Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A café sells ice cream in three flavours: vanilla, mango and pistachio. Isla buys a cone with two scoops, using two different flavours, one for the bottom scoop and one for the top scoop. Work out how many different cones she could buy.
- 2.Two fair six-sided dice are rolled together. One die is red and the other is blue. Work out how many different outcomes are possible.
- 3.A fabric is dyed blue and yellow in the ratio 3 : 5. A tailor uses 1.5 m of blue fabric and the matching amount of yellow fabric needed for the ratio. Work out the total length of fabric used.
- 4.Work out the value of √49 + ∛27
- 5.Work out how many factors 100 has.
- 6.Four friends share a restaurant bill of £53.90 equally. A calculator gives each share as 13.475. Work out how much each friend should pay.
- 7.Work out the value of 6² − 4³.
- 8.Grace works out 7 × 99 by writing 99 as 100 − 1. Use her method to work out 7 × 99.
- 9.Which of these is written correctly in standard form?
- 10.A student works out the exact area of a circle with radius 4 cm by squaring the radius but forgetting to multiply by π. Work out the correct exact area of the circle, in terms of π.
- 11.Work out the reciprocal of (2 + 3)
- 12.A length, L cm, has the error interval 24.5 ≤ L < 25.5. Write down the degree of accuracy to which the length was measured.
- 13.Without using a calculator, estimate √20 × √12, giving your answer to the nearest whole number.
- 14.On a number line, point A is at −1. Point B is 4 units from point A. Write down the two possible positions of point B.
- 15.A digital timer truncates every time to 1 decimal place. It shows a swimmer's time for one length as 12.3 seconds. Using t for the swimmer's actual time in seconds, write down the error interval for t.
Answer key
- (a) 6 — Method: the two scoops sit in different places on the cone, so a cone is an ordered choice; the possibilities can be listed systematically or counted by multiplying the choices available at each stage. Working: there are 3 flavours for the bottom scoop, and once that flavour is used only 2 flavours remain for the top scoop, so there are 3 × 2 = 6 cones; listing them confirms this, since vanilla on the bottom allows mango or pistachio on top, mango on the bottom allows vanilla or pistachio, and pistachio on the bottom allows vanilla or mango. Answer: 6. The distractors: 3 comes from treating the two scoops as interchangeable, so that vanilla under mango and mango under vanilla are counted as one cone; 9 comes from allowing the same flavour to be used for both scoops, giving 3 × 3; 5 comes from adding the 3 choices for the bottom scoop to the 2 choices left for the top scoop instead of multiplying them.
- (c) 36 — Method: set the outcomes out in a grid with one die along the top and the other down the side, so that every cell of the grid is one outcome, and count the cells. Working: the red die can land in 6 ways, so the grid has 6 columns, and the blue die can also land in 6 ways, so the grid has 6 rows; the number of cells is 6 × 6 = 36. Answer: 36. The distractors: 12 comes from adding 6 and 6 instead of multiplying them; 6 comes from counting the outcomes of a single die and forgetting that the second die also has to land; 21 comes from treating the two dice as indistinguishable, so that a red 2 with a blue 3 and a red 3 with a blue 2 are counted as one outcome.
- (b) 4 m — Blue fabric is 3 parts and this equals 1.5 m, so one part is 1.5 ÷ 3 = 0.5 m. Yellow fabric is 5 parts, so it is 5 × 0.5 = 2.5 m. The total length is 1.5 + 2.5 = 4 m. 2.5 m is the length of yellow fabric only, without adding the blue fabric back in. 1.5 m is just the given length of blue fabric, with the yellow fabric never worked out. 2.4 m comes from swapping the ratio, treating blue as 5 parts and yellow as 3 parts, giving one part as 1.5 ÷ 5 = 0.3 m and yellow as 3 × 0.3 = 0.9 m, then adding 1.5 + 0.9 = 2.4.
- (a) 10 — √49 = 7 and ∛27 = 3, so √49 + ∛27 = 7 + 3 = 10. Treating the cube root as dividing by 3 instead of finding the cube root gives 27 ÷ 3 = 9, then 7 + 9 = 16. Multiplying the two roots instead of adding them gives 7 × 3 = 21. Ignoring the cube root symbol and using 27 as it stands gives 7 + 27 = 34.
- (c) 9 — Method: factors come in pairs that multiply to give the number, so work through the pairs in order; a factor paired with itself is counted only once. Working: the pairs are 1 × 100, 2 × 50, 4 × 25, 5 × 20 and 10 × 10. The first four pairs give eight different factors, and the last pair adds only one more, so the factors are 1, 2, 4, 5, 10, 20, 25, 50 and 100. Answer: 9. The distractors: 10 comes from counting the pair 10 × 10 as two separate factors; 8 comes from leaving 1 out of the list, on the view that 1 is not a proper factor; 4 comes from writing 100 = 2² × 5² and multiplying the two indices together instead of adding 1 to each index first.
- (b) £13.48 — Method: an amount of money is written to the nearest penny, which is 2 decimal places, so the calculator display has to be rounded to 2 decimal places. Working: 53.90 ÷ 4 = 13.475, and the digit in the third decimal place is 5, so the penny digit goes up from 7 to 8. Answer: £13.48. The distractors: £13.47 comes from chopping the third decimal place off instead of rounding with it; £13.50 comes from rounding to the nearest 10p rather than to the nearest penny; £13.40 comes from cutting the display short at 1 decimal place, which is both the wrong degree of accuracy and a truncation rather than a rounding.
- (c) −28 — 6² = 36 and 4³ = 64. Work out 36 − 64 = −28. A candidate who subtracts in the wrong order gets 64 − 36 = 28. A candidate who adds instead of subtracting gets 36 + 64 = 100. A candidate who multiplies the base by the exponent instead of raising the power (6 × 2 − 4 × 3 = 12 − 12) gets 0.
- (c) 693 — Method: multiplying a bracket by a number multiplies every term inside it, so 7 × (100 − 1) = 7 × 100 − 7 × 1. Working: 7 × 100 = 700 and 7 × 1 = 7, so the calculation becomes 700 − 7 = 693. Answer: 693. The distractors: 699 comes from subtracting the 1 itself rather than 7 lots of it, giving 700 − 1 = 699; 707 comes from adding the second product instead of subtracting it, giving 700 + 7 = 707; 700 comes from rounding 99 up to 100 and then offering the estimate 7 × 100 as an exact value.
- (a) 7.5 × 10⁴ — Standard form is A × 10ⁿ, where A is between 1 and 10 (1 ≤ A < 10) and n is an integer — 7.5 × 10⁴ satisfies all of this. 12 × 10³ fails because 12 is not below 10. 0.5 × 10⁴ fails because 0.5 is not at least 1. 6.2 × 4⁵ fails because standard form always uses a power of 10, not a power of 4.
- (d) 16π cm² — Method: for a circle, area = π × radius². Working: area = π × 4² = π × 16 = 16π cm². Answer: 16π cm². The student squared the radius but left out the π, which is why 16 cm² is not the exact area. 4π cm² comes from multiplying by the radius once instead of squaring it: π × 4 = 4π. 8π cm² comes from using the circumference formula 2 × π × radius instead of the area formula: 2 × π × 4 = 8π. 64π cm² comes from using the diameter (8 cm) as the radius in the area formula: π × 8² = 64π.
- (a) 1/5 — Work out the bracket first: 2 + 3 = 5. The reciprocal of 5 is 1/5. A candidate who forgot to take the reciprocal and just gave the value of the bracket wrote 5. A candidate who took the reciprocal but made a sign error wrote −1/5. A candidate who found the reciprocal of each number separately and added them, treating reciprocal as if it distributes over addition, worked out 1/2 + 1/3 = 5/6.
- (a) to the nearest centimetre — Method: the error interval of a rounded measurement runs from half a unit below the stated value to half a unit above it, so the width of the interval is one whole unit of the accuracy used. Working: the interval runs from 24.5 to 25.5, a width of 25.5 − 24.5 = 1, so the unit of accuracy is 1 cm; the stated value is the midpoint, 25 cm, and 25 correct to the nearest centimetre is exactly what gives 24.5 ≤ L < 25.5. Answer: to the nearest centimetre. To the nearest 0.5 cm comes from reading the half-unit, 0.5, as the accuracy itself instead of doubling it back to the full unit. To 1 decimal place comes from seeing the bounds written with one decimal place and taking that as the accuracy, but the bounds of a value given to 1 decimal place would be only 0.05 either side. To the nearest 10 cm comes from confusing the size of the value, about 25, with the unit it was rounded to; rounding to the nearest 10 cm would give an interval 5 cm either side of the stated value.
- (d) 15 — Use √a × √b = √(ab): √20 × √12 = √(20 × 12) = √240. Since 15² = 225 and 16² = 256, and 240 is a little closer to 225 than to 256, √240 is a little under 15.5 — in fact √240 ≈ 15.49, which rounds to 15. Adding the two roots instead of multiplying them, √20 + √12 ≈ 4.47 + 3.46 ≈ 7.94, rounds to 8, but the question asks for the product, not the sum. Multiplying 20 by 12 and stopping there, without ever taking a square root, leaves 240, which is the number under the root, not its value. Rounding each root to the nearest whole number BEFORE multiplying — √20 ≈ 4 and √12 ≈ 3 — gives 4 × 3 = 12, a cruder estimate that loses accuracy by rounding twice instead of once.
- (c) 3 or −5 — Method: a point a fixed distance from another can lie on either side of it, so move the given distance in each direction from the starting point. Working: moving 4 units to the right gives −1 + 4 = 3, and moving 4 units to the left gives −1 − 4 = −5. Answer: 3 or −5. The distractors: 5 or −3 comes from starting at 1 instead of −1, giving 1 + 4 and 1 − 4; 3 only comes from moving to the right and forgetting that the point could lie to the left as well; 4 or −4 comes from measuring the distance from zero instead of from point A, which just repeats the given distance.
- (c) 12.3 ≤ t < 12.4 — Method: truncating cuts the later digits off instead of rounding them, so nothing is ever pushed upwards. The displayed value is therefore the smallest the time can be, and the time can run up to, but not reach, the next value the display can show. Working: the display reads 12.3, so the actual time is at least 12.3 seconds; as soon as the time reaches 12.3 + 0.1 = 12.4 seconds the display would read 12.4, so 12.4 is not included. Answer: 12.3 ≤ t < 12.4. The distractors: 12.25 ≤ t < 12.35 is the interval for a time rounded to 1 decimal place, and this display does not round; 12.3 < t ≤ 12.4 excludes the one value the display certainly allows and includes the one it rules out; 12.3 ≤ t ≤ 12.4 treats 12.4 seconds as possible, but at 12.4 seconds the display would no longer read 12.3.
Build your own mix at the worksheet builder.