Printable · GCSE Higher · ages 14-16
Limits of accuracy and bounds worksheet — GCSE Higher
Fifteen questions on "limits of accuracy and bounds" — DfE statement N16. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
part Higher
Answer key: Limits of accuracy and bounds worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 18 — The error intervals are 35 ≤ distance < 45 and 2.5 ≤ time < 3.5. Average speed is distance ÷ time, and to make a quotient as large as possible you divide the largest possible numerator by the SMALLEST possible denominator: 45 ÷ 2.5 = 18 km/h. Using the upper bound of time as well as the upper bound of distance, 45 ÷ 3.5, gives roughly 12.9 km/h — dividing by a bigger number produces a smaller result, so this actually finds a value smaller than the true maximum. Using the lower bound of distance with the lower bound of time, 35 ÷ 2.5 = 14, mixes up which bound belongs to a maximum calculation. Using the lower bound of distance with the upper bound of time, 35 ÷ 3.5 = 10, is in fact the correct method for the MINIMUM speed, not the maximum.
- (b) No, the true mass could be as high as 852.5 kg — Method: find the upper bound of the true mass and compare it with the weight limit. Working: the display is correct to the nearest 5 kg, so half of 5 kg is 2.5 kg, and the true mass, m kg, satisfies 847.5 ≤ m < 852.5. Part of that interval lies above 850 kg, so the parcels are not definitely within the limit. Answer: the true mass could be as high as 852.5 kg, which is above the limit. ("Yes, the display reads 850 kg, which is not above the limit" compares the limit with the displayed value instead of with the largest value the true mass could take. "Yes, the true mass is at least 847.5 kg and at most 850 kg" uses the correct half unit below but caps the interval at the limit instead of at 852.5 kg. "No, 850 kg on the display rounds up to 855 kg" wrongly treats the displayed value as if it rounds again.)
- (b) 20 — Each length has its own error interval: 11.5 ≤ a < 12.5 and 6.5 ≤ b < 7.5. The upper bound of a sum is found by adding the upper bounds of both quantities: 12.5 + 7.5 = 20. Bounding only one of the two lengths and adding the other quantity's given value unbounded, 12.5 + 7 = 19.5, misses that both measurements carry their own uncertainty. Adding the lower bounds instead of the upper bounds, 11.5 + 6.5 = 18, gives the lower bound of the sum, not the upper one. Using a whole centimetre of error either side instead of half a centimetre, (12 + 1) + (7 + 1) = 21, comes from forgetting the error is half the rounding unit.
- (b) 14.5 ≤ l < 15.5 — A measurement given to the nearest metre could have been rounded from anywhere up to half a metre below or above it: 15 − 0.5 = 14.5 and 15 + 0.5 = 15.5. Every value from 14.5 up to (but not reaching) 15.5 rounds to 15, so the error interval is 14.5 ≤ l < 15.5, with the lower bound included and the upper bound excluded. Making both ends strict, 14.5 < l < 15.5, wrongly excludes 14.5 itself, even though 14.5 does round to 15. Making both ends inclusive, 14.5 ≤ l ≤ 15.5, wrongly includes 15.5, which actually rounds up to 16, not 15. Using a whole metre either side instead of half a metre, giving 14 ≤ l < 16, comes from forgetting that the error is only half the rounding unit.
- (c) Yes — the greatest possible total is 493.5 kg, under 500 kg — 493 kg correct to the nearest kg means the true total mass, m, satisfies 492.5 kg ≤ m < 493.5 kg. The greatest possible total is 493.5 kg, which is under the 500 kg safe working load, so the four people are definitely within it. 'The true total could be as high as 498 kg' comes from treating 'nearest kg' as an error of ±5 kg instead of ±0.5 kg. 'Cannot be decided without the exact total' overlooks that the error interval already gives the greatest possible total, so the decision can be made without knowing the exact figure. '493 kg is only an estimate, so it may be over 500 kg' ignores that the error interval is bounded — the true total cannot exceed 493.5 kg, well under 500 kg.
- (a) the nearest whole number — The error intervals are 23.5 ≤ p < 24.5 and 5.5 ≤ q < 6.5. The minimum of p ÷ q is 23.5 ÷ 6.5 ≈ 3.615, and the maximum is 24.5 ÷ 5.5 ≈ 4.455. Both of these round to 4 at the nearest whole number, so the answer is guaranteed correct to the nearest whole number — but not to the nearest 0.1, since 3.615 rounds to 3.6 while 4.455 rounds to 4.5, which do not agree. Claiming the nearest 0.1 assumes every figure a calculator shows is trustworthy, without checking whether the bounds actually agree that far. Claiming only the nearest 10 badly understates how much can be guaranteed here, since both bounds already round to 4, not merely to 0. Saying no degree of accuracy can be guaranteed gives up before checking whether the bounds agree at any level at all.
- (b) No — their possible jump lengths do not overlap — Method: each recorded jump stands for the lengths within half of 0.1 m, that is 0.05 m, of the figure recorded, and Priya is right only if the two ranges overlap. Working: Priya's jump is at least 3.8 − 0.05 = 3.75 m and below 3.85 m, because a jump of 3.85 m would have been recorded as 3.9 m; Nadia's jump is at least 3.85 m and below 3.9 + 0.05 = 3.95 m. Every length Priya could have jumped is below 3.85 m and every length Nadia could have jumped is at least 3.85 m, so Nadia jumped further whatever the exact lengths were. Answer: No — their possible jump lengths do not overlap. The distractors: the reason that a recorded jump is exactly the length jumped reaches the same verdict by treating a rounded record as exact, which is the idea this question tests; both jumps being 3.85 m would put 3.85 m inside Priya's range, when a jump of that length is recorded as 3.9 m; Priya jumping up to 3.9 m goes a whole 0.1 m above her record instead of half of it.
- (b) 18.5 ≤ T < 18.7 — Method: the error interval reaches half the rounding unit either side of the recorded value. Working: half of 0.2 is 0.1, so the interval runs from 18.6 − 0.1 to 18.6 + 0.1. Answer: 18.5 ≤ T < 18.7. (18.4 ≤ T < 18.8 comes from using the full rounding unit, 0.2, either side instead of half of it. 18.5 ≤ T ≤ 18.7 comes from including the upper bound with ≤ instead of excluding it with <. 18.6 ≤ T < 18.8 comes from treating the recorded value as the start of the interval and adding the whole rounding unit, 0.2, above it.)
- (a) 37.5 — The error intervals are 45 ≤ c < 55 and 17.5 ≤ d < 18.5. The maximum possible value of a difference comes from the largest possible value being reduced by the smallest amount: use the upper bound of c together with the LOWER bound of d, since subtracting less gives a bigger result: 55 − 17.5 = 37.5. Using the upper bound for both quantities, 55 − 18.5 = 36.5, forgets that subtracting a bigger number gives a smaller answer, not a bigger one. Using the lower bounds for both, 45 − 17.5 = 27.5, gives the lower bound of the difference instead of the upper one. Using the lower bound of c with the upper bound of d, 45 − 18.5 = 26.5, combines the two bounds the wrong way round entirely.
- (b) 93.9975 — Each measurement was rounded to 1 decimal place, so the error is half of 0.1: length is 12.35 ≤ L < 12.45, and width is 7.45 ≤ W < 7.55. The upper bound for the area comes from multiplying the upper bounds of both dimensions: 12.45 × 7.55 = 93.9975 m². Using the lower bound of both dimensions instead, 12.35 × 7.45 = 92.0075 m², gives the lower bound of the area rather than the upper one. Multiplying the two given rounded values directly, 12.4 × 7.5 = 93, forgets that a rounded measurement is not exact and needs its own error interval. Bounding only the length and leaving the width at its given value, 12.45 × 7.5 = 93.375, misses that the width also has an upper bound of its own.
- (a) The tape can only give the length to the nearest centimetre — Method: a measurement should never be written to a finer degree of accuracy than the instrument used can read. Working: the tape is marked in centimetres, so the smallest division Leah can read is 1 cm, which is 0.01 m and two decimal places in metres; writing 7.3157 m claims the length to the nearest tenth of a millimetre, four decimal places, which the markings cannot support. A record of 7.32 m, to the nearest centimetre, is what this tape justifies. Answer: The tape can only give the length to the nearest centimetre. The distractors: the nearest millimetre contradicts the markings described in the question, which are centimetres, and would still claim more accuracy than the tape offers; the rule that a length in metres must be written to 2 decimal places borrows the habit of writing money to the penny, when the accuracy of a length depends on the instrument; rounding to the nearest metre would throw away accuracy the tape genuinely provides.
- (b) 23 kg — Method: the rounded value sits exactly in the middle of the error interval. Working: the interval 22.5 ≤ m < 23.5 stretches 0.5 either side of the rounded value, so the rounded value is 23. Answer: 23 kg. (22 kg comes from rounding the lower bound down instead of finding the middle of the interval. 22.5 kg comes from giving the lower bound itself rather than the rounded value. 23.5 kg comes from giving the upper bound itself rather than the rounded value.)
- (b) Yes, because 14.8 cm rounds to 15 cm to the nearest cm — Method: a recorded measurement is not an exact length; it stands for every length that rounds to it, so the two records agree if one rod can produce both. Working: Ben's record of 14.8 cm to the nearest 0.1 cm means the rod is between 14.75 cm and 14.85 cm, and 14.8 is nearer to 15 than to 14, so a rod of that length is recorded as 15 cm to the nearest centimetre. Both records can therefore come from the same rod. Answer: Yes, because 14.8 cm rounds to 15 cm to the nearest cm. The distractors: the claim that 14.8 cm rounds to 15.0 cm to 1 decimal place is false, since 14.8 cm is already written to 1 decimal place and stays 14.8 cm; the claim that it rounds to 14 cm is false, because 14.8 is 0.2 away from 15 and 0.8 away from 14; the claim that the two lengths are not the same treats each record as an exact length, when each is only a rounded record of one rod.
- (c) 12.44 — The error intervals are 155.5 ≤ mass < 156.5 and 11.5 ≤ volume < 12.5. To make a quotient as small as possible, use the SMALLEST possible numerator together with the LARGEST possible denominator: 155.5 ÷ 12.5 = 12.44 g/cm³. Using the lower bound for both mass and volume, 155.5 ÷ 11.5 ≈ 13.52, forgets that dividing by a smaller number makes the result bigger, not smaller — that pairing does not give a minimum at all. Dividing the two given rounded values directly, 156 ÷ 12 = 13, ignores that both measurements have their own error interval. Using the upper bound of mass with the upper bound of volume, 156.5 ÷ 12.5 = 12.52, takes both bounds the same way round; it is neither the minimum nor the maximum, since the maximum needs the largest mass with the smallest volume, 156.5 ÷ 11.5 ≈ 13.61.
- (b) Yes — the actual mass could be as low as 995 g — Method: a mass shown to the nearest 10 g lies within half of 10 g, that is 5 g, of the figure on the display, so compare the smallest mass the bag can have with the checker's limit of 996 g. Working: 1,000 − 5 = 995, so the actual mass of the bag can be as low as 995 g, and 995 g is below the 996 g limit, so a bag showing 1,000 g on the machine can still be rejected. Answer: Yes — the actual mass could be as low as 995 g. The distractors: 990 g comes from going a whole 10 g below the display instead of half of it; 999.5 g comes from treating the display as being to the nearest gram, when it is to the nearest 10 g; the claim that the mass is exactly 1,000 g treats a rounded display as an exact measurement.
Build your own mix at the worksheet builder.