Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.The diameter of an artificial silk fibre is 4 × 10⁻⁶ metres. One nanometre is 10⁻⁹ metres. Work out the diameter of the fibre in nanometres.
- 2.A recipe uses 0.625 kg of flour. Write this mass as a fraction of a kilogram, in its simplest form.
- 3.The two shorter sides of a right-angled triangle are √12 cm and √24 cm. Work out the exact length of the hypotenuse.
- 4.A garden path is measured by Jon as 12 m, correct to the nearest metre, and by Mia as 12.6 m, correct to the nearest 0.1 m. Which statement about the two measurements is correct?
- 5.Oliver drives 95 km at an average speed of 50 km/h. Work out an estimate for the time the journey takes, by rounding the distance to the nearest 100 km.
- 6.Write these numbers in order, starting with the largest: −0.6, 0.45, −0.15, 0.5, −0.09
- 7.Write down the exact decimal value of the fraction 1/6.
- 8.Priya has 24 red beads and 36 blue beads. She makes identical bracelets, using every bead and with none left over. Work out the greatest number of bracelets she can make.
- 9.A number, x, is truncated (not rounded) to 1 decimal place and the result is 6.2. Write down the error interval for x.
- 10.A cyclist travels 40 km, correct to the nearest 10 km, in a time of 3 hours, correct to the nearest hour. Work out the maximum possible average speed, in km/h.
- 11.In a science experiment, the temperature of a liquid is recorded as 18.6 °C, correct to the nearest 0.2 °C. Write down the error interval for the actual temperature, T °C.
- 12.A car manufacturer offers a car in 6 colours and 4 trim levels. Two colour-and-trim combinations are not available: red with sport trim, and white with sport trim. Work out how many different colour-and-trim combinations are available.
- 13.A tank contains 120 litres of water. Water is drained out at a rate of 8 litres per minute for 6 minutes, and then a hose adds 15 litres. Work out how much water is left in the tank.
- 14.Write down the symbol that makes this statement true: −2/3 ___ −5/6
- 15.Write 0.35 as a fraction in its lowest terms.
Answer key
- (a) 4,000 nanometres — Method: the number of nanometres is the diameter divided by the length of one nanometre, and dividing powers of ten means subtracting the indices. Working: −6 − (−9) = 3, so 10⁻⁶ ÷ 10⁻⁹ = 10³, and the diameter is 4 × 10³ nanometres. Answer: 4,000 nanometres. The distractors: 400 nanometres comes from taking the difference between the indices as 2 instead of 3; 4 nanometres comes from changing the name of the unit without converting, leaving the coefficient untouched; 0.004 nanometres comes from dividing by 10³ instead of multiplying by it, as though a nanometre were the larger of the two units.
- (c) 5/8 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.625 = 625/1000 = 5/8 (dividing both numerator and denominator by 125). Answer: 5/8. 25/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 31/50 comes from rounding 0.625 to 0.62 before converting. 8/5 comes from simplifying correctly to 5/8 and then writing the fraction upside down.
- (d) 6 — By Pythagoras' theorem, the square of the hypotenuse equals the sum of the squares of the other two sides: (√12)² + (√24)² = 12 + 24 = 36. The hypotenuse is √36 = 6 cm. Adding the two side lengths directly instead of squaring them first, treating the theorem as if it were a straight sum of the sides, gives √12 + √24 = 2√3 + 2√6. Multiplying the two squared values, 12 × 24 = 288, instead of adding them, then taking the root, gives √288 = 12√2. Adding the squares correctly to get 36 but forgetting to take the square root at the end leaves 36 as the answer instead of the hypotenuse itself.
- (a) They cannot both be describing the same path — Jon's measurement means the true length, l, satisfies 11.5 m ≤ l < 12.5 m. Mia's measurement means the true length satisfies 12.55 m ≤ l < 12.65 m. These two ranges do not overlap, so the two measurements cannot both be describing the same path. 'They must both be describing the same path' ignores that the two ranges do not overlap at all. 'Jon's measurement must be wrong' wrongly assumes Jon is the one at fault, when the mismatch does not show which measurement, if either, is wrong. 'Mia's measurement must be wrong' makes the same unjustified assumption in the other direction.
- (d) 2 hours — Method: the time for a journey is the distance divided by the speed, so round the distance first and then divide by the speed. Working: 95 km rounds to 100 km, and 100 ÷ 50 = 2; the speed is in kilometres per hour, so the answer is a number of hours. Answer: 2 hours. The distractors: 1 hour comes from rounding the distance down to 50 km to match the speed, so that the journey looks like a single hour of driving; 30 minutes comes from dividing the speed by the distance, 50 ÷ 100, instead of the distance by the speed; 1 hour 54 minutes is the exact time, 95 ÷ 50 = 1.9 hours, worked out in full when the question asks for an estimate.
- (c) 0.5, 0.45, −0.09, −0.15, −0.6 — Method: compare the decimals by their position on a number line, remembering that with negative decimals the one closer to zero is larger. Working: 0.5 and 0.45 are positive, so they come first, with 0.5 the larger of the two. Among the negatives, −0.09 is closest to zero, then −0.15, then −0.6 is furthest from zero and so the smallest. Answer: 0.5, 0.45, −0.09, −0.15, −0.6. 0.5, 0.45, −0.15, −0.09, −0.6 swaps −0.09 and −0.15, treating the negative decimal with more digits after the point as closer to zero. −0.6, −0.15, −0.09, 0.45, 0.5 lists the numbers from smallest to largest instead of largest to smallest. 0.5, 0.45, −0.6, −0.15, −0.09 orders the negative decimals by the size of the digit (0.6 > 0.15 > 0.09) as if they were positive, instead of recognising that a bigger negative decimal is further from zero and so smaller.
- (a) 0.1666... — Method: a fraction bar means divide, so the decimal is found by dividing the numerator by the denominator; when a remainder comes back unchanged the division never ends, the digit it produces repeats for ever, and the exact value has to be written with that recurring digit rather than a rounded one. Working: 1 ÷ 6 is set out as 1.000 ÷ 6; six does not go into 1, and six goes into 10 tenths once with 4 left over, so the first decimal digit is 1; the 4 left over makes 40 hundredths, and six goes into 40 six times with 4 left over again; that same remainder of 4 returns at every step, so the digit 6 repeats without end. Answer: 0.1666... The distractors: 0.16 comes from carrying the division out to two decimal places and stopping there, as though the decimal terminated; 0.17 comes from rounding the division to two decimal places, which gives a value close to one sixth but not equal to it; 0.6 comes from writing the digit of the denominator straight after the decimal point, as though 1/6 meant six tenths.
- (d) 12 — Method: if the bracelets are identical and no beads are left over, the number of bracelets must divide exactly into both totals, so it is the highest common factor of 24 and 36. Working: 24 = 2³ × 3 and 36 = 2² × 3²; taking the lower index of each shared prime gives 2² × 3 = 4 × 3 = 12. Each bracelet then has 2 red beads and 3 blue beads. Answer: 12. The distractors: 6 comes from taking each shared prime once rather than at its lower index, giving 2 × 3, which is a common factor but not the highest; 72 is the lowest common multiple of 24 and 36, from taking the higher index of each prime instead of the lower; 60 comes from adding the two bead totals instead of looking for a common factor.
- (b) 6.2 ≤ x < 6.3 — Truncating simply cuts off the digits after the required decimal place instead of rounding them, so every value from 6.2 up to (but not reaching) 6.3 truncates to 6.2. This gives the error interval 6.2 ≤ x < 6.3, with no allowance made on the lower side because truncation never rounds a smaller value up into this interval. Using 6.15 ≤ x < 6.25 applies the rounding rule of going half a unit either side, which does not apply to truncation. Writing 6.1 < x ≤ 6.2 puts the interval below 6.2 instead of above it. Writing 6.2 ≤ x ≤ 6.3 wrongly includes 6.3, which truncates down to itself, not to 6.2.
- (c) 18 — The error intervals are 35 ≤ distance < 45 and 2.5 ≤ time < 3.5. Average speed is distance ÷ time, and to make a quotient as large as possible you divide the largest possible numerator by the SMALLEST possible denominator: 45 ÷ 2.5 = 18 km/h. Using the upper bound of time as well as the upper bound of distance, 45 ÷ 3.5, gives roughly 12.9 km/h — dividing by a bigger number produces a smaller result, so this actually finds a value smaller than the true maximum. Using the lower bound of distance with the lower bound of time, 35 ÷ 2.5 = 14, mixes up which bound belongs to a maximum calculation. Using the lower bound of distance with the upper bound of time, 35 ÷ 3.5 = 10, is in fact the correct method for the MINIMUM speed, not the maximum.
- (b) 18.5 ≤ T < 18.7 — Method: the error interval reaches half the rounding unit either side of the recorded value. Working: half of 0.2 is 0.1, so the interval runs from 18.6 − 0.1 to 18.6 + 0.1. Answer: 18.5 ≤ T < 18.7. (18.4 ≤ T < 18.8 comes from using the full rounding unit, 0.2, either side instead of half of it. 18.5 ≤ T ≤ 18.7 comes from including the upper bound with ≤ instead of excluding it with <. 18.6 ≤ T < 18.8 comes from treating the recorded value as the start of the interval and adding the whole rounding unit, 0.2, above it.)
- (c) 22 — Without restriction there are 6 × 4 = 24 combinations. Two specific combinations are not available, so subtract 2: 24 − 2 = 22. 24 comes from ignoring the restriction completely. 23 comes from subtracting only 1 of the 2 excluded combinations. 18 comes from removing the whole sport trim level, 6 × 3 = 18, instead of removing just the two excluded combinations.
- (c) 87 litres — Work out how much water is drained: 8 × 6 = 48 litres. Subtract this from the starting amount: 120 − 48 = 72 litres. Then add the 15 litres from the hose: 72 + 15 = 87 litres. Subtracting the 15 litres instead of adding it, as though the hose also removed water, gives 120 − 48 − 15 = 57 litres. Stopping after the drain step, without adding the hose water back in, leaves the working at 72 litres. Adding the rate and the time instead of multiplying them, 8 + 6 = 14 litres drained, and then working from there gives 120 − 14 + 15 = 121 litres. So 87 litres of water is left in the tank.
- (c) > — Method: write both fractions with a common denominator so they can be compared directly. Working: −2/3 = −4/6. Comparing −4/6 and −5/6, −4 is greater than −5, so −4/6 is greater than −5/6. Answer: −2/3 > −5/6, so the symbol is >. < comes from treating the fraction with the larger numerator and denominator, 5/6, as the greater number, ignoring that both fractions are negative. = comes from assuming the fractions must be equal because they look similar in size. ≤ combines < (false) with = (false).
- (d) 7/20 — Method: write the decimal over the power of ten that matches the number of digits after the point, then divide the numerator and the denominator by their highest common factor. Working: 0.35 has two digits after the point, so it is 35 hundredths and can be written as 35/100; the highest common factor of 35 and 100 is 5, and 35 ÷ 5 = 7 with 100 ÷ 5 = 20. Answer: 7/20. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 7/25 comes from dividing the numerator by 5 but the denominator by 4, using a different factor on the top and on the bottom; 35/10 comes from counting one decimal place instead of two and writing the digits over 10.
Build your own mix at the worksheet builder.