Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 63 — 10% of 180 = 18, so 5% = 9. 35% = (3 × 18) + 9 = 54 + 9 = 63. A candidate who uses 25% instead of 35% gets 45. A candidate who doubles 35% to get 70% by mistake gets 126. A candidate who subtracts 35 from 180 instead of finding a percentage gets 145.
- (c) 12.44 — The error intervals are 155.5 ≤ mass < 156.5 and 11.5 ≤ volume < 12.5. To make a quotient as small as possible, use the SMALLEST possible numerator together with the LARGEST possible denominator: 155.5 ÷ 12.5 = 12.44 g/cm³. Using the lower bound for both mass and volume, 155.5 ÷ 11.5 ≈ 13.52, forgets that dividing by a smaller number makes the result bigger, not smaller — that pairing does not give a minimum at all. Dividing the two given rounded values directly, 156 ÷ 12 = 13, ignores that both measurements have their own error interval. Using the upper bound of mass with the upper bound of volume, 156.5 ÷ 12.5 = 12.52, takes both bounds the same way round; it is neither the minimum nor the maximum, since the maximum needs the largest mass with the smallest volume, 156.5 ÷ 11.5 ≈ 13.61.
- (a) The tape can only give the length to the nearest centimetre — Method: a measurement should never be written to a finer degree of accuracy than the instrument used can read. Working: the tape is marked in centimetres, so the smallest division Leah can read is 1 cm, which is 0.01 m and two decimal places in metres; writing 7.3157 m claims the length to the nearest tenth of a millimetre, four decimal places, which the markings cannot support. A record of 7.32 m, to the nearest centimetre, is what this tape justifies. Answer: The tape can only give the length to the nearest centimetre. The distractors: the nearest millimetre contradicts the markings described in the question, which are centimetres, and would still claim more accuracy than the tape offers; the rule that a length in metres must be written to 2 decimal places borrows the habit of writing money to the penny, when the accuracy of a length depends on the instrument; rounding to the nearest metre would throw away accuracy the tape genuinely provides.
- (a) 200 g — One quarter of 160 g is 40 g. Increasing the amount means adding this on: 160 + 40 = 200 g. Finding the increase, 1/4 of 160 = 40 g, but stopping there without adding it to the original amount leaves just 40 g. Using 4/5 instead of 5/4 as the scaling fraction, 160 × 4/5 = 128 g, actually decreases the amount rather than increasing it. Increasing by a half instead of a quarter, 160 + 80 = 240 g, uses the wrong fraction of 160.
- (c) 62.35 ≤ r < 62.45 — Method: with a value rounded to 1 decimal place, the error interval reaches half of 0.1 either side. Working: half of 0.1 is 0.05, so the interval runs from 62.4 − 0.05 to 62.4 + 0.05. Answer: 62.35 ≤ r < 62.45. (62 ≤ r < 63 comes from rounding to the nearest whole number instead of 1 decimal place. 62.35 ≤ r ≤ 62.45 comes from including the upper bound with ≤ instead of excluding it with <. 62.3 ≤ r < 62.5 comes from using 0.1 either side instead of half of it.)
- (d) 6 × 10⁷ — 3 × 2 = 6, and 2 + 5 = 7, so (3 × 10²) × (2 × 10⁵) = 6 × 10⁷. Multiplying the exponents instead of adding them gives 2 × 5 = 10, so 6 × 10¹⁰. Adding the coefficients instead of multiplying them gives 3 + 2 = 5, so 5 × 10⁷. Subtracting the exponents instead of adding them gives 5 − 2 = 3, so 6 × 10³.
- (b) 1.45 ≤ m < 1.55 — The flour's mass is labelled 1.5 kg, correct to the nearest 0.1 kg, so half of 0.1 kg is added to and subtracted from 1.5 kg to find the interval: 1.5 − 0.05 = 1.45 and 1.5 + 0.05 = 1.55, giving 1.45 ≤ m < 1.55. '1.4 ≤ m < 1.6' comes from taking the whole 0.1 kg as the margin either side, instead of half of it. '1.45 < m ≤ 1.55' comes from writing the inequality signs the wrong way round — the lower bound should be included and the upper bound excluded, not the other way round. '1.45 ≤ m ≤ 1.55' comes from including the upper bound, when the convention is that the upper bound is never actually reached.
- (d) 6,000,000 — Method: round each number to 1 significant figure, then subtract. Working: 8,340,000 rounds to 8,000,000 (1 s.f.); 1,950,000 rounds to 2,000,000 (1 s.f.); 8,000,000 − 2,000,000 = 6,000,000. Answer: 6,000,000. 6,390,000 is the exact difference, found without rounding the numbers first. 8,000,000 comes from rounding the population correctly but forgetting to subtract the capital's population at all. 6,300,000 comes from rounding 8,340,000 to the nearest hundred thousand, 8,300,000, instead of to 1 significant figure, then subtracting the correctly rounded 2,000,000.
- (a) 8 litres per minute — Method: write the time as a decimal number of minutes, then divide the volume by the time. Working: 30 seconds = 30/60 minute = 0.5 minute, so 2 minutes 30 seconds = 2.5 minutes. Rate = 20 ÷ 2.5 = 8 litres per minute. Answer: 8 litres per minute. (10 litres per minute comes from ignoring the extra 30 seconds and dividing by 2 minutes only. 8.7 litres per minute comes from misreading 2 minutes 30 seconds as 2.3 minutes instead of 2.5 minutes. 0.125 litres per minute comes from dividing the time by the volume instead of the volume by the time.)
- (a) the nearest whole number — The error intervals are 23.5 ≤ p < 24.5 and 5.5 ≤ q < 6.5. The minimum of p ÷ q is 23.5 ÷ 6.5 ≈ 3.615, and the maximum is 24.5 ÷ 5.5 ≈ 4.455. Both of these round to 4 at the nearest whole number, so the answer is guaranteed correct to the nearest whole number — but not to the nearest 0.1, since 3.615 rounds to 3.6 while 4.455 rounds to 4.5, which do not agree. Claiming the nearest 0.1 assumes every figure a calculator shows is trustworthy, without checking whether the bounds actually agree that far. Claiming only the nearest 10 badly understates how much can be guaranteed here, since both bounds already round to 4, not merely to 0. Saying no degree of accuracy can be guaranteed gives up before checking whether the bounds agree at any level at all.
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
- (d) 27/80 — Method: write the total as a fraction of a litre, then divide by the number of glasses. Working: 1.35 = 27/20, so each glass holds 27/20 ÷ 4 = 27/80 of a litre. Answer: 27/80. 27/20 comes from converting the total correctly to a fraction but forgetting to divide by the number of glasses. 27/5 comes from multiplying the total by 4 instead of dividing. 17/50 comes from rounding 1.35 ÷ 4 to 0.34 before converting to a fraction.
- (a) 7.5 × 10⁴ — Standard form is A × 10ⁿ, where A is between 1 and 10 (1 ≤ A < 10) and n is an integer — 7.5 × 10⁴ satisfies all of this. 12 × 10³ fails because 12 is not below 10. 0.5 × 10⁴ fails because 0.5 is not at least 1. 6.2 × 4⁵ fails because standard form always uses a power of 10, not a power of 4.
- (c) 8 hours 35 minutes — From 21:35 to midnight is 2 hours 25 minutes, and from midnight to 06:10 is a further 6 hours 10 minutes, giving a total of 8 hours 35 minutes. Misreading the departure time as 22:35 instead of 21:35 loses an hour from the calculation and gives 7 hours 35 minutes. Misreading the departure time as 20:35 instead of 21:35 gains an hour and gives 9 hours 35 minutes. Subtracting the times as if both fell on the same day, without crossing midnight, gives 15 hours 25 minutes.
- (d) £70 — Method: the discount is a percentage of the original price only, so work it out, subtract it, and add the fixed delivery charge afterwards. Working: 25% of £80 is £80 ÷ 4 = £20, so the discounted price is £80 − £20 = £60, and the total is £60 + £10 = £70. Answer: £70. The distractors: £60 comes from working out the discounted price and stopping there, leaving the delivery charge out of the total; £65 comes from taking £25 off the price instead of 25% of it, giving £80 − £25 = £55 and then £55 + £10 = £65; £67.50 comes from adding the delivery charge before the discount and reducing the whole amount, giving 75% of £90 = £67.50.
Build your own mix at the worksheet builder.