Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 27/80 — Method: write the total as a fraction of a litre, then divide by the number of glasses. Working: 1.35 = 27/20, so each glass holds 27/20 ÷ 4 = 27/80 of a litre. Answer: 27/80. 27/20 comes from converting the total correctly to a fraction but forgetting to divide by the number of glasses. 27/5 comes from multiplying the total by 4 instead of dividing. 17/50 comes from rounding 1.35 ÷ 4 to 0.34 before converting to a fraction.
- (d) 1.6 × 10⁵ — 5.6 ÷ 3.5 = 1.6, and 7 − 2 = 5, so the average turnover per shop is 1.6 × 10⁵ pounds. Multiplying the exponents instead of subtracting them gives 7 × 2 = 14, so 1.6 × 10¹⁴. Adding the exponents instead of subtracting them gives 7 + 2 = 9, so 1.6 × 10⁹. Subtracting the coefficients instead of dividing them gives 5.6 − 3.5 = 2.1, so 2.1 × 10⁵.
- (a) The tape can only give the length to the nearest centimetre — Method: a measurement should never be written to a finer degree of accuracy than the instrument used can read. Working: the tape is marked in centimetres, so the smallest division Leah can read is 1 cm, which is 0.01 m and two decimal places in metres; writing 7.3157 m claims the length to the nearest tenth of a millimetre, four decimal places, which the markings cannot support. A record of 7.32 m, to the nearest centimetre, is what this tape justifies. Answer: The tape can only give the length to the nearest centimetre. The distractors: the nearest millimetre contradicts the markings described in the question, which are centimetres, and would still claim more accuracy than the tape offers; the rule that a length in metres must be written to 2 decimal places borrows the habit of writing money to the penny, when the accuracy of a length depends on the instrument; rounding to the nearest metre would throw away accuracy the tape genuinely provides.
- (a) 120 — There are 6 choices for the first digit. The second digit must be different from the first, leaving 5 choices, and the third digit must differ from both of the first two, leaving 4 choices. By the product rule, the number of codes is 6 × 5 × 4 = 120. Allowing every digit to repeat, ignoring the 'no digit twice' rule entirely, gives 6 × 6 × 6 = 216. Adding the number of choices at each position instead of multiplying them, 6 + 5 + 4, gives 15. Treating the three chosen digits as one unordered set, rather than as digits in a fixed order on the padlock, divides by the 3! = 6 ways of arranging them: 120 ÷ 6 = 20.
- (c) 8 hours 35 minutes — From 21:35 to midnight is 2 hours 25 minutes, and from midnight to 06:10 is a further 6 hours 10 minutes, giving a total of 8 hours 35 minutes. Misreading the departure time as 22:35 instead of 21:35 loses an hour from the calculation and gives 7 hours 35 minutes. Misreading the departure time as 20:35 instead of 21:35 gains an hour and gives 9 hours 35 minutes. Subtracting the times as if both fell on the same day, without crossing midnight, gives 15 hours 25 minutes.
- (a) 8 litres per minute — Method: write the time as a decimal number of minutes, then divide the volume by the time. Working: 30 seconds = 30/60 minute = 0.5 minute, so 2 minutes 30 seconds = 2.5 minutes. Rate = 20 ÷ 2.5 = 8 litres per minute. Answer: 8 litres per minute. (10 litres per minute comes from ignoring the extra 30 seconds and dividing by 2 minutes only. 8.7 litres per minute comes from misreading 2 minutes 30 seconds as 2.3 minutes instead of 2.5 minutes. 0.125 litres per minute comes from dividing the time by the volume instead of the volume by the time.)
- (a) 0.55, 58%, 3/5 — Converting all three to decimals: 3/5 = 0.6, 0.55 stays as 0.55, and 58% = 0.58. In order from smallest to largest, this is 0.55, then 58%, then 3/5. Writing the numbers in the reverse order, largest to smallest, gives 3/5, 58%, 0.55. Misconverting 3/5 as 0.5 instead of 0.6 makes it appear smaller than both other values, giving the order 3/5, 0.55, 58%. Misconverting 58% as 0.058 instead of 0.58, by moving the decimal point two extra places, makes it appear smallest of the three, giving the order 58%, 0.55, 3/5.
- (b) Yes — the actual mass could be as low as 995 g — Method: a mass shown to the nearest 10 g lies within half of 10 g, that is 5 g, of the figure on the display, so compare the smallest mass the bag can have with the checker's limit of 996 g. Working: 1,000 − 5 = 995, so the actual mass of the bag can be as low as 995 g, and 995 g is below the 996 g limit, so a bag showing 1,000 g on the machine can still be rejected. Answer: Yes — the actual mass could be as low as 995 g. The distractors: 990 g comes from going a whole 10 g below the display instead of half of it; 999.5 g comes from treating the display as being to the nearest gram, when it is to the nearest 10 g; the claim that the mass is exactly 1,000 g treats a rounded display as an exact measurement.
- (c) 11 — Method: work out the total number of combinations as if there were no restriction, then subtract the one combination that is not allowed. Working: without any restriction there are 4 backdrops × 3 outfits = 12 combinations. The grey backdrop with the formal suit is not allowed, removing 1 combination: 12 − 1 = 11. Answer: 11. 12 comes from forgetting to remove the combination that is not allowed. 8 comes from removing the entire formal suit outfit from the count instead of just the one combination with the grey backdrop. 10 comes from removing two combinations instead of just the one that is not allowed.
- (d) 60 mph — Average speed = distance ÷ time, with the time measured in hours. 45 minutes is 45/60 of an hour, which is 0.75 of an hour, so the journey takes 1.75 hours. Speed = 105 ÷ 1.75 = 60 mph. 52.5 mph rounds the time up to 2 hours, 72.4 mph writes 1 hour 45 minutes as 1.45 hours, and 183.75 mph multiplies the distance by the time instead of dividing.
- (d) £4.80 — Method: find the error interval, then check which value falls outside it. Working: half of 20p is 10p, so the actual cost, c, satisfies £4.50 ≤ c < £4.70. £4.80 is above £4.70, so it could not be the actual cost. Answer: £4.80. (£4.50 is a genuine possible cost — it sits at the included lower boundary. £4.65 is a genuine possible cost, below the £4.70 upper boundary. £4.55 is a genuine possible cost, well inside the interval.)
- (d) 1050 ml — Convert both amounts to millilitres: 1.8 litres = 1800 ml and 3/4 litre = 750 ml. Subtracting gives 1800 − 750 = 1050 ml. Confusing 3/4 with 75% and converting it as 75 ml instead of 750 ml gives 1800 − 75 = 1725 ml. Adding the amount poured out instead of subtracting it gives 1800 + 750 = 2550 ml. Misreading 1.8 litres as 0.8 litres, losing the whole litre, gives 800 − 750 = 50 ml.
- (b) 30 — Method: 12% of an amount is 12/100 of it, so find 1% by dividing by 100 and then multiply by 12. Working: 1% of 250 is 250 ÷ 100 = 2.5, and 12% is 2.5 × 12 = 30. Answer: 30 seats. The distractors: 3 comes from writing 12% as 0.012 instead of 0.12, giving 0.012 × 250 = 3; 25 comes from finding 10% of the seats and stopping there; 24 comes from counting 12 seats for each whole hundred, 12 + 12 = 24, and ignoring the remaining 50 seats.
- (a) 33.5 mph — Method: the smallest possible actual value is half the rounding unit below the given value. Working: half of 1 mph is 0.5 mph, so the smallest possible speed is 34 − 0.5 = 33.5 mph. Answer: 33.5 mph. (33 mph comes from subtracting the whole rounding unit, 1, instead of half of it. 34 mph comes from giving the rounded value itself rather than the lower bound. 34.5 mph comes from adding the half unit instead of subtracting it, giving the upper bound.)
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
Build your own mix at the worksheet builder.