Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Rationalise the denominator of 6/√3, giving your answer in its simplest form.
- 2.A number, x, is truncated (not rounded) to 1 decimal place and the result is 6.2. Write down the error interval for x.
- 3.By listing systematically, work out how many two-digit multiples of 5 can be made using the digits 0, 3 and 5, if each digit can be used at most once and the number cannot start with 0.
- 4.Work out the value of .
- 5.Jack buys 3 books, each costing £4.25, and pays with a £20 note. Work out how much change he receives.
- 6.Priya has 24 red beads and 36 blue beads. She makes identical bracelets, using every bead and with none left over. Work out the greatest number of bracelets she can make.
- 7.n is a whole number and 2 ≤ n < 6. Write down all the possible values of n.
- 8.The density of a type of plastic is 0.9 g/cm³. Work out this density in kg/m³.
- 9.A van has a mass of 2,000 kg, correct to 1 significant figure. Using m for the mass of the van in kilograms, write down the error interval for m.
- 10.A tank contains 120 litres of water. Water is drained out at a rate of 8 litres per minute for 6 minutes, and then a hose adds 15 litres. Work out how much water is left in the tank.
- 11.A cyclist travels 40 km, correct to the nearest 10 km, in a time of 3 hours, correct to the nearest hour. Work out the maximum possible average speed, in km/h.
- 12.Write 5,000,000 in standard form.
- 13.Write 5/6 as a decimal, showing clearly which digit recurs.
- 14.Write 0.005 in standard form.
- 15.Which of these is written correctly in standard form?
Answer key
- (a) 2√3 — Multiply the top and bottom of the fraction by √3, since √3 × √3 = 3: 6/√3 = (6 × √3)/(√3 × √3) = 6√3/3. Dividing 6 by 3 gives 2, so the fraction simplifies to 2√3. Multiplying only the numerator by √3 and then cancelling the surd in the denominator against it as if they were the same term, without properly squaring the denominator, leads to 6. Dividing 6 by 3 as 3 instead of 2 gives 3√3 — a slip in the final division. Simplifying 6√3/3 by cancelling the whole numerator's 3 with the denominator's 3, including the surd, gives 2, which loses the surd altogether.
- (b) 6.2 ≤ x < 6.3 — Truncating simply cuts off the digits after the required decimal place instead of rounding them, so every value from 6.2 up to (but not reaching) 6.3 truncates to 6.2. This gives the error interval 6.2 ≤ x < 6.3, with no allowance made on the lower side because truncation never rounds a smaller value up into this interval. Using 6.15 ≤ x < 6.25 applies the rounding rule of going half a unit either side, which does not apply to truncation. Writing 6.1 < x ≤ 6.2 puts the interval below 6.2 instead of above it. Writing 6.2 ≤ x ≤ 6.3 wrongly includes 6.3, which truncates down to itself, not to 6.2.
- (b) 3 — Method: list all valid two-digit numbers that can be made without starting with 0, then keep only the ones that are multiples of 5. Working: the two-digit numbers possible are 30, 35, 50 and 53. A number is a multiple of 5 only if it ends in 0 or 5: 30 ends in 0, 35 ends in 5, 50 ends in 0, but 53 ends in 3. So there are 3 multiples of 5. Answer: 3. 4 comes from including 53 as a multiple of 5 without checking that its last digit is not 0 or 5. 2 comes from leaving out 50, wrongly assuming 0 cannot be used as the second digit either. 6 comes from listing every two-digit arrangement of the three digits, including ones that start with 0, without applying either restriction.
- (d) 8 — Method: write $16^{3/4}$ as $(\sqrt[4]{16})^3$ — the denominator of the index gives the root, the numerator gives the power. Working: $\sqrt[4]{16} = 2$, so $16^{3/4} = 2^3 = 8$. Answer: 8. A candidate who multiplies 16 by 3/4 is treating the index as an ordinary factor and gets 12 — a fractional index is not a multiplier. A candidate who takes the square root instead of the fourth root and then cubes it works out $(\sqrt{16})^3 = 4^3$ and gets 64; the denominator 4 names a fourth root, not a square root. A candidate who takes the fourth root of 16 correctly but stops there, without cubing it, gets 2.
- (c) £7.25 — Find the total cost of the books first: 3 × 4.25 = 12.75, so the books cost £12.75 in total. Subtract this from the £20 note: 20.00 − 12.75 = 7.25, so the change is £7.25. Stopping after finding the cost and not subtracting it from £20 gives £12.75, which is the amount spent, not the change. Borrowing correctly in the pence column but forgetting to reduce the pounds column by 1 gives £8.25 instead of £7.25. Multiplying 3 × 4.25 as 12.25 instead of 12.75, a multiplication slip, makes the change come out £0.50 too high, at £7.75. So Jack receives £7.25 change.
- (d) 12 — Method: if the bracelets are identical and no beads are left over, the number of bracelets must divide exactly into both totals, so it is the highest common factor of 24 and 36. Working: 24 = 2³ × 3 and 36 = 2² × 3²; taking the lower index of each shared prime gives 2² × 3 = 4 × 3 = 12. Each bracelet then has 2 red beads and 3 blue beads. Answer: 12. The distractors: 6 comes from taking each shared prime once rather than at its lower index, giving 2 × 3, which is a common factor but not the highest; 72 is the lowest common multiple of 24 and 36, from taking the higher index of each prime instead of the lower; 60 comes from adding the two bead totals instead of looking for a common factor.
- (a) 2, 3, 4, 5 — Method: work out which whole numbers satisfy both parts of the inequality. Working: n ≥ 2 means n can be 2 or more; n < 6 means n must be less than 6, so 6 itself is not included. The whole numbers that fit both conditions are 2, 3, 4 and 5. Answer: 2, 3, 4, 5. 2, 3, 4, 5, 6 treats < 6 as ≤ 6 and wrongly includes 6. 3, 4, 5 treats ≥ 2 as > 2 and wrongly leaves out 2. 1, 2, 3, 4, 5 wrongly includes 1, which does not satisfy n ≥ 2.
- (a) 900 kg/m³ — Both parts of the compound unit change. There are 100 cm in a metre, so 1 m³ = 100³ = 1 000 000 cm³, and there are 1000 g in a kilogram. So 1 g/cm³ = 1 000 000 ÷ 1000 = 1000 kg/m³, and the plastic is 0.9 × 1000 = 900 kg/m³. 900 000 kg/m³ converts the volume but leaves the mass in grams, 0.0009 kg/m³ converts the mass but leaves the volume in cm³, and 0.09 kg/m³ uses the 100 cm in a metre without cubing it.
- (a) 1,500 ≤ m < 2,500 — Method: a four-digit figure written to 1 significant figure has been rounded to the nearest 1,000, so the mass lies within half of 1,000, that is 500, of the figure given. Working: 2,000 − 500 = 1,500 and 2,000 + 500 = 2,500. The lower limit is included, because 1,500 kg rounds up to 2,000 kg to 1 significant figure, while 2,500 kg rounds up to 3,000 kg, so the upper limit is not. Answer: 1,500 ≤ m < 2,500. The distractors: 1,950 ≤ m < 2,050 comes from rounding to the nearest 100 instead of to 1 significant figure; 1,000 ≤ m < 3,000 goes a whole 1,000 either side instead of half of it; 1,500 < m ≤ 2,500 has the two limits the wrong way round.
- (c) 87 litres — Work out how much water is drained: 8 × 6 = 48 litres. Subtract this from the starting amount: 120 − 48 = 72 litres. Then add the 15 litres from the hose: 72 + 15 = 87 litres. Subtracting the 15 litres instead of adding it, as though the hose also removed water, gives 120 − 48 − 15 = 57 litres. Stopping after the drain step, without adding the hose water back in, leaves the working at 72 litres. Adding the rate and the time instead of multiplying them, 8 + 6 = 14 litres drained, and then working from there gives 120 − 14 + 15 = 121 litres. So 87 litres of water is left in the tank.
- (c) 18 — The error intervals are 35 ≤ distance < 45 and 2.5 ≤ time < 3.5. Average speed is distance ÷ time, and to make a quotient as large as possible you divide the largest possible numerator by the SMALLEST possible denominator: 45 ÷ 2.5 = 18 km/h. Using the upper bound of time as well as the upper bound of distance, 45 ÷ 3.5, gives roughly 12.9 km/h — dividing by a bigger number produces a smaller result, so this actually finds a value smaller than the true maximum. Using the lower bound of distance with the lower bound of time, 35 ÷ 2.5 = 14, mixes up which bound belongs to a maximum calculation. Using the lower bound of distance with the upper bound of time, 35 ÷ 3.5 = 10, is in fact the correct method for the MINIMUM speed, not the maximum.
- (c) 5 × 10⁶ — Method: standard form is written as A × 10ⁿ, where A is at least 1 and less than 10 and n counts the places the decimal point moves. Working: the digits of 5,000,000 give a coefficient of A = 5, and the decimal point travels from the end of 5,000,000 until it sits just after the 5, a move of 6 places, so n = 6. Answer: 5 × 10⁶. The distractors: 50 × 10⁵ comes from stopping before the coefficient has been brought into range, and 50 is not less than 10, so it is not standard form; 5 × 10⁷ comes from counting the seven digits of 5,000,000 instead of the six places the decimal point moves; 5 × 10⁻⁶ comes from making the index negative because the decimal point was carried to the left, when a negative index belongs to a number smaller than 1.
- (b) 0.83333... — Divide 5 by 6 using long division. 5.000... ÷ 6: 50 ÷ 6 = 8 remainder 2, giving the first decimal digit 8. Bring down a 0 to make 20, and 20 ÷ 6 = 3 remainder 2 — the remainder 2 has reappeared, so from here the digit 3 repeats forever. This gives 5/6 = 0.83333... . Stopping after two decimal places and writing 0.83 treats the division as if it terminated, when the remainder never reaches zero. Shifting the decimal point one place too far to the left gives 0.083333..., the same digits divided by an extra power of ten. A slip in the long division itself, misreading a remainder, can produce the wrong repeating digit, 0.85555... .
- (c) 5 × 10⁻³ — Method: in standard form the coefficient must be at least 1 and less than 10, and for a number smaller than 1 the index is negative and counts the places the decimal point moves to the right. Working: the only significant digit is 5, so the coefficient is 5; moving the decimal point in 0.005 three places to the right gives 5, so the index is −3. Answer: 5 × 10⁻³. The distractors: 0.5 × 10⁻² is the same value written the wrong way, because 0.5 is smaller than 1 and so is not an allowed coefficient; 5 × 10⁻² comes from counting the two zeros after the decimal point instead of the three places the point moves; 5 × 10³ comes from taking the index as positive, which describes a number in the thousands rather than one smaller than 1.
- (a) 7.5 × 10⁴ — Standard form is A × 10ⁿ, where A is between 1 and 10 (1 ≤ A < 10) and n is an integer — 7.5 × 10⁴ satisfies all of this. 12 × 10³ fails because 12 is not below 10. 0.5 × 10⁴ fails because 0.5 is not at least 1. 6.2 × 4⁵ fails because standard form always uses a power of 10, not a power of 4.
Build your own mix at the worksheet builder.