Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 120 — There are 6 choices for the first digit. The second digit must be different from the first, leaving 5 choices, and the third digit must differ from both of the first two, leaving 4 choices. By the product rule, the number of codes is 6 × 5 × 4 = 120. Allowing every digit to repeat, ignoring the 'no digit twice' rule entirely, gives 6 × 6 × 6 = 216. Adding the number of choices at each position instead of multiplying them, 6 + 5 + 4, gives 15. Treating the three chosen digits as one unordered set, rather than as digits in a fixed order on the padlock, divides by the 3! = 6 ways of arranging them: 120 ÷ 6 = 20.
- (c) 11 — Method: work out the total number of combinations as if there were no restriction, then subtract the one combination that is not allowed. Working: without any restriction there are 4 backdrops × 3 outfits = 12 combinations. The grey backdrop with the formal suit is not allowed, removing 1 combination: 12 − 1 = 11. Answer: 11. 12 comes from forgetting to remove the combination that is not allowed. 8 comes from removing the entire formal suit outfit from the count instead of just the one combination with the grey backdrop. 10 comes from removing two combinations instead of just the one that is not allowed.
- (a) The tape can only give the length to the nearest centimetre — Method: a measurement should never be written to a finer degree of accuracy than the instrument used can read. Working: the tape is marked in centimetres, so the smallest division Leah can read is 1 cm, which is 0.01 m and two decimal places in metres; writing 7.3157 m claims the length to the nearest tenth of a millimetre, four decimal places, which the markings cannot support. A record of 7.32 m, to the nearest centimetre, is what this tape justifies. Answer: The tape can only give the length to the nearest centimetre. The distractors: the nearest millimetre contradicts the markings described in the question, which are centimetres, and would still claim more accuracy than the tape offers; the rule that a length in metres must be written to 2 decimal places borrows the habit of writing money to the penny, when the accuracy of a length depends on the instrument; rounding to the nearest metre would throw away accuracy the tape genuinely provides.
- (a) £600 — Method: round the number of cakes and the price of each cake to 1 significant figure, then multiply the rounded values. Working: 187 rounds to 200, and £2.95 rounds to £3 (the digit after the first, 9, rounds the 2 up to 3), so the estimate is 200 × £3 = £600. £400 comes from rounding £2.95 down to £2 instead of up to £3, giving 200 × £2 = £400. £561 comes from rounding only the price and using the exact number of cakes, 187 × £3 = £561. £570 comes from rounding 187 to the nearest 10 as 190 instead of to 1 significant figure as 200, giving 190 × £3 = £570. Answer: £600.
- (a) 4,000 nanometres — Method: the number of nanometres is the diameter divided by the length of one nanometre, and dividing powers of ten means subtracting the indices. Working: −6 − (−9) = 3, so 10⁻⁶ ÷ 10⁻⁹ = 10³, and the diameter is 4 × 10³ nanometres. Answer: 4,000 nanometres. The distractors: 400 nanometres comes from taking the difference between the indices as 2 instead of 3; 4 nanometres comes from changing the name of the unit without converting, leaving the coefficient untouched; 0.004 nanometres comes from dividing by 10³ instead of multiplying by it, as though a nanometre were the larger of the two units.
- (a) 8.15 ≤ y < 8.25 — Rounding to 1 decimal place means the error interval spans half of 0.1, so 0.05, either side of 8.2: 8.2 − 0.05 = 8.15 and 8.2 + 0.05 = 8.25. The lower bound uses ≤ because 8.15 itself rounds to 8.2, but the upper bound uses < because 8.25 would round up to 8.3. So the error interval is 8.15 ≤ y < 8.25. A candidate who used the wrong rounding band gave 8.1 ≤ y < 8.2. A candidate who used a strict inequality at both ends wrote 8.15 < y < 8.25, wrongly excluding 8.15 itself. A candidate who added the full 0.1 instead of half of it wrote 8.2 ≤ y < 8.3.
- (c) £384.00 — Adding 20% VAT means multiplying the price by 1.2: £320 × 1.2 = £384.00. Treating the 20% as a flat £20 rather than a percentage of the price, £320 + £20, gives £340.00. Working out the VAT amount alone, £320 × 0.2 = £64.00, and stopping there without adding it back to the original price gives just the VAT, not the total price. Misplacing the decimal point and using 2% instead of 20%, £320 × 1.02, gives £326.40.
- (c) 8 hours 35 minutes — From 21:35 to midnight is 2 hours 25 minutes, and from midnight to 06:10 is a further 6 hours 10 minutes, giving a total of 8 hours 35 minutes. Misreading the departure time as 22:35 instead of 21:35 loses an hour from the calculation and gives 7 hours 35 minutes. Misreading the departure time as 20:35 instead of 21:35 gains an hour and gives 9 hours 35 minutes. Subtracting the times as if both fell on the same day, without crossing midnight, gives 15 hours 25 minutes.
- (a) 8 × 10³ — Method: divide the capacity of the card by the size of one photograph, dividing the coefficients and subtracting the indices, then bring the coefficient back into the range 1 to 10. Working: 3.2 ÷ 4 = 0.8 and 10 − 6 = 4, which gives 0.8 × 10⁴; a coefficient of 0.8 is smaller than 1, so the decimal point moves one place to the right and the index falls by 1. Answer: 8 × 10³. The distractors: 8 × 10⁴ comes from correcting 0.8 to 8 without reducing the index, which makes the answer ten times too large; 1.28 × 10¹⁷ comes from multiplying the two numbers instead of dividing them, since 3.2 × 4 = 12.8 and 10 + 6 = 16; 8 × 10¹⁵ comes from dividing the coefficients but adding the indices instead of subtracting them.
- (d) 24.69 — To round to 2 decimal places, look only at the third decimal digit to decide whether the second decimal digit rounds up. In 24.6851 the third decimal digit is 5, and since 5 is 5 or more, the second decimal digit rounds up from 8 to 9, giving 24.69. Rounding to 1 decimal place instead of 2 gives 24.7, one place value too coarse. Keeping the third decimal digit rather than dropping it gives 24.685, which is 3 decimal places. Looking at the fourth decimal digit, 1, instead of the third one, and wrongly deciding that no rounding is needed, leaves the length unrounded at 24.68.
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
- (c) 12.3 ≤ t < 12.4 — Method: truncating cuts the later digits off instead of rounding them, so nothing is ever pushed upwards. The displayed value is therefore the smallest the time can be, and the time can run up to, but not reach, the next value the display can show. Working: the display reads 12.3, so the actual time is at least 12.3 seconds; as soon as the time reaches 12.3 + 0.1 = 12.4 seconds the display would read 12.4, so 12.4 is not included. Answer: 12.3 ≤ t < 12.4. The distractors: 12.25 ≤ t < 12.35 is the interval for a time rounded to 1 decimal place, and this display does not round; 12.3 < t ≤ 12.4 excludes the one value the display certainly allows and includes the one it rules out; 12.3 ≤ t ≤ 12.4 treats 12.4 seconds as possible, but at 12.4 seconds the display would no longer read 12.3.
- (a) 6 × 10² metres — Method: distance = speed × time, so multiply the coefficients and add the indices. Working: 3 × 2 = 6 for the coefficients, and 8 + (−6) = 2 for the indices; 6 lies between 1 and 10, so the coefficient needs no adjustment. Answer: 6 × 10² metres, which is 600 metres. The distractors: 5 × 10² metres comes from adding the coefficients, 3 + 2, instead of multiplying them; 6 × 10¹⁴ metres comes from subtracting the indices, 8 − (−6), which is the rule for dividing rather than for multiplying; 6 × 10⁻⁴⁸ metres comes from multiplying the indices, 8 × (−6), instead of adding them.
- (d) 64 — Method: each time the power increases by 1, the value doubles, since one more 2 is multiplied in. Working: 2⁶ = 2⁵ × 2 = 32 × 2 = 64. Answer: 64. (37 comes from adding the power to the value, 32 + 5, instead of multiplying by the base. 192 comes from multiplying 32 by the new power, 6, instead of by the base, 2. 34 comes from adding the base to the value, 32 + 2, instead of multiplying.)
- (d) £70 — Method: the discount is a percentage of the original price only, so work it out, subtract it, and add the fixed delivery charge afterwards. Working: 25% of £80 is £80 ÷ 4 = £20, so the discounted price is £80 − £20 = £60, and the total is £60 + £10 = £70. Answer: £70. The distractors: £60 comes from working out the discounted price and stopping there, leaving the delivery charge out of the total; £65 comes from taking £25 off the price instead of 25% of it, giving £80 − £25 = £55 and then £55 + £10 = £65; £67.50 comes from adding the delivery charge before the discount and reducing the whole amount, giving 75% of £90 = £67.50.
Build your own mix at the worksheet builder.