Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 8 × 10³ — Method: divide the capacity of the card by the size of one photograph, dividing the coefficients and subtracting the indices, then bring the coefficient back into the range 1 to 10. Working: 3.2 ÷ 4 = 0.8 and 10 − 6 = 4, which gives 0.8 × 10⁴; a coefficient of 0.8 is smaller than 1, so the decimal point moves one place to the right and the index falls by 1. Answer: 8 × 10³. The distractors: 8 × 10⁴ comes from correcting 0.8 to 8 without reducing the index, which makes the answer ten times too large; 1.28 × 10¹⁷ comes from multiplying the two numbers instead of dividing them, since 3.2 × 4 = 12.8 and 10 + 6 = 16; 8 × 10¹⁵ comes from dividing the coefficients but adding the indices instead of subtracting them.
- (d) £6 — First find 30% of £200, which is £60, then find 10% of that: £60 × 0.1 = £6. Adding the two percentages together instead of applying them one after the other, 10% + 30% = 40%, and finding 40% of £200 gives £80. Finding 30% of £200 = £60 correctly but stopping before applying the second percentage leaves £60 as the final answer. Finding only 10% of the original £200, ignoring the 30% entirely, gives £20.
- (d) 60 mph — Average speed = distance ÷ time, with the time measured in hours. 45 minutes is 45/60 of an hour, which is 0.75 of an hour, so the journey takes 1.75 hours. Speed = 105 ÷ 1.75 = 60 mph. 52.5 mph rounds the time up to 2 hours, 72.4 mph writes 1 hour 45 minutes as 1.45 hours, and 183.75 mph multiplies the distance by the time instead of dividing.
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
- (c) 62.35 ≤ r < 62.45 — Method: with a value rounded to 1 decimal place, the error interval reaches half of 0.1 either side. Working: half of 0.1 is 0.05, so the interval runs from 62.4 − 0.05 to 62.4 + 0.05. Answer: 62.35 ≤ r < 62.45. (62 ≤ r < 63 comes from rounding to the nearest whole number instead of 1 decimal place. 62.35 ≤ r ≤ 62.45 comes from including the upper bound with ≤ instead of excluding it with <. 62.3 ≤ r < 62.5 comes from using 0.1 either side instead of half of it.)
- (d) £70 — Method: the discount is a percentage of the original price only, so work it out, subtract it, and add the fixed delivery charge afterwards. Working: 25% of £80 is £80 ÷ 4 = £20, so the discounted price is £80 − £20 = £60, and the total is £60 + £10 = £70. Answer: £70. The distractors: £60 comes from working out the discounted price and stopping there, leaving the delivery charge out of the total; £65 comes from taking £25 off the price instead of 25% of it, giving £80 − £25 = £55 and then £55 + £10 = £65; £67.50 comes from adding the delivery charge before the discount and reducing the whole amount, giving 75% of £90 = £67.50.
- (a) 300 N/m² — Pressure is force ÷ area, and the unit N/m² says so: newtons divided by square metres. The calculation is 240 ÷ 0.8. Multiplying both numbers by 10 clears the decimal: 2400 ÷ 8 = 300 N/m². 192 N/m² multiplies the force by the area instead of dividing, 30 N/m² divides by 8 and so loses the decimal point, and 3000 N/m² multiplies only the force by 10 when clearing the decimal.
- (a) 8.15 ≤ y < 8.25 — Rounding to 1 decimal place means the error interval spans half of 0.1, so 0.05, either side of 8.2: 8.2 − 0.05 = 8.15 and 8.2 + 0.05 = 8.25. The lower bound uses ≤ because 8.15 itself rounds to 8.2, but the upper bound uses < because 8.25 would round up to 8.3. So the error interval is 8.15 ≤ y < 8.25. A candidate who used the wrong rounding band gave 8.1 ≤ y < 8.2. A candidate who used a strict inequality at both ends wrote 8.15 < y < 8.25, wrongly excluding 8.15 itself. A candidate who added the full 0.1 instead of half of it wrote 8.2 ≤ y < 8.3.
- (a) 8,350 — Rounding to the nearest 100 means the true number can be up to half of 100, which is 50, below the recorded figure before it would round down to a lower hundred. The smallest possible number is therefore 8,400 − 50 = 8,350. Adding 50 instead of subtracting it gives 8,450, which is the upper end of the interval rather than the smallest value, and 8,450 is not itself possible because it would round up to 8,500. Subtracting a whole 100 instead of half of it gives 8,300, going too far below the recorded value. Subtracting 10 instead of half of the rounding unit gives 8,390, treating the rounding unit as 100 but the tolerance as only 10.
- (b) 90 km/h — To convert metres per second to kilometres per hour, multiply by 3.6 (there are 3600 seconds in an hour and 1000 metres in a kilometre, and 3600 ÷ 1000 = 3.6): 25 × 3.6 = 90 km/h. Dividing by 3.6 instead of multiplying gives 25 ÷ 3.6 = 6.9 km/h (to 1 d.p.). Multiplying by 60 instead of 3.6, confusing the conversion from seconds to minutes with the conversion to hours, gives 25 × 60 = 1500 km/h. Multiplying by 3600 to convert seconds to hours but forgetting to convert metres to kilometres gives 25 × 3600 = 90000, which is a speed in metres per hour, not kilometres per hour.
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (c) £47.00 — First apply the 20% reduction: £65 × 0.8 = £52.00. Then take off the further £5: £52.00 − £5 = £47.00. Treating the 20% as a flat £20 rather than a percentage of the price, £65 − £20 − £5, gives £40.00. Applying the 20% reduction correctly but forgetting to take off the extra £5 leaves £52.00. Taking off the £5 first and then applying the 20% reduction to the smaller amount, (£65 − £5) × 0.8, gives £48.00.
- (a) 33.5 mph — Method: the smallest possible actual value is half the rounding unit below the given value. Working: half of 1 mph is 0.5 mph, so the smallest possible speed is 34 − 0.5 = 33.5 mph. Answer: 33.5 mph. (33 mph comes from subtracting the whole rounding unit, 1, instead of half of it. 34 mph comes from giving the rounded value itself rather than the lower bound. 34.5 mph comes from adding the half unit instead of subtracting it, giving the upper bound.)
- (c) 4 × 10⁴ — 8 ÷ 2 = 4, and 6 − 2 = 4, so each project receives 4 × 10⁴ pounds. Multiplying the exponents instead of subtracting them gives 6 × 2 = 12, so 4 × 10¹². Adding the exponents instead of subtracting them gives 6 + 2 = 8, so 4 × 10⁸. Subtracting the coefficients instead of dividing them gives 8 − 2 = 6, so 6 × 10⁴.
- (a) −4.5 °C — Order the temperatures by their actual value on a number line, remembering that a more negative number is further below zero and therefore colder: −4.5 °C is the coldest, since it is further below zero than −4.05 °C, −3.8 °C or 2 °C. Comparing the digits 405 and 45 as though the decimal points lined up, without padding −4.5 to match the number of decimal places in −4.05 first, makes −4.05 °C look like it has the bigger size, so it gets picked as the coldest by mistake — in fact −4.05 °C is closer to zero than −4.5 °C, not further from it. Picking −3.8 °C comes from choosing the negative reading with the smallest absolute value, forgetting that for negative numbers, a smaller absolute value means a warmer, less negative temperature, not a colder one. Picking 2 °C comes from ignoring the negative signs on the other three readings altogether and comparing raw digit sizes, when in fact any negative temperature is colder than any positive temperature. So the coldest temperature is −4.5 °C.
Build your own mix at the worksheet builder.