole rounding unit, 1, instead of half of it. 34 mph comes from giving the rounded value itself rather than the lower bound. 34.5 mph comes from adding the half unit instead of subtracting it, giving the upper bound.)
- (b) 23 kg — Method: the rounded value sits exactly in the middle of the error interval. Working: the interval 22.5 ≤ m < 23.5 stretches 0.5 either side of the rounded value, so the rounded value is 23. Answer: 23 kg. (22 kg comes from rounding the lower bound down instead of finding the middle of the interval. 22.5 kg comes from giving the lower bound itself rather than the rounded value. 23.5 kg comes from giving the upper bound itself rather than the rounded value.)
- (a) 33.2 — The radius was rounded to 1 decimal place, so its error interval is 3.15 ≤ r < 3.25. The upper bound for the area uses the upper bound of the radius, squared: area = π × 3.25² ≈ 33.183, which rounds to 33.2 m² (3 s.f.). Using the given value of the radius directly instead of its upper bound, π × 3.2² ≈ 32.2, ignores that the radius itself has a range of possible values. Bounding the radius correctly but forgetting to square it, using area = π × 3.25 ≈ 10.2 instead of π × 3.25², drops the whole squaring step from the area formula. Using the LOWER bound of the radius instead of the upper one, π × 3.15² ≈ 31.2, finds the lower bound of the area, not the upper one.
Build your own mix at the worksheet builder.