Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 2.5 × 10⁶ — Divide the A values: 5 ÷ 2 = 2.5. Subtract the powers of 10: 4 − (−2) = 4 + 2 = 6. So the answer is 2.5 × 10⁶. A candidate who worked out 4 − 2 = 2, treating the subtraction of a negative as an ordinary subtraction, wrote 2.5 × 10². A candidate who subtracted in the wrong order, −2 − 4 = −6, wrote 2.5 × 10⁻⁶. A candidate who multiplied the A values instead of dividing, 5 × 2 = 10, and added the powers, 4 + (−2) = 2, then rewrote 10 × 10² in standard form as 1 × 10³.
- (b) 120 — Method: fill the positions on the shelf one at a time; each book placed leaves one fewer book available for the next position, and the product rule multiplies the choices. Working: there are 5 books for the first position, 4 for the second, 3 for the third, 2 for the fourth and 1 for the last, so the number of orders is 5 × 4 × 3 × 2 × 1 = 120. Answer: 120. The distractors: 25 comes from multiplying the 5 books by the 5 positions rather than multiplying the shrinking number of choices at each position; 60 comes from halving the correct product, as though each order had been counted twice in the way that pairs are; 720 comes from carrying the product one factor too far and working out 6 × 5 × 4 × 3 × 2 × 1, as though there were six books.
- (a) 0.55, 58%, 3/5 — Converting all three to decimals: 3/5 = 0.6, 0.55 stays as 0.55, and 58% = 0.58. In order from smallest to largest, this is 0.55, then 58%, then 3/5. Writing the numbers in the reverse order, largest to smallest, gives 3/5, 58%, 0.55. Misconverting 3/5 as 0.5 instead of 0.6 makes it appear smaller than both other values, giving the order 3/5, 0.55, 58%. Misconverting 58% as 0.058 instead of 0.58, by moving the decimal point two extra places, makes it appear smallest of the three, giving the order 58%, 0.55, 3/5.
- (c) 5/8 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.625 = 625/1000 = 5/8 (dividing both numerator and denominator by 125). Answer: 5/8. 25/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 31/50 comes from rounding 0.625 to 0.62 before converting. 8/5 comes from simplifying correctly to 5/8 and then writing the fraction upside down.
- (a) 1,850 — Method: find the error interval, then check which value falls outside it. Working: half of 100 is 50, so the actual number of visitors, v, satisfies 1,750 ≤ v < 1,850. 1,850 sits exactly on the excluded upper boundary, since a value of 1,850 would round to 1,900, not 1,800. Answer: 1,850. (1,750 is a genuine possible value — it sits at the included lower boundary. 1,799 is a genuine possible value, just below the upper boundary. 1,760 is a genuine possible value, well inside the interval.)
- (a) 56 — Method: count the ordered selections with the product rule first, then divide by the number of different orders in which any one committee could have been picked. Working: there are 8 choices for a first pupil, 7 for a second and 6 for a third, giving 8 × 7 × 6 = 336 ordered selections; any particular three pupils could have been picked in 3 × 2 × 1 = 6 orders, so the number of different committees is 336 ÷ 6 = 56. Answer: 56. The distractors: 336 comes from stopping at 8 × 7 × 6 and treating the three places as distinct posts when they are identical; 168 comes from dividing that product by 2 rather than by the 6 orders in which three chosen pupils can be listed; 24 comes from multiplying the 8 volunteers by the 3 places instead of multiplying the choices at each stage.
- (b) 93.9975 — Each measurement was rounded to 1 decimal place, so the error is half of 0.1: length is 12.35 ≤ L < 12.45, and width is 7.45 ≤ W < 7.55. The upper bound for the area comes from multiplying the upper bounds of both dimensions: 12.45 × 7.55 = 93.9975 m². Using the lower bound of both dimensions instead, 12.35 × 7.45 = 92.0075 m², gives the lower bound of the area rather than the upper one. Multiplying the two given rounded values directly, 12.4 × 7.5 = 93, forgets that a rounded measurement is not exact and needs its own error interval. Bounding only the length and leaving the width at its given value, 12.45 × 7.5 = 93.375, misses that the width also has an upper bound of its own.
- (a) 1,500 ≤ m < 2,500 — Method: a four-digit figure written to 1 significant figure has been rounded to the nearest 1,000, so the mass lies within half of 1,000, that is 500, of the figure given. Working: 2,000 − 500 = 1,500 and 2,000 + 500 = 2,500. The lower limit is included, because 1,500 kg rounds up to 2,000 kg to 1 significant figure, while 2,500 kg rounds up to 3,000 kg, so the upper limit is not. Answer: 1,500 ≤ m < 2,500. The distractors: 1,950 ≤ m < 2,050 comes from rounding to the nearest 100 instead of to 1 significant figure; 1,000 ≤ m < 3,000 goes a whole 1,000 either side instead of half of it; 1,500 < m ≤ 2,500 has the two limits the wrong way round.
- (d) 50 km/h — The error intervals are 99.5 ≤ distance < 100.5 and 1.95 ≤ time < 2.05. The minimum speed is 99.5 ÷ 2.05 ≈ 48.54 km/h, and the maximum speed is 100.5 ÷ 1.95 ≈ 51.54 km/h. These two bounds round to different whole numbers, 49 and 52, so the speed cannot be guaranteed to the nearest whole number — but every value between them rounds to 50 at the nearest 10, so 50 km/h is the value that can safely be guaranteed. Quoting 49 km/h uses only the minimum bound's rounding, without checking that the maximum bound rounds to something different. Quoting 52 km/h makes the same mistake using only the maximum bound instead. Quoting 48.54 km/h states one bound to the full accuracy a calculator shows, as if the smallest possible speed were the answer, when the true speed could be anything up to 51.54 km/h.
- (a) 1/4 — The empty part of the tank is 80 − 60 = 20 litres. As a fraction of the full capacity, this is 20/80, which simplifies to 1/4. Finding the fraction of the tank that is FULL instead of empty, 60/80, simplifies to 3/4 — the wrong quantity for the question asked. Writing the empty amount over the amount remaining instead of over the full capacity, 20/60, simplifies to 1/3. Comparing the empty amount to 100 instead of to the tank's actual capacity of 80, 20/100, gives 1/5.
- (a) £18 — Method: the percentage acts as an operator on the bill, and 15% can be built from 10% and 5%, where 5% is half of 10%. Working: 10% of £120 is £120 ÷ 10 = £12, and 5% is half of that, £6, so the charge is £12 + £6 = £18. Answer: £18. The distractors: £8 comes from reading 15% as one fifteenth and working out £120 ÷ 15 = £8; £12 comes from finding 10% of the bill and stopping there; £138 comes from finding the charge correctly and then giving the new total, £120 + £18, rather than the charge the question asks for.
- (d) 0.024 cm — Method: significant figures are counted from the first non-zero digit; the zeros in front of it only fix the place value and are not significant. Working: in 0.02384 the first significant figure is 2 and the second is 3, so the rounding is decided by the next digit, 8. As 8 is 5 or more, the second significant figure goes up from 3 to 4, in the same place value. Answer: 0.024 cm. The distractors: 0.023 cm comes from chopping the 84 off instead of rounding it; 0.02 cm comes from counting the leading zeros as significant figures, so the 2 is taken as the second figure and the rounding stops there; 0.0238 cm is 0.02384 correct to 3 significant figures, one figure too many.
- (b) 18.5 ≤ T < 18.7 — Method: the error interval reaches half the rounding unit either side of the recorded value. Working: half of 0.2 is 0.1, so the interval runs from 18.6 − 0.1 to 18.6 + 0.1. Answer: 18.5 ≤ T < 18.7. (18.4 ≤ T < 18.8 comes from using the full rounding unit, 0.2, either side instead of half of it. 18.5 ≤ T ≤ 18.7 comes from including the upper bound with ≤ instead of excluding it with <. 18.6 ≤ T < 18.8 comes from treating the recorded value as the start of the interval and adding the whole rounding unit, 0.2, above it.)
- (a) 8 litres per minute — Method: write the time as a decimal number of minutes, then divide the volume by the time. Working: 30 seconds = 30/60 minute = 0.5 minute, so 2 minutes 30 seconds = 2.5 minutes. Rate = 20 ÷ 2.5 = 8 litres per minute. Answer: 8 litres per minute. (10 litres per minute comes from ignoring the extra 30 seconds and dividing by 2 minutes only. 8.7 litres per minute comes from misreading 2 minutes 30 seconds as 2.3 minutes instead of 2.5 minutes. 0.125 litres per minute comes from dividing the time by the volume instead of the volume by the time.)
- (d) 64 — Method: each time the power increases by 1, the value doubles, since one more 2 is multiplied in. Working: 2⁶ = 2⁵ × 2 = 32 × 2 = 64. Answer: 64. (37 comes from adding the power to the value, 32 + 5, instead of multiplying by the base. 192 comes from multiplying 32 by the new power, 6, instead of by the base, 2. 34 comes from adding the base to the value, 32 + 2, instead of multiplying.)
Build your own mix at the worksheet builder.