Printable · GCSE Higher · ages 14-16
Limits of accuracy and bounds worksheet — GCSE Higher
Fifteen questions on "limits of accuracy and bounds" — DfE statement N16. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
part Higher
Answer key: Limits of accuracy and bounds worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 62.35 ≤ r < 62.45 — Method: with a value rounded to 1 decimal place, the error interval reaches half of 0.1 either side. Working: half of 0.1 is 0.05, so the interval runs from 62.4 − 0.05 to 62.4 + 0.05. Answer: 62.35 ≤ r < 62.45. (62 ≤ r < 63 comes from rounding to the nearest whole number instead of 1 decimal place. 62.35 ≤ r ≤ 62.45 comes from including the upper bound with ≤ instead of excluding it with <. 62.3 ≤ r < 62.5 comes from using 0.1 either side instead of half of it.)
- (a) 37.5 — The error intervals are 45 ≤ c < 55 and 17.5 ≤ d < 18.5. The maximum possible value of a difference comes from the largest possible value being reduced by the smallest amount: use the upper bound of c together with the LOWER bound of d, since subtracting less gives a bigger result: 55 − 17.5 = 37.5. Using the upper bound for both quantities, 55 − 18.5 = 36.5, forgets that subtracting a bigger number gives a smaller answer, not a bigger one. Using the lower bounds for both, 45 − 17.5 = 27.5, gives the lower bound of the difference instead of the upper one. Using the lower bound of c with the upper bound of d, 45 − 18.5 = 26.5, combines the two bounds the wrong way round entirely.
- (a) 33.5 mph — Method: the smallest possible actual value is half the rounding unit below the given value. Working: half of 1 mph is 0.5 mph, so the smallest possible speed is 34 − 0.5 = 33.5 mph. Answer: 33.5 mph. (33 mph comes from subtracting the whole rounding unit, 1, instead of half of it. 34 mph comes from giving the rounded value itself rather than the lower bound. 34.5 mph comes from adding the half unit instead of subtracting it, giving the upper bound.)
- (c) 12.44 — The error intervals are 155.5 ≤ mass < 156.5 and 11.5 ≤ volume < 12.5. To make a quotient as small as possible, use the SMALLEST possible numerator together with the LARGEST possible denominator: 155.5 ÷ 12.5 = 12.44 g/cm³. Using the lower bound for both mass and volume, 155.5 ÷ 11.5 ≈ 13.52, forgets that dividing by a smaller number makes the result bigger, not smaller — that pairing does not give a minimum at all. Dividing the two given rounded values directly, 156 ÷ 12 = 13, ignores that both measurements have their own error interval. Using the upper bound of mass with the upper bound of volume, 156.5 ÷ 12.5 = 12.52, takes both bounds the same way round; it is neither the minimum nor the maximum, since the maximum needs the largest mass with the smallest volume, 156.5 ÷ 11.5 ≈ 13.61.
- (b) Yes, because 14.8 cm rounds to 15 cm to the nearest cm — Method: a recorded measurement is not an exact length; it stands for every length that rounds to it, so the two records agree if one rod can produce both. Working: Ben's record of 14.8 cm to the nearest 0.1 cm means the rod is between 14.75 cm and 14.85 cm, and 14.8 is nearer to 15 than to 14, so a rod of that length is recorded as 15 cm to the nearest centimetre. Both records can therefore come from the same rod. Answer: Yes, because 14.8 cm rounds to 15 cm to the nearest cm. The distractors: the claim that 14.8 cm rounds to 15.0 cm to 1 decimal place is false, since 14.8 cm is already written to 1 decimal place and stays 14.8 cm; the claim that it rounds to 14 cm is false, because 14.8 is 0.2 away from 15 and 0.8 away from 14; the claim that the two lengths are not the same treats each record as an exact length, when each is only a rounded record of one rod.
- (a) 33.2 — The radius was rounded to 1 decimal place, so its error interval is 3.15 ≤ r < 3.25. The upper bound for the area uses the upper bound of the radius, squared: area = π × 3.25² ≈ 33.183, which rounds to 33.2 m² (3 s.f.). Using the given value of the radius directly instead of its upper bound, π × 3.2² ≈ 32.2, ignores that the radius itself has a range of possible values. Bounding the radius correctly but forgetting to square it, using area = π × 3.25 ≈ 10.2 instead of π × 3.25², drops the whole squaring step from the area formula. Using the LOWER bound of the radius instead of the upper one, π × 3.15² ≈ 31.2, finds the lower bound of the area, not the upper one.
- (c) 23.375 — The error intervals are 7.5 ≤ base < 8.5 and 4.5 ≤ height < 5.5. The upper bound of the area uses the upper bound of both the base and the height, then halves the product: 8.5 × 5.5 ÷ 2 = 23.375 cm². Using the lower bound of both dimensions instead, 7.5 × 4.5 ÷ 2 = 16.875, gives the lower bound of the area rather than the upper one. Multiplying the two upper bounds together but forgetting to halve for the triangle formula, 8.5 × 5.5 = 46.750, treats the triangle as if it were a rectangle. Using the given values directly without applying any bound at all, 8 × 5 ÷ 2 = 20.000, ignores that each rounded measurement has its own range of possible values.
- (d) 50 km/h — The error intervals are 99.5 ≤ distance < 100.5 and 1.95 ≤ time < 2.05. The minimum speed is 99.5 ÷ 2.05 ≈ 48.54 km/h, and the maximum speed is 100.5 ÷ 1.95 ≈ 51.54 km/h. These two bounds round to different whole numbers, 49 and 52, so the speed cannot be guaranteed to the nearest whole number — but every value between them rounds to 50 at the nearest 10, so 50 km/h is the value that can safely be guaranteed. Quoting 49 km/h uses only the minimum bound's rounding, without checking that the maximum bound rounds to something different. Quoting 52 km/h makes the same mistake using only the maximum bound instead. Quoting 48.54 km/h states one bound to the full accuracy a calculator shows, as if the smallest possible speed were the answer, when the true speed could be anything up to 51.54 km/h.
- (b) 20 — Each length has its own error interval: 11.5 ≤ a < 12.5 and 6.5 ≤ b < 7.5. The upper bound of a sum is found by adding the upper bounds of both quantities: 12.5 + 7.5 = 20. Bounding only one of the two lengths and adding the other quantity's given value unbounded, 12.5 + 7 = 19.5, misses that both measurements carry their own uncertainty. Adding the lower bounds instead of the upper bounds, 11.5 + 6.5 = 18, gives the lower bound of the sum, not the upper one. Using a whole centimetre of error either side instead of half a centimetre, (12 + 1) + (7 + 1) = 21, comes from forgetting the error is half the rounding unit.
- (c) 18 — The error intervals are 35 ≤ distance < 45 and 2.5 ≤ time < 3.5. Average speed is distance ÷ time, and to make a quotient as large as possible you divide the largest possible numerator by the SMALLEST possible denominator: 45 ÷ 2.5 = 18 km/h. Using the upper bound of time as well as the upper bound of distance, 45 ÷ 3.5, gives roughly 12.9 km/h — dividing by a bigger number produces a smaller result, so this actually finds a value smaller than the true maximum. Using the lower bound of distance with the lower bound of time, 35 ÷ 2.5 = 14, mixes up which bound belongs to a maximum calculation. Using the lower bound of distance with the upper bound of time, 35 ÷ 3.5 = 10, is in fact the correct method for the MINIMUM speed, not the maximum.
- (a) 1,850 — Method: find the error interval, then check which value falls outside it. Working: half of 100 is 50, so the actual number of visitors, v, satisfies 1,750 ≤ v < 1,850. 1,850 sits exactly on the excluded upper boundary, since a value of 1,850 would round to 1,900, not 1,800. Answer: 1,850. (1,750 is a genuine possible value — it sits at the included lower boundary. 1,799 is a genuine possible value, just below the upper boundary. 1,760 is a genuine possible value, well inside the interval.)
- (c) Yes — the greatest possible total is 493.5 kg, under 500 kg — 493 kg correct to the nearest kg means the true total mass, m, satisfies 492.5 kg ≤ m < 493.5 kg. The greatest possible total is 493.5 kg, which is under the 500 kg safe working load, so the four people are definitely within it. 'The true total could be as high as 498 kg' comes from treating 'nearest kg' as an error of ±5 kg instead of ±0.5 kg. 'Cannot be decided without the exact total' overlooks that the error interval already gives the greatest possible total, so the decision can be made without knowing the exact figure. '493 kg is only an estimate, so it may be over 500 kg' ignores that the error interval is bounded — the true total cannot exceed 493.5 kg, well under 500 kg.
- (d) £4.80 — Method: find the error interval, then check which value falls outside it. Working: half of 20p is 10p, so the actual cost, c, satisfies £4.50 ≤ c < £4.70. £4.80 is above £4.70, so it could not be the actual cost. Answer: £4.80. (£4.50 is a genuine possible cost — it sits at the included lower boundary. £4.65 is a genuine possible cost, below the £4.70 upper boundary. £4.55 is a genuine possible cost, well inside the interval.)
- (b) 1.45 ≤ m < 1.55 — The flour's mass is labelled 1.5 kg, correct to the nearest 0.1 kg, so half of 0.1 kg is added to and subtracted from 1.5 kg to find the interval: 1.5 − 0.05 = 1.45 and 1.5 + 0.05 = 1.55, giving 1.45 ≤ m < 1.55. '1.4 ≤ m < 1.6' comes from taking the whole 0.1 kg as the margin either side, instead of half of it. '1.45 < m ≤ 1.55' comes from writing the inequality signs the wrong way round — the lower bound should be included and the upper bound excluded, not the other way round. '1.45 ≤ m ≤ 1.55' comes from including the upper bound, when the convention is that the upper bound is never actually reached.
- (b) 93.9975 — Each measurement was rounded to 1 decimal place, so the error is half of 0.1: length is 12.35 ≤ L < 12.45, and width is 7.45 ≤ W < 7.55. The upper bound for the area comes from multiplying the upper bounds of both dimensions: 12.45 × 7.55 = 93.9975 m². Using the lower bound of both dimensions instead, 12.35 × 7.45 = 92.0075 m², gives the lower bound of the area rather than the upper one. Multiplying the two given rounded values directly, 12.4 × 7.5 = 93, forgets that a rounded measurement is not exact and needs its own error interval. Bounding only the length and leaving the width at its given value, 12.45 × 7.5 = 93.375, misses that the width also has an upper bound of its own.
Build your own mix at the worksheet builder.