Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
- (a) 8 litres per minute — Method: write the time as a decimal number of minutes, then divide the volume by the time. Working: 30 seconds = 30/60 minute = 0.5 minute, so 2 minutes 30 seconds = 2.5 minutes. Rate = 20 ÷ 2.5 = 8 litres per minute. Answer: 8 litres per minute. (10 litres per minute comes from ignoring the extra 30 seconds and dividing by 2 minutes only. 8.7 litres per minute comes from misreading 2 minutes 30 seconds as 2.3 minutes instead of 2.5 minutes. 0.125 litres per minute comes from dividing the time by the volume instead of the volume by the time.)
- (b) 93.9975 — Each measurement was rounded to 1 decimal place, so the error is half of 0.1: length is 12.35 ≤ L < 12.45, and width is 7.45 ≤ W < 7.55. The upper bound for the area comes from multiplying the upper bounds of both dimensions: 12.45 × 7.55 = 93.9975 m². Using the lower bound of both dimensions instead, 12.35 × 7.45 = 92.0075 m², gives the lower bound of the area rather than the upper one. Multiplying the two given rounded values directly, 12.4 × 7.5 = 93, forgets that a rounded measurement is not exact and needs its own error interval. Bounding only the length and leaving the width at its given value, 12.45 × 7.5 = 93.375, misses that the width also has an upper bound of its own.
- (a) the nearest whole number — The error intervals are 23.5 ≤ p < 24.5 and 5.5 ≤ q < 6.5. The minimum of p ÷ q is 23.5 ÷ 6.5 ≈ 3.615, and the maximum is 24.5 ÷ 5.5 ≈ 4.455. Both of these round to 4 at the nearest whole number, so the answer is guaranteed correct to the nearest whole number — but not to the nearest 0.1, since 3.615 rounds to 3.6 while 4.455 rounds to 4.5, which do not agree. Claiming the nearest 0.1 assumes every figure a calculator shows is trustworthy, without checking whether the bounds actually agree that far. Claiming only the nearest 10 badly understates how much can be guaranteed here, since both bounds already round to 4, not merely to 0. Saying no degree of accuracy can be guaranteed gives up before checking whether the bounds agree at any level at all.
- (a) 0.55, 58%, 3/5 — Converting all three to decimals: 3/5 = 0.6, 0.55 stays as 0.55, and 58% = 0.58. In order from smallest to largest, this is 0.55, then 58%, then 3/5. Writing the numbers in the reverse order, largest to smallest, gives 3/5, 58%, 0.55. Misconverting 3/5 as 0.5 instead of 0.6 makes it appear smaller than both other values, giving the order 3/5, 0.55, 58%. Misconverting 58% as 0.058 instead of 0.58, by moving the decimal point two extra places, makes it appear smallest of the three, giving the order 58%, 0.55, 3/5.
- (b) 0.3, 32%, 7/20 — Method: convert every number to a decimal so they can be compared on the same scale. Working: 7/20 = 0.35, 0.3 stays as 0.3, and 32% = 0.32. Comparing 0.3, 0.32 and 0.35 in size gives the order 0.3, then 0.32, then 0.35. Answer: 0.3, 32%, 7/20. 7/20, 32%, 0.3 lists the numbers from largest to smallest instead of smallest to largest. 0.3, 7/20, 32% swaps 32% and 7/20, treating the fraction 7/20 as smaller even though 7/20 = 0.35 is bigger than 32% = 0.32. 32%, 0.3, 7/20 comes from moving the digits one place too far when converting the percentage, giving 0.032 instead of 0.32, which makes 32% look far smaller than it really is.
- (b) £13.48 — Method: an amount of money is written to the nearest penny, which is 2 decimal places, so the calculator display has to be rounded to 2 decimal places. Working: 53.90 ÷ 4 = 13.475, and the digit in the third decimal place is 5, so the penny digit goes up from 7 to 8. Answer: £13.48. The distractors: £13.47 comes from chopping the third decimal place off instead of rounding with it; £13.50 comes from rounding to the nearest 10p rather than to the nearest penny; £13.40 comes from cutting the display short at 1 decimal place, which is both the wrong degree of accuracy and a truncation rather than a rounding.
- (a) 1,500 ≤ m < 2,500 — Method: a four-digit figure written to 1 significant figure has been rounded to the nearest 1,000, so the mass lies within half of 1,000, that is 500, of the figure given. Working: 2,000 − 500 = 1,500 and 2,000 + 500 = 2,500. The lower limit is included, because 1,500 kg rounds up to 2,000 kg to 1 significant figure, while 2,500 kg rounds up to 3,000 kg, so the upper limit is not. Answer: 1,500 ≤ m < 2,500. The distractors: 1,950 ≤ m < 2,050 comes from rounding to the nearest 100 instead of to 1 significant figure; 1,000 ≤ m < 3,000 goes a whole 1,000 either side instead of half of it; 1,500 < m ≤ 2,500 has the two limits the wrong way round.
- (a) 33.2 — The radius was rounded to 1 decimal place, so its error interval is 3.15 ≤ r < 3.25. The upper bound for the area uses the upper bound of the radius, squared: area = π × 3.25² ≈ 33.183, which rounds to 33.2 m² (3 s.f.). Using the given value of the radius directly instead of its upper bound, π × 3.2² ≈ 32.2, ignores that the radius itself has a range of possible values. Bounding the radius correctly but forgetting to square it, using area = π × 3.25 ≈ 10.2 instead of π × 3.25², drops the whole squaring step from the area formula. Using the LOWER bound of the radius instead of the upper one, π × 3.15² ≈ 31.2, finds the lower bound of the area, not the upper one.
- (b) £45.90 — The cost is 18 × £3.45 = £62.10. Profit = £108 − £62.10 = £45.90. A candidate who does not borrow in the tenths column, doing 1 − 0 = 1 instead of borrowing to make 10 − 1 = 9 and so leaving the units as 8 − 2 = 6, gets £46.10. A candidate who adds the cost to the selling price instead of subtracting gets £108 + £62.10 = £170.10. A candidate who gives the cost instead of the profit gets £62.10.
- (b) £72 — One fifth of £60 = £12. New price = £60 + £12 = £72. A candidate who gives the increase instead of the new price gets £12. A candidate who subtracts the increase instead of adding it gets £60 − £12 = £48. A candidate who uses 1/4 instead of 1/5 gets £60 + £15 = £75.
- (a) 11:20 — Method: find the flight time using time = distance ÷ speed, then add this to the departure time. Working: 2340 ÷ 780 = 3 hours; 08:20 + 3 hours = 11:20. Answer: 11:20. 08:40 comes from dividing speed by distance instead of distance by speed, giving a flight time of 1/3 hour (20 minutes) rather than 3 hours. 11:00 comes from adding the 3-hour flight time to the hour of the departure time only, 8 + 3 = 11, and losing the 20 minutes. 03:00 comes from finding the flight time correctly but giving it as a clock time on its own, forgetting to add it to the departure time.
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (c) £196.35 — Method: convert both prices to pounds, multiply each by its quantity, then add the two totals. Working: 340 rolls at £0.24 each = £81.60; 85 cakes at £1.35 each = £114.75; £81.60 + £114.75 = £196.35. Answer: £196.35. £81.60 comes from working out the cost of the rolls only and forgetting to add the cost of the cakes. £114.75 comes from working out the cost of the cakes only and forgetting to add the cost of the rolls. £122.91 comes from converting 24p to £0.024 instead of £0.24, a place value error of a factor of 10 in the price of the rolls, before adding the correctly worked out cost of the cakes.
- (d) 1.6 × 10⁵ — 5.6 ÷ 3.5 = 1.6, and 7 − 2 = 5, so the average turnover per shop is 1.6 × 10⁵ pounds. Multiplying the exponents instead of subtracting them gives 7 × 2 = 14, so 1.6 × 10¹⁴. Adding the exponents instead of subtracting them gives 7 + 2 = 9, so 1.6 × 10⁹. Subtracting the coefficients instead of dividing them gives 5.6 − 3.5 = 2.1, so 2.1 × 10⁵.
Build your own mix at the worksheet builder.