Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 360 — There are 5 choices for the letter. The first digit can be any of the 9 digits from 1 to 9, giving 9 choices, and the second digit must differ from the first, leaving 8 choices. By the product rule, the number of PINs is 5 × 9 × 8 = 360. Allowing the second digit to repeat the first, ignoring the 'no digit twice' rule, gives 5 × 9 × 9 = 405. Adding the numbers of choices instead of multiplying them, 5 + 9 + 8, gives 22. Treating the pair of digits as an unordered choice, rather than as a first digit followed by a second digit in a fixed order, halves the digit count: 5 × (9 × 8 ÷ 2) = 180.
- (b) 6.4 × 10⁸ — There are 5 letter positions, each with 23 choices, and 2 digit positions, each with 10 choices, and every position is independent because repeats are allowed. By the product rule, the total is 23⁵ × 10² = 6,436,343 × 100 = 643,634,300, which is 6.4 × 10⁸ to 2 significant figures. Using all 26 letters instead of the 23 that are actually allowed, ignoring the excluded letters entirely, gives 26⁵ × 10² = 1,188,137,600, which is 1.2 × 10⁹ to 2 significant figures. Adding the seven counts of choices instead of multiplying them, 23 + 23 + 10 + 10 + 23 + 23 + 23, gives 135, which is 1.4 × 10² to 2 significant figures — a total far too small for seven independent positions. Swapping which count of choices belongs to letters and which belongs to digits, working out 23² × 10⁵ instead of 23⁵ × 10², gives 52,900,000, which is 5.3 × 10⁷ to 2 significant figures.
- (c) Sam is correct — The leading zeros in 0.070268 are not significant, so the first three significant figures are 7, 0 and 2. The next digit along is 6, and since 6 is 5 or more, the third significant figure rounds up from 2 to 3, giving 0.0703. This means Sam's answer is correct. Writing 0.070 keeps only 2 significant figures, one short of what was asked. Writing 0.0702 ignores the digit 6 that follows and leaves the third figure unrounded. Writing 0.0704 rounds the third figure up twice, as if a later digit had also pushed it up.
- (c) 11 — Method: work out the total number of combinations as if there were no restriction, then subtract the one combination that is not allowed. Working: without any restriction there are 4 backdrops × 3 outfits = 12 combinations. The grey backdrop with the formal suit is not allowed, removing 1 combination: 12 − 1 = 11. Answer: 11. 12 comes from forgetting to remove the combination that is not allowed. 8 comes from removing the entire formal suit outfit from the count instead of just the one combination with the grey backdrop. 10 comes from removing two combinations instead of just the one that is not allowed.
- (c) 0.0065 — Leading zeros are never significant, so counting from the first non-zero digit, the first two significant figures of 0.006482 are 6 and 4. Look at the next digit along, 8, to decide whether the second figure rounds up: since 8 is 5 or more, the 4 rounds up to 5, giving 0.0065. Rounding to 2 decimal places instead of 2 significant figures gives 0.01, which answers a different question. Wrongly counting one of the leading zeros as a significant figure and stopping one figure short gives 0.006. Keeping an extra digit, as in 0.00648, gives 3 significant figures rather than 2.
- (c) 4 × 10⁴ — 8 ÷ 2 = 4, and 6 − 2 = 4, so each project receives 4 × 10⁴ pounds. Multiplying the exponents instead of subtracting them gives 6 × 2 = 12, so 4 × 10¹². Adding the exponents instead of subtracting them gives 6 + 2 = 8, so 4 × 10⁸. Subtracting the coefficients instead of dividing them gives 8 − 2 = 6, so 6 × 10⁴.
- (a) 4,000 nanometres — Method: the number of nanometres is the diameter divided by the length of one nanometre, and dividing powers of ten means subtracting the indices. Working: −6 − (−9) = 3, so 10⁻⁶ ÷ 10⁻⁹ = 10³, and the diameter is 4 × 10³ nanometres. Answer: 4,000 nanometres. The distractors: 400 nanometres comes from taking the difference between the indices as 2 instead of 3; 4 nanometres comes from changing the name of the unit without converting, leaving the coefficient untouched; 0.004 nanometres comes from dividing by 10³ instead of multiplying by it, as though a nanometre were the larger of the two units.
- (d) £6 — First find 30% of £200, which is £60, then find 10% of that: £60 × 0.1 = £6. Adding the two percentages together instead of applying them one after the other, 10% + 30% = 40%, and finding 40% of £200 gives £80. Finding 30% of £200 = £60 correctly but stopping before applying the second percentage leaves £60 as the final answer. Finding only 10% of the original £200, ignoring the 30% entirely, gives £20.
- (d) 50 km/h — The error intervals are 99.5 ≤ distance < 100.5 and 1.95 ≤ time < 2.05. The minimum speed is 99.5 ÷ 2.05 ≈ 48.54 km/h, and the maximum speed is 100.5 ÷ 1.95 ≈ 51.54 km/h. These two bounds round to different whole numbers, 49 and 52, so the speed cannot be guaranteed to the nearest whole number — but every value between them rounds to 50 at the nearest 10, so 50 km/h is the value that can safely be guaranteed. Quoting 49 km/h uses only the minimum bound's rounding, without checking that the maximum bound rounds to something different. Quoting 52 km/h makes the same mistake using only the maximum bound instead. Quoting 48.54 km/h states one bound to the full accuracy a calculator shows, as if the smallest possible speed were the answer, when the true speed could be anything up to 51.54 km/h.
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (c) 20p — Turn each price into the same rate before comparing. The small bag is 400 g = 0.4 kg, so it costs £1.12 ÷ 0.4 = £2.80 per kg. The large bag costs £3.90 ÷ 1.5 = £2.60 per kg. The saving is £2.80 − £2.60 = £0.20, which is 20p per kg. 2p compares the prices per 100 g rather than per kilogram, £2.78 subtracts one bag price from the other without turning either into a rate, and £2.60 is the large bag's price per kilogram rather than the saving.
- (d) £143 — From 09:15 to 12:45 is 3 hours 30 minutes, which is 3.5 hours. The charge for the time is 3.5 × £28 = £98, and the call-out fee is added on once: £98 + £45 = £143. £98 leaves out the call-out fee altogether, £129 charges for 3 hours instead of 3.5 hours, and £255.50 adds the fee to the hourly rate before multiplying, which charges the £45 for every hour.
- (c) 3 × 10⁶ — Daily revenue = (4 × 10³) × 2.5 = 1 × 10⁴ (£10,000). Multiplying by the number of days, (3 × 10²), gives annual revenue = (1 × 10⁴) × (3 × 10²) = 3 × 10⁶ (£3,000,000). A candidate who forgot to multiply by the price and just multiplied the number of items by the number of days worked out (4 × 10³) × (3 × 10²) = 1.2 × 10⁶. A candidate who added the number of days to the daily revenue instead of multiplying worked out 1 × 10⁴ + 3 × 10² = 1.03 × 10⁴. A candidate who misread £2.50 as £25 worked out a daily revenue of (4 × 10³) × 25 = 1 × 10⁵, giving an annual total of (1 × 10⁵) × (3 × 10²) = 3 × 10⁷.
- (b) 3 — Method: list all valid two-digit numbers that can be made without starting with 0, then keep only the ones that are multiples of 5. Working: the two-digit numbers possible are 30, 35, 50 and 53. A number is a multiple of 5 only if it ends in 0 or 5: 30 ends in 0, 35 ends in 5, 50 ends in 0, but 53 ends in 3. So there are 3 multiples of 5. Answer: 3. 4 comes from including 53 as a multiple of 5 without checking that its last digit is not 0 or 5. 2 comes from leaving out 50, wrongly assuming 0 cannot be used as the second digit either. 6 comes from listing every two-digit arrangement of the three digits, including ones that start with 0, without applying either restriction.
- (a) 0.55, 58%, 3/5 — Converting all three to decimals: 3/5 = 0.6, 0.55 stays as 0.55, and 58% = 0.58. In order from smallest to largest, this is 0.55, then 58%, then 3/5. Writing the numbers in the reverse order, largest to smallest, gives 3/5, 58%, 0.55. Misconverting 3/5 as 0.5 instead of 0.6 makes it appear smaller than both other values, giving the order 3/5, 0.55, 58%. Misconverting 58% as 0.058 instead of 0.58, by moving the decimal point two extra places, makes it appear smallest of the three, giving the order 58%, 0.55, 3/5.
Build your own mix at the worksheet builder.