Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 30 — Method: 12% of an amount is 12/100 of it, so find 1% by dividing by 100 and then multiply by 12. Working: 1% of 250 is 250 ÷ 100 = 2.5, and 12% is 2.5 × 12 = 30. Answer: 30 seats. The distractors: 3 comes from writing 12% as 0.012 instead of 0.12, giving 0.012 × 250 = 3; 25 comes from finding 10% of the seats and stopping there; 24 comes from counting 12 seats for each whole hundred, 12 + 12 = 24, and ignoring the remaining 50 seats.
- (c) 8 hours 35 minutes — From 21:35 to midnight is 2 hours 25 minutes, and from midnight to 06:10 is a further 6 hours 10 minutes, giving a total of 8 hours 35 minutes. Misreading the departure time as 22:35 instead of 21:35 loses an hour from the calculation and gives 7 hours 35 minutes. Misreading the departure time as 20:35 instead of 21:35 gains an hour and gives 9 hours 35 minutes. Subtracting the times as if both fell on the same day, without crossing midnight, gives 15 hours 25 minutes.
- (c) 4 × 10⁴ — 8 ÷ 2 = 4, and 6 − 2 = 4, so each project receives 4 × 10⁴ pounds. Multiplying the exponents instead of subtracting them gives 6 × 2 = 12, so 4 × 10¹². Adding the exponents instead of subtracting them gives 6 + 2 = 8, so 4 × 10⁸. Subtracting the coefficients instead of dividing them gives 8 − 2 = 6, so 6 × 10⁴.
- (c) 360 — There are 5 choices for the letter. The first digit can be any of the 9 digits from 1 to 9, giving 9 choices, and the second digit must differ from the first, leaving 8 choices. By the product rule, the number of PINs is 5 × 9 × 8 = 360. Allowing the second digit to repeat the first, ignoring the 'no digit twice' rule, gives 5 × 9 × 9 = 405. Adding the numbers of choices instead of multiplying them, 5 + 9 + 8, gives 22. Treating the pair of digits as an unordered choice, rather than as a first digit followed by a second digit in a fixed order, halves the digit count: 5 × (9 × 8 ÷ 2) = 180.
- (a) 200 g — One quarter of 160 g is 40 g. Increasing the amount means adding this on: 160 + 40 = 200 g. Finding the increase, 1/4 of 160 = 40 g, but stopping there without adding it to the original amount leaves just 40 g. Using 4/5 instead of 5/4 as the scaling fraction, 160 × 4/5 = 128 g, actually decreases the amount rather than increasing it. Increasing by a half instead of a quarter, 160 + 80 = 240 g, uses the wrong fraction of 160.
- (a) £177.60 — Total raised = 240 × £1.85 = £444.00. The hospital receives 40% of this: £444.00 × 0.4 = £177.60. A candidate who works out the remaining 60% instead of the 40% given away gets £266.40. A candidate who forgets to find the percentage and gives the full total gets £444.00. A candidate who halves 40% by mistake and uses 20% gets £88.80.
- (a) −4.5 °C — Order the temperatures by their actual value on a number line, remembering that a more negative number is further below zero and therefore colder: −4.5 °C is the coldest, since it is further below zero than −4.05 °C, −3.8 °C or 2 °C. Comparing the digits 405 and 45 as though the decimal points lined up, without padding −4.5 to match the number of decimal places in −4.05 first, makes −4.05 °C look like it has the bigger size, so it gets picked as the coldest by mistake — in fact −4.05 °C is closer to zero than −4.5 °C, not further from it. Picking −3.8 °C comes from choosing the negative reading with the smallest absolute value, forgetting that for negative numbers, a smaller absolute value means a warmer, less negative temperature, not a colder one. Picking 2 °C comes from ignoring the negative signs on the other three readings altogether and comparing raw digit sizes, when in fact any negative temperature is colder than any positive temperature. So the coldest temperature is −4.5 °C.
- (a) 300 N/m² — Pressure is force ÷ area, and the unit N/m² says so: newtons divided by square metres. The calculation is 240 ÷ 0.8. Multiplying both numbers by 10 clears the decimal: 2400 ÷ 8 = 300 N/m². 192 N/m² multiplies the force by the area instead of dividing, 30 N/m² divides by 8 and so loses the decimal point, and 3000 N/m² multiplies only the force by 10 when clearing the decimal.
- (d) 1.6 × 10⁵ — 5.6 ÷ 3.5 = 1.6, and 7 − 2 = 5, so the average turnover per shop is 1.6 × 10⁵ pounds. Multiplying the exponents instead of subtracting them gives 7 × 2 = 14, so 1.6 × 10¹⁴. Adding the exponents instead of subtracting them gives 7 + 2 = 9, so 1.6 × 10⁹. Subtracting the coefficients instead of dividing them gives 5.6 − 3.5 = 2.1, so 2.1 × 10⁵.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (a) 7.5 × 10⁴ — Standard form is A × 10ⁿ, where A is between 1 and 10 (1 ≤ A < 10) and n is an integer — 7.5 × 10⁴ satisfies all of this. 12 × 10³ fails because 12 is not below 10. 0.5 × 10⁴ fails because 0.5 is not at least 1. 6.2 × 4⁵ fails because standard form always uses a power of 10, not a power of 4.
- (c) 62.35 ≤ r < 62.45 — Method: with a value rounded to 1 decimal place, the error interval reaches half of 0.1 either side. Working: half of 0.1 is 0.05, so the interval runs from 62.4 − 0.05 to 62.4 + 0.05. Answer: 62.35 ≤ r < 62.45. (62 ≤ r < 63 comes from rounding to the nearest whole number instead of 1 decimal place. 62.35 ≤ r ≤ 62.45 comes from including the upper bound with ≤ instead of excluding it with <. 62.3 ≤ r < 62.5 comes from using 0.1 either side instead of half of it.)
- (a) 56 — Method: count the ordered selections with the product rule first, then divide by the number of different orders in which any one committee could have been picked. Working: there are 8 choices for a first pupil, 7 for a second and 6 for a third, giving 8 × 7 × 6 = 336 ordered selections; any particular three pupils could have been picked in 3 × 2 × 1 = 6 orders, so the number of different committees is 336 ÷ 6 = 56. Answer: 56. The distractors: 336 comes from stopping at 8 × 7 × 6 and treating the three places as distinct posts when they are identical; 168 comes from dividing that product by 2 rather than by the 6 orders in which three chosen pupils can be listed; 24 comes from multiplying the 8 volunteers by the 3 places instead of multiplying the choices at each stage.
- (d) 64 — Method: each time the power increases by 1, the value doubles, since one more 2 is multiplied in. Working: 2⁶ = 2⁵ × 2 = 32 × 2 = 64. Answer: 64. (37 comes from adding the power to the value, 32 + 5, instead of multiplying by the base. 192 comes from multiplying 32 by the new power, 6, instead of by the base, 2. 34 comes from adding the base to the value, 32 + 2, instead of multiplying.)
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
Build your own mix at the worksheet builder.