Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 9π cm² — The area of a circle is π × r². With a radius of 3 cm this is π × 3² = 9π cm², and this is exact because π has not been replaced by any approximation. Writing 28.3 cm² replaces π with a rounded decimal value, 3.14, and then rounds the result again, so it is only an approximation. Writing 28.26 cm² uses π ≈ 3.14 without a final rounding step, but this is still only an approximation of 9π, not the exact value. Writing 27 cm² comes from replacing π with the rough approximation 3, which is even further from the true value.
- (d) 1.2 × 10⁵ — 4 × 3 = 12, and 3 + 1 = 4, giving 12 × 10⁴ — but 12 is not between 1 and 10, so this must be rewritten as 1.2 × 10⁵. Stopping at 12 × 10⁴ without rewriting it leaves the coefficient out of range. Rewriting 12 as 1.2 but leaving the exponent at 4 instead of increasing it to 5 gives 1.2 × 10⁴, which is ten times too small. Adding the coefficients instead of multiplying them gives 4 + 3 = 7, so 7 × 10⁴.
- (c) 12.44 — The error intervals are 155.5 ≤ mass < 156.5 and 11.5 ≤ volume < 12.5. To make a quotient as small as possible, use the SMALLEST possible numerator together with the LARGEST possible denominator: 155.5 ÷ 12.5 = 12.44 g/cm³. Using the lower bound for both mass and volume, 155.5 ÷ 11.5 ≈ 13.52, forgets that dividing by a smaller number makes the result bigger, not smaller — that pairing does not give a minimum at all. Dividing the two given rounded values directly, 156 ÷ 12 = 13, ignores that both measurements have their own error interval. Using the upper bound of mass with the upper bound of volume, 156.5 ÷ 12.5 = 12.52, takes both bounds the same way round; it is neither the minimum nor the maximum, since the maximum needs the largest mass with the smallest volume, 156.5 ÷ 11.5 ≈ 13.61.
- (a) 1/4 — The empty part of the tank is 80 − 60 = 20 litres. As a fraction of the full capacity, this is 20/80, which simplifies to 1/4. Finding the fraction of the tank that is FULL instead of empty, 60/80, simplifies to 3/4 — the wrong quantity for the question asked. Writing the empty amount over the amount remaining instead of over the full capacity, 20/60, simplifies to 1/3. Comparing the empty amount to 100 instead of to the tank's actual capacity of 80, 20/100, gives 1/5.
- (c) 12.3 ≤ t < 12.4 — Method: truncating cuts the later digits off instead of rounding them, so nothing is ever pushed upwards. The displayed value is therefore the smallest the time can be, and the time can run up to, but not reach, the next value the display can show. Working: the display reads 12.3, so the actual time is at least 12.3 seconds; as soon as the time reaches 12.3 + 0.1 = 12.4 seconds the display would read 12.4, so 12.4 is not included. Answer: 12.3 ≤ t < 12.4. The distractors: 12.25 ≤ t < 12.35 is the interval for a time rounded to 1 decimal place, and this display does not round; 12.3 < t ≤ 12.4 excludes the one value the display certainly allows and includes the one it rules out; 12.3 ≤ t ≤ 12.4 treats 12.4 seconds as possible, but at 12.4 seconds the display would no longer read 12.3.
- (a) 33.2 — The radius was rounded to 1 decimal place, so its error interval is 3.15 ≤ r < 3.25. The upper bound for the area uses the upper bound of the radius, squared: area = π × 3.25² ≈ 33.183, which rounds to 33.2 m² (3 s.f.). Using the given value of the radius directly instead of its upper bound, π × 3.2² ≈ 32.2, ignores that the radius itself has a range of possible values. Bounding the radius correctly but forgetting to square it, using area = π × 3.25 ≈ 10.2 instead of π × 3.25², drops the whole squaring step from the area formula. Using the LOWER bound of the radius instead of the upper one, π × 3.15² ≈ 31.2, finds the lower bound of the area, not the upper one.
- (a) 200 g — One quarter of 160 g is 40 g. Increasing the amount means adding this on: 160 + 40 = 200 g. Finding the increase, 1/4 of 160 = 40 g, but stopping there without adding it to the original amount leaves just 40 g. Using 4/5 instead of 5/4 as the scaling fraction, 160 × 4/5 = 128 g, actually decreases the amount rather than increasing it. Increasing by a half instead of a quarter, 160 + 80 = 240 g, uses the wrong fraction of 160.
- (c) 5 — Method: work out the volume of one box, divide the total volume by it, then round down since a partial box cannot fit. Working: volume of one box = 7³ = 343 cm³. 2000 ÷ 343 = 5.83 (2 d.p.). Since only whole boxes fit, the greatest number is 5. Answer: 5. (6 comes from rounding 5.83 up to the nearest whole number instead of rounding down to the number of boxes that actually fit. 343 comes from giving the volume of one box instead of the number of boxes. 5.8 comes from leaving the division as a decimal instead of rounding down to a whole number of boxes.)
- (a) 40 — Method: a number is odd exactly when its units digit is odd, so the restricted position is filled first and the two free positions are then filled from the digits that are left, multiplying the number of choices at each stage. Working: of the six digits only 3 and 9 are odd, so there are 2 choices for the units digit; once that digit has been used, 5 digits remain for the hundreds position and then 4 remain for the tens position, so the count is 2 × 5 × 4 = 40. Answer: 40. The distractors: 120 comes from ignoring the word odd altogether and counting every three-digit number that can be made from the six digits, 6 × 5 × 4; 60 comes from filling the hundreds and tens positions first, 6 then 5, and only then allowing 2 odd digits for the units position, which overcounts because one of 3 and 9 may already have been used, giving 6 × 5 × 2; 72 comes from restricting the units digit to 3 or 9 correctly but overlooking the condition that no digit may be used twice, so all six digits are still counted as available for each of the other two positions, giving 2 × 6 × 6.
- (b) £45 — Since 2/3 of the amount is £30, one third is £30 ÷ 2 = £15, and the whole amount is three thirds: £15 × 3 = £45. Applying the fraction forwards to £30 instead of reversing it, £30 × 2/3 = £20, treats the given amount as the whole rather than as two thirds of it. Finding one third correctly as £15 but forgetting to multiply by 3 to get the whole amount leaves £15 as the final answer. Reading £30 as one third of the amount rather than as two thirds, and so multiplying straight by 3, gives £30 × 3 = £90.
- (a) 1,850 — Method: find the error interval, then check which value falls outside it. Working: half of 100 is 50, so the actual number of visitors, v, satisfies 1,750 ≤ v < 1,850. 1,850 sits exactly on the excluded upper boundary, since a value of 1,850 would round to 1,900, not 1,800. Answer: 1,850. (1,750 is a genuine possible value — it sits at the included lower boundary. 1,799 is a genuine possible value, just below the upper boundary. 1,760 is a genuine possible value, well inside the interval.)
- (a) The tape can only give the length to the nearest centimetre — Method: a measurement should never be written to a finer degree of accuracy than the instrument used can read. Working: the tape is marked in centimetres, so the smallest division Leah can read is 1 cm, which is 0.01 m and two decimal places in metres; writing 7.3157 m claims the length to the nearest tenth of a millimetre, four decimal places, which the markings cannot support. A record of 7.32 m, to the nearest centimetre, is what this tape justifies. Answer: The tape can only give the length to the nearest centimetre. The distractors: the nearest millimetre contradicts the markings described in the question, which are centimetres, and would still claim more accuracy than the tape offers; the rule that a length in metres must be written to 2 decimal places borrows the habit of writing money to the penny, when the accuracy of a length depends on the instrument; rounding to the nearest metre would throw away accuracy the tape genuinely provides.
- (c) 4 × 10⁴ — 8 ÷ 2 = 4, and 6 − 2 = 4, so each project receives 4 × 10⁴ pounds. Multiplying the exponents instead of subtracting them gives 6 × 2 = 12, so 4 × 10¹². Adding the exponents instead of subtracting them gives 6 + 2 = 8, so 4 × 10⁸. Subtracting the coefficients instead of dividing them gives 8 − 2 = 6, so 6 × 10⁴.
- (a) −4.5 °C — Order the temperatures by their actual value on a number line, remembering that a more negative number is further below zero and therefore colder: −4.5 °C is the coldest, since it is further below zero than −4.05 °C, −3.8 °C or 2 °C. Comparing the digits 405 and 45 as though the decimal points lined up, without padding −4.5 to match the number of decimal places in −4.05 first, makes −4.05 °C look like it has the bigger size, so it gets picked as the coldest by mistake — in fact −4.05 °C is closer to zero than −4.5 °C, not further from it. Picking −3.8 °C comes from choosing the negative reading with the smallest absolute value, forgetting that for negative numbers, a smaller absolute value means a warmer, less negative temperature, not a colder one. Picking 2 °C comes from ignoring the negative signs on the other three readings altogether and comparing raw digit sizes, when in fact any negative temperature is colder than any positive temperature. So the coldest temperature is −4.5 °C.
- (c) Sam is correct — The leading zeros in 0.070268 are not significant, so the first three significant figures are 7, 0 and 2. The next digit along is 6, and since 6 is 5 or more, the third significant figure rounds up from 2 to 3, giving 0.0703. This means Sam's answer is correct. Writing 0.070 keeps only 2 significant figures, one short of what was asked. Writing 0.0702 ignores the digit 6 that follows and leaves the third figure unrounded. Writing 0.0704 rounds the third figure up twice, as if a later digit had also pushed it up.
Build your own mix at the worksheet builder.