Printable · GCSE Higher · ages 14-16
Fractions and decimals, including recurring decimals worksheet — GCSE Higher
Fifteen questions on "fractions and decimals, including recurring decimals" — DfE statement N10. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
part HigherNon-calculator
Answer key: Fractions and decimals, including recurring decimals worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 0.83333... — Divide 5 by 6 using long division. 5.000... ÷ 6: 50 ÷ 6 = 8 remainder 2, giving the first decimal digit 8. Bring down a 0 to make 20, and 20 ÷ 6 = 3 remainder 2 — the remainder 2 has reappeared, so from here the digit 3 repeats forever. This gives 5/6 = 0.83333... . Stopping after two decimal places and writing 0.83 treats the division as if it terminated, when the remainder never reaches zero. Shifting the decimal point one place too far to the left gives 0.083333..., the same digits divided by an extra power of ten. A slip in the long division itself, misreading a remainder, can produce the wrong repeating digit, 0.85555... .
- (a) 13/40 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.325 = 325/1000 = 13/40 (dividing both numerator and denominator by 25). Answer: 13/40. 13/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 8/25 comes from rounding 0.325 down to 0.32 before converting. 3/8 comes from recalling the learned conversion 3/8 = 0.375 and matching it to 0.325 because both are three-place decimals beginning with 3, instead of converting the decimal given.
- (c) Exactly 1: the subtraction has no rounding at any step. — 10x − x removes the recurring part completely, because the digits after the decimal point in 10x and in x are identical from the tenths place onward, so they cancel exactly: 9.999... − 0.999... = 9.000... = 9. Nothing was rounded to reach 9x = 9, so x = 1 is an exact equality, not an approximation, and the statement that the value is exactly 1, with no rounding at any step, is the correct one. Calling it only approximately 1, on the ground that a recurring decimal can never reach a whole number, misunderstands what the subtraction has just shown: the recurring tail cancels completely, leaving no gap to approximate away. Claiming the method only works because the recurring digit is 9 is also wrong — the same subtraction cancels the recurring part for any repeating digit, not just 9; it is the choice of multiplier (10, matching the one-digit repeat) that makes the cancellation exact, not the digit itself. Saying 10x minus x gives 8.999... rather than 9 misreads the subtraction: 9.999... − 0.999... has no digit to borrow from, since every decimal digit in the two numbers matches, so the result is exactly 9, not 8.999... .
- (d) 2/25 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.08 = 8/100 = 2/25 (dividing both numerator and denominator by 4). Answer: 2/25. The student's fraction, 8/10, comes from ignoring the zero in the tenths column and reading 0.08 as though it were 0.8; it simplifies to 4/5. 1/125 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places. 25/2 comes from flipping the correct fraction upside down.
- (c) 0.7, 0.72, 3/4 — Method: numbers written in different forms cannot be compared as they stand, so every fraction is turned into a decimal by dividing the numerator by the denominator, and the decimals are then compared place by place from the left. Working: 3/4 means 3 ÷ 4 = 0.75, so the three values to compare are 0.7, 0.75 and 0.72; written to two decimal places they are 0.70, 0.75 and 0.72, and the hundredths digits 0, 5 and 2 put 0.70 first, 0.72 next and 0.75 last; written again in the forms the question used, the order from smallest is 0.7, then 0.72, then 3/4. Answer: 0.7, 0.72, 3/4. The distractors: 3/4, 0.7, 0.72 comes from turning 3/4 into 0.34 by writing the numerator and the denominator as the two digits after the point, which makes the fraction the smallest of the three; 0.72, 3/4, 0.7 comes from the belief that the more digits a decimal has the smaller it must be, which puts both 0.72 and 0.75 below 0.7 and 0.72 below 0.75; 3/4, 0.72, 0.7 comes from comparing the three values correctly but listing them largest first, against an instruction to start with the smallest.
- (a) 2/11 — Let x = 0.18 recurring, so x = 0.181818... . Since two digits repeat, multiply by 100: 100x = 18.181818... . Subtracting the original x removes the recurring part, because the digits line up exactly: 100x − x = 18.181818... − 0.181818... = 18, so 99x = 18, giving x = 18/99 = 2/11. Treating the decimal as if it terminated at two places gives 18/100 = 9/50, which is only 0.18 and drops the repeating part entirely. Subtracting 10x instead of x — using 100x − 10x = 90x = 18 — is the wrong power of ten for a two-digit repeating block, and gives x = 18/90 = 1/5. Making an arithmetic slip in the numerator, 18 − 1 = 17 instead of 18, gives 17/99.
- (a) 0.625 — Method: convert the fraction to a decimal so it can be compared properly with 0.6. Working: 5/8 = 0.625, and since 0.625 > 0.6, the larger value is 0.625. Answer: 0.625. 0.6 repeats Sam's incorrect claim, made by comparing single digits rather than full place value. 0.58 comes from converting 5/8 incorrectly, treating it as if it read 5 tenths and 8 hundredths. 0.85 comes from turning the fraction upside down and writing its digits straight after the decimal point, 8 then 5, instead of dividing.
- (a) 7/8 — Method: write the decimal over the power of ten that matches the number of digits after the point, then divide the numerator and the denominator by their highest common factor. Working: 0.875 has three digits after the point, so it is 875 thousandths and can be written as 875/1000; the highest common factor of 875 and 1000 is 125, and 875 ÷ 125 = 7 with 1000 ÷ 125 = 8. Answer: 7/8. The distractors: 8/7 comes from cancelling correctly but writing the two parts the wrong way round; 9/10 comes from rounding 0.875 to one decimal place as 0.9 before converting; 7/80 comes from counting four decimal places instead of three and using a denominator of 10000, giving 875/10000.
- (c) 3/11 — Method: let a letter stand for the recurring decimal, multiply by the power of ten that shifts exactly one repeating block past the point, subtract the original equation so that the recurring tail cancels, then solve and cancel. Working: let x = 0.272727...; the repeating block is two digits long, so multiply by 100 to give 100x = 27.272727...; subtracting gives 99x = 27, so x = 27/99; the highest common factor of 27 and 99 is 9, and 27 ÷ 9 = 3 with 99 ÷ 9 = 11. Answer: 3/11. The distractors: 27/100 comes from writing the repeating block over 100 instead of over 99, forgetting that subtracting x leaves 99x rather than 100x; 3/10 comes from rounding the decimal to one place and converting 0.3; 2/9 comes from treating only the 2 as recurring and converting 0.222... instead.
- (c) 5/8 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.625 = 625/1000 = 5/8 (dividing both numerator and denominator by 125). Answer: 5/8. 25/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 31/50 comes from rounding 0.625 to 0.62 before converting. 8/5 comes from simplifying correctly to 5/8 and then writing the fraction upside down.
- (b) 0.58333... — Divide 7 by 12 using long division. 70 ÷ 12 = 5 remainder 10, so the first decimal digit is 5. Bring down a 0 to make 100: 100 ÷ 12 = 8 remainder 4, so the second digit is 8. Bring down a 0 to make 40: 40 ÷ 12 = 3 remainder 4, so the third digit is 3. Bring down a 0 to make 40 again — the remainder 4 has reappeared, so the digit 3 repeats forever from here. This gives 7/12 = 0.58333... . Stopping the division after two digits and writing 0.58 treats it as if it terminated, when the remainder is not yet zero. Misreading the pattern as a two-digit repeating block, '58', gives 0.585858..., which wrongly makes the 5 recur as well as the 3. A slip in the long division that carries the wrong remainder forward can make the second digit itself appear to repeat instead of the third, giving 0.588888... .
- (b) 3/50 — Method: write the decimal over the power of ten that matches the number of digits after the point, counting every digit including a zero, then divide the numerator and the denominator by their highest common factor. Working: 0.06 has two digits after the point, so it is 6 hundredths and can be written as 6/100; the highest common factor of 6 and 100 is 2, and 6 ÷ 2 = 3 with 100 ÷ 2 = 50. Answer: 3/50. The distractors: 3/5 comes from ignoring the zero straight after the point and converting 0.6 instead, giving 6/10, which cancels to 3/5; 3/500 comes from counting three decimal places instead of two and writing 6/1000, which cancels to 3/500; 1/6 comes from putting 1 over the digits after the point, as though 0.06 meant one sixth.
- (c) 9/5 — Method: the area of a rectangle is its length multiplied by its width; the decimal product is then written over a power of ten and cancelled. Working: 24 × 75 = 1800, and 2.4 and 0.75 have three decimal places between them, so 2.4 × 0.75 = 1.8; the area of the panel is 1.8 square metres, which is eighteen tenths, so it can be written as 18/10, and dividing the numerator and the denominator by 2 gives 9 over 5. Answer: 9/5. The distractors: 4/5 comes from converting only the digits after the decimal point and losing the whole one, turning 1.8 into eight tenths; 63/20 comes from adding the two sides instead of multiplying them, giving 3.15; 9/50 comes from misplacing the decimal point in the product and writing 0.18, which cancels to 9 over 50.
- (c) 5/11 — Let x = 0.45 recurring, so x = 0.454545... . Since two digits repeat, multiply by 100: 100x = 45.454545... . Subtracting the original x removes the recurring part exactly, because it lines up digit for digit: 100x − x = 45.454545... − 0.454545... = 45, so 99x = 45, giving x = 45/99 = 5/11. Treating the decimal as if it terminated at two places gives 45/100 = 9/20, which is only 0.45 and drops the repeating part entirely. Subtracting 10x instead of x — using 100x − 10x = 90x = 45 — is the wrong power of ten for a two-digit repeating block, and gives x = 45/90 = 1/2. Making an arithmetic slip in the numerator, 45 − 1 = 44 instead of 45, gives 44/99 = 4/9.
- (c) 7/30 — Let x = 0.2333... . Because only the 3 recurs, use two multiples of x that line up the recurring part exactly: 10x = 2.333... and 100x = 23.333... . Subtracting removes the recurring tail completely: 100x − 10x = 23.333... − 2.333... = 21, so 90x = 21, giving x = 21/90 = 7/30. Treating the decimal as if it terminated after two places, writing 0.23 as 23/100, ignores that the 3 carries on forever. Misreading which digits recur — treating 0.2333... as if the block '23' repeated, giving 0.232323... — leads to x = 23/99, which is a different, larger recurring decimal from the one given. A numerator slip in the subtraction, computing 22 instead of 21, gives x = 22/90 = 11/45.
Build your own mix at the worksheet builder.