Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Write 0.36 as a fraction in its simplest form.
- 2.A garden path is measured by Jon as 12 m, correct to the nearest metre, and by Mia as 12.6 m, correct to the nearest 0.1 m. Which statement about the two measurements is correct?
- 3.Rationalise the denominator of 6/√3, giving your answer in its simplest form.
- 4.An allotment is divided into two plots in the ratio 2:3. The larger plot has an area of 18 m². Work out the fraction of the total area taken up by the smaller plot.
- 5.Which one of these statements is true?
- 6.Work out √3 × √12, giving your answer as an integer.
- 7.In a science experiment, the temperature of a liquid is recorded as 18.6 °C, correct to the nearest 0.2 °C. Write down the error interval for the actual temperature, T °C.
- 8.Postage on a parcel is calculated as £4.60, correct to the nearest 20p. Which of these could not be the actual cost of the postage?
- 9.A bag of flour is labelled 1.5 kg, correct to the nearest 0.1 kg. The true mass of the flour is m kg. Which inequality gives all the possible values of m?
- 10.n is a whole number and 2 ≤ n < 6. Write down all the possible values of n.
- 11.Two-digit numbers are formed using the digits 2, 5, 7 and 8, and each digit may be used only once in a number. Work out how many of these two-digit numbers are even.
- 12.A circle has a radius of 3 cm. Which of these is the exact area of the circle?
- 13.A lorry travels 105 miles in 1 hour 45 minutes. Work out its average speed in miles per hour.
- 14.A lift has a safe working load of 500 kg. Four people get in the lift and the lift's display records their total mass as 493 kg, correct to the nearest kg. Decide whether the four people are definitely within the safe working load.
- 15.Write 0.06 as a fraction in its simplest form.
Answer key
- (b) 9/25 — Method: write the decimal over the matching power of ten, then divide the numerator and the denominator by their highest common factor. Working: 0.36 has two digits after the point, so 0.36 = 36/100; the highest common factor of 36 and 100 is 4, and 36 ÷ 4 = 9 with 100 ÷ 4 = 25; since 9 and 25 share no factor greater than 1, the fraction is fully cancelled. Answer: 9/25. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 9/50 comes from dividing the numerator by 4 but the denominator by only 2; 36/10 comes from counting one decimal place instead of two and writing the digits over 10.
- (a) They cannot both be describing the same path — Jon's measurement means the true length, l, satisfies 11.5 m ≤ l < 12.5 m. Mia's measurement means the true length satisfies 12.55 m ≤ l < 12.65 m. These two ranges do not overlap, so the two measurements cannot both be describing the same path. 'They must both be describing the same path' ignores that the two ranges do not overlap at all. 'Jon's measurement must be wrong' wrongly assumes Jon is the one at fault, when the mismatch does not show which measurement, if either, is wrong. 'Mia's measurement must be wrong' makes the same unjustified assumption in the other direction.
- (a) 2√3 — Multiply the top and bottom of the fraction by √3, since √3 × √3 = 3: 6/√3 = (6 × √3)/(√3 × √3) = 6√3/3. Dividing 6 by 3 gives 2, so the fraction simplifies to 2√3. Multiplying only the numerator by √3 and then cancelling the surd in the denominator against it as if they were the same term, without properly squaring the denominator, leads to 6. Dividing 6 by 3 as 3 instead of 2 gives 3√3 — a slip in the final division. Simplifying 6√3/3 by cancelling the whole numerator's 3 with the denominator's 3, including the surd, gives 2, which loses the surd altogether.
- (a) 2/5 — The ratio 2:3 has 2 + 3 = 5 parts in total, and the larger plot is 3 of those parts. Since the larger plot is 18 m², each part is 18 ÷ 3 = 6 m², so the total area is 5 × 6 = 30 m² and the smaller plot is 2 × 6 = 12 m². The fraction of the total area taken up by the smaller plot is 12/30, which simplifies to 2/5. Giving the fraction for the larger plot instead of the smaller one gives 3/5. Comparing the smaller plot to the larger plot instead of to the total area gives 2/3. Assuming the two plots split the area evenly, ignoring the given ratio altogether, gives 1/2.
- (c) −5 ≤ −5 — The symbol ≤ means 'less than or equal to', and −5 is equal to −5, so this statement is true. −3 ≥ −1 is false: a candidate who ignores the negative signs and compares 3 with 1 would wrongly think −3 is the bigger number, but on the number line −3 is smaller than −1. 0.4 < 2/5 is false because 2/5 converts to exactly 0.4, so the two values are equal, not one strictly less than the other — a candidate who assumes a fraction is automatically bigger than a similar-looking decimal without converting it would miss this. 7/10 ≤ 0.6 is false because 7/10 converts to 0.7, which is bigger than 0.6; a candidate who misplaces the decimal point and converts 7/10 as 0.07 would wrongly believe this statement is true.
- (a) 6 — Use √a × √b = √(ab): √3 × √12 = √(3 × 12) = √36 = 6. Adding the numbers under the roots instead of multiplying them, 3 + 12 = 15, gives √15 — that comes from applying the rule for adding surds to a multiplication question. Multiplying the two numbers under the roots but then forgetting to take the square root at the end leaves 36. Simplifying only √12 to 2√3 and then dropping the other √3 factor entirely gives 2√3.
- (b) 18.5 ≤ T < 18.7 — Method: the error interval reaches half the rounding unit either side of the recorded value. Working: half of 0.2 is 0.1, so the interval runs from 18.6 − 0.1 to 18.6 + 0.1. Answer: 18.5 ≤ T < 18.7. (18.4 ≤ T < 18.8 comes from using the full rounding unit, 0.2, either side instead of half of it. 18.5 ≤ T ≤ 18.7 comes from including the upper bound with ≤ instead of excluding it with <. 18.6 ≤ T < 18.8 comes from treating the recorded value as the start of the interval and adding the whole rounding unit, 0.2, above it.)
- (d) £4.80 — Method: find the error interval, then check which value falls outside it. Working: half of 20p is 10p, so the actual cost, c, satisfies £4.50 ≤ c < £4.70. £4.80 is above £4.70, so it could not be the actual cost. Answer: £4.80. (£4.50 is a genuine possible cost — it sits at the included lower boundary. £4.65 is a genuine possible cost, below the £4.70 upper boundary. £4.55 is a genuine possible cost, well inside the interval.)
- (b) 1.45 ≤ m < 1.55 — The flour's mass is labelled 1.5 kg, correct to the nearest 0.1 kg, so half of 0.1 kg is added to and subtracted from 1.5 kg to find the interval: 1.5 − 0.05 = 1.45 and 1.5 + 0.05 = 1.55, giving 1.45 ≤ m < 1.55. '1.4 ≤ m < 1.6' comes from taking the whole 0.1 kg as the margin either side, instead of half of it. '1.45 < m ≤ 1.55' comes from writing the inequality signs the wrong way round — the lower bound should be included and the upper bound excluded, not the other way round. '1.45 ≤ m ≤ 1.55' comes from including the upper bound, when the convention is that the upper bound is never actually reached.
- (a) 2, 3, 4, 5 — Method: work out which whole numbers satisfy both parts of the inequality. Working: n ≥ 2 means n can be 2 or more; n < 6 means n must be less than 6, so 6 itself is not included. The whole numbers that fit both conditions are 2, 3, 4 and 5. Answer: 2, 3, 4, 5. 2, 3, 4, 5, 6 treats < 6 as ≤ 6 and wrongly includes 6. 3, 4, 5 treats ≥ 2 as > 2 and wrongly leaves out 2. 1, 2, 3, 4, 5 wrongly includes 1, which does not satisfy n ≥ 2.
- (c) 6 — The units digit must be even, so it can be 2 or 8, giving 2 choices. The tens digit can then be any of the remaining 3 digits, since one digit has been used for the units. Multiply: 2 × 3 = 6. 12 comes from working out how many two-digit numbers can be made in total, 4 × 3 = 12, ignoring the requirement that the number is even. 8 comes from choosing the units digit from 2 options and then wrongly allowing any of the 4 digits again for the tens digit, 2 × 4 = 8, which lets a digit repeat. 2 comes from counting only the choices for the units digit and forgetting the tens digit.
- (c) 9π cm² — The area of a circle is π × r². With a radius of 3 cm this is π × 3² = 9π cm², and this is exact because π has not been replaced by any approximation. Writing 28.3 cm² replaces π with a rounded decimal value, 3.14, and then rounds the result again, so it is only an approximation. Writing 28.26 cm² uses π ≈ 3.14 without a final rounding step, but this is still only an approximation of 9π, not the exact value. Writing 27 cm² comes from replacing π with the rough approximation 3, which is even further from the true value.
- (d) 60 mph — Average speed = distance ÷ time, with the time measured in hours. 45 minutes is 45/60 of an hour, which is 0.75 of an hour, so the journey takes 1.75 hours. Speed = 105 ÷ 1.75 = 60 mph. 52.5 mph rounds the time up to 2 hours, 72.4 mph writes 1 hour 45 minutes as 1.45 hours, and 183.75 mph multiplies the distance by the time instead of dividing.
- (c) Yes — the greatest possible total is 493.5 kg, under 500 kg — 493 kg correct to the nearest kg means the true total mass, m, satisfies 492.5 kg ≤ m < 493.5 kg. The greatest possible total is 493.5 kg, which is under the 500 kg safe working load, so the four people are definitely within it. 'The true total could be as high as 498 kg' comes from treating 'nearest kg' as an error of ±5 kg instead of ±0.5 kg. 'Cannot be decided without the exact total' overlooks that the error interval already gives the greatest possible total, so the decision can be made without knowing the exact figure. '493 kg is only an estimate, so it may be over 500 kg' ignores that the error interval is bounded — the true total cannot exceed 493.5 kg, well under 500 kg.
- (b) 3/50 — Method: write the decimal over the power of ten that matches the number of digits after the point, counting every digit including a zero, then divide the numerator and the denominator by their highest common factor. Working: 0.06 has two digits after the point, so it is 6 hundredths and can be written as 6/100; the highest common factor of 6 and 100 is 2, and 6 ÷ 2 = 3 with 100 ÷ 2 = 50. Answer: 3/50. The distractors: 3/5 comes from ignoring the zero straight after the point and converting 0.6 instead, giving 6/10, which cancels to 3/5; 3/500 comes from counting three decimal places instead of two and writing 6/1000, which cancels to 3/500; 1/6 comes from putting 1 over the digits after the point, as though 0.06 meant one sixth.
Build your own mix at the worksheet builder.