Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) £384.00 — Adding 20% VAT means multiplying the price by 1.2: £320 × 1.2 = £384.00. Treating the 20% as a flat £20 rather than a percentage of the price, £320 + £20, gives £340.00. Working out the VAT amount alone, £320 × 0.2 = £64.00, and stopping there without adding it back to the original price gives just the VAT, not the total price. Misplacing the decimal point and using 2% instead of 20%, £320 × 1.02, gives £326.40.
- (d) £4.80 — Method: find the error interval, then check which value falls outside it. Working: half of 20p is 10p, so the actual cost, c, satisfies £4.50 ≤ c < £4.70. £4.80 is above £4.70, so it could not be the actual cost. Answer: £4.80. (£4.50 is a genuine possible cost — it sits at the included lower boundary. £4.65 is a genuine possible cost, below the £4.70 upper boundary. £4.55 is a genuine possible cost, well inside the interval.)
- (d) 50 km/h — The error intervals are 99.5 ≤ distance < 100.5 and 1.95 ≤ time < 2.05. The minimum speed is 99.5 ÷ 2.05 ≈ 48.54 km/h, and the maximum speed is 100.5 ÷ 1.95 ≈ 51.54 km/h. These two bounds round to different whole numbers, 49 and 52, so the speed cannot be guaranteed to the nearest whole number — but every value between them rounds to 50 at the nearest 10, so 50 km/h is the value that can safely be guaranteed. Quoting 49 km/h uses only the minimum bound's rounding, without checking that the maximum bound rounds to something different. Quoting 52 km/h makes the same mistake using only the maximum bound instead. Quoting 48.54 km/h states one bound to the full accuracy a calculator shows, as if the smallest possible speed were the answer, when the true speed could be anything up to 51.54 km/h.
- (d) 60 mph — Average speed = distance ÷ time, with the time measured in hours. 45 minutes is 45/60 of an hour, which is 0.75 of an hour, so the journey takes 1.75 hours. Speed = 105 ÷ 1.75 = 60 mph. 52.5 mph rounds the time up to 2 hours, 72.4 mph writes 1 hour 45 minutes as 1.45 hours, and 183.75 mph multiplies the distance by the time instead of dividing.
- (c) 8 hours 35 minutes — From 21:35 to midnight is 2 hours 25 minutes, and from midnight to 06:10 is a further 6 hours 10 minutes, giving a total of 8 hours 35 minutes. Misreading the departure time as 22:35 instead of 21:35 loses an hour from the calculation and gives 7 hours 35 minutes. Misreading the departure time as 20:35 instead of 21:35 gains an hour and gives 9 hours 35 minutes. Subtracting the times as if both fell on the same day, without crossing midnight, gives 15 hours 25 minutes.
- (d) 6 × 10⁷ — 3 × 2 = 6, and 2 + 5 = 7, so (3 × 10²) × (2 × 10⁵) = 6 × 10⁷. Multiplying the exponents instead of adding them gives 2 × 5 = 10, so 6 × 10¹⁰. Adding the coefficients instead of multiplying them gives 3 + 2 = 5, so 5 × 10⁷. Subtracting the exponents instead of adding them gives 5 − 2 = 3, so 6 × 10³.
- (c) 12.44 — The error intervals are 155.5 ≤ mass < 156.5 and 11.5 ≤ volume < 12.5. To make a quotient as small as possible, use the SMALLEST possible numerator together with the LARGEST possible denominator: 155.5 ÷ 12.5 = 12.44 g/cm³. Using the lower bound for both mass and volume, 155.5 ÷ 11.5 ≈ 13.52, forgets that dividing by a smaller number makes the result bigger, not smaller — that pairing does not give a minimum at all. Dividing the two given rounded values directly, 156 ÷ 12 = 13, ignores that both measurements have their own error interval. Using the upper bound of mass with the upper bound of volume, 156.5 ÷ 12.5 = 12.52, takes both bounds the same way round; it is neither the minimum nor the maximum, since the maximum needs the largest mass with the smallest volume, 156.5 ÷ 11.5 ≈ 13.61.
- (b) £13.48 — Method: an amount of money is written to the nearest penny, which is 2 decimal places, so the calculator display has to be rounded to 2 decimal places. Working: 53.90 ÷ 4 = 13.475, and the digit in the third decimal place is 5, so the penny digit goes up from 7 to 8. Answer: £13.48. The distractors: £13.47 comes from chopping the third decimal place off instead of rounding with it; £13.50 comes from rounding to the nearest 10p rather than to the nearest penny; £13.40 comes from cutting the display short at 1 decimal place, which is both the wrong degree of accuracy and a truncation rather than a rounding.
- (c) 12.3 ≤ t < 12.4 — Method: truncating cuts the later digits off instead of rounding them, so nothing is ever pushed upwards. The displayed value is therefore the smallest the time can be, and the time can run up to, but not reach, the next value the display can show. Working: the display reads 12.3, so the actual time is at least 12.3 seconds; as soon as the time reaches 12.3 + 0.1 = 12.4 seconds the display would read 12.4, so 12.4 is not included. Answer: 12.3 ≤ t < 12.4. The distractors: 12.25 ≤ t < 12.35 is the interval for a time rounded to 1 decimal place, and this display does not round; 12.3 < t ≤ 12.4 excludes the one value the display certainly allows and includes the one it rules out; 12.3 ≤ t ≤ 12.4 treats 12.4 seconds as possible, but at 12.4 seconds the display would no longer read 12.3.
- (c) 2.5 × 10⁶ — Divide the A values: 5 ÷ 2 = 2.5. Subtract the powers of 10: 4 − (−2) = 4 + 2 = 6. So the answer is 2.5 × 10⁶. A candidate who worked out 4 − 2 = 2, treating the subtraction of a negative as an ordinary subtraction, wrote 2.5 × 10². A candidate who subtracted in the wrong order, −2 − 4 = −6, wrote 2.5 × 10⁻⁶. A candidate who multiplied the A values instead of dividing, 5 × 2 = 10, and added the powers, 4 + (−2) = 2, then rewrote 10 × 10² in standard form as 1 × 10³.
- (a) 300 N/m² — Pressure is force ÷ area, and the unit N/m² says so: newtons divided by square metres. The calculation is 240 ÷ 0.8. Multiplying both numbers by 10 clears the decimal: 2400 ÷ 8 = 300 N/m². 192 N/m² multiplies the force by the area instead of dividing, 30 N/m² divides by 8 and so loses the decimal point, and 3000 N/m² multiplies only the force by 10 when clearing the decimal.
- (c) 36 — Method: set the outcomes out in a grid with one die along the top and the other down the side, so that every cell of the grid is one outcome, and count the cells. Working: the red die can land in 6 ways, so the grid has 6 columns, and the blue die can also land in 6 ways, so the grid has 6 rows; the number of cells is 6 × 6 = 36. Answer: 36. The distractors: 12 comes from adding 6 and 6 instead of multiplying them; 6 comes from counting the outcomes of a single die and forgetting that the second die also has to land; 21 comes from treating the two dice as indistinguishable, so that a red 2 with a blue 3 and a red 3 with a blue 2 are counted as one outcome.
- (c) 5 — Method: work out the volume of one box, divide the total volume by it, then round down since a partial box cannot fit. Working: volume of one box = 7³ = 343 cm³. 2000 ÷ 343 = 5.83 (2 d.p.). Since only whole boxes fit, the greatest number is 5. Answer: 5. (6 comes from rounding 5.83 up to the nearest whole number instead of rounding down to the number of boxes that actually fit. 343 comes from giving the volume of one box instead of the number of boxes. 5.8 comes from leaving the division as a decimal instead of rounding down to a whole number of boxes.)
- (b) £300 — The increased price is 110% of the original, so the original price = £330 ÷ 1.1 = £300. A candidate who finds 10% of £330 and subtracts it, wrongly treating £330 as the original, gets £330 − £33 = £297. A candidate who adds 10% of £330 again instead of reversing the increase gets £330 + £33 = £363. A candidate who divides by 0.1 instead of 1.1 gets £3,300.
- (a) 900 kg/m³ — Both parts of the compound unit change. There are 100 cm in a metre, so 1 m³ = 100³ = 1 000 000 cm³, and there are 1000 g in a kilogram. So 1 g/cm³ = 1 000 000 ÷ 1000 = 1000 kg/m³, and the plastic is 0.9 × 1000 = 900 kg/m³. 900 000 kg/m³ converts the volume but leaves the mass in grams, 0.0009 kg/m³ converts the mass but leaves the volume in cm³, and 0.09 kg/m³ uses the 100 cm in a metre without cubing it.
Build your own mix at the worksheet builder.