Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 0.1666... — Method: a fraction bar means divide, so the decimal is found by dividing the numerator by the denominator; when a remainder comes back unchanged the division never ends, the digit it produces repeats for ever, and the exact value has to be written with that recurring digit rather than a rounded one. Working: 1 ÷ 6 is set out as 1.000 ÷ 6; six does not go into 1, and six goes into 10 tenths once with 4 left over, so the first decimal digit is 1; the 4 left over makes 40 hundredths, and six goes into 40 six times with 4 left over again; that same remainder of 4 returns at every step, so the digit 6 repeats without end. Answer: 0.1666... The distractors: 0.16 comes from carrying the division out to two decimal places and stopping there, as though the decimal terminated; 0.17 comes from rounding the division to two decimal places, which gives a value close to one sixth but not equal to it; 0.6 comes from writing the digit of the denominator straight after the decimal point, as though 1/6 meant six tenths.
- (c) 8,000,000,000 — Method: a power of ten is 1 followed by that many zeros, so 8 × 10⁹ is 8 multiplied by 1 followed by nine zeros. Working: 10⁹ = 1,000,000,000, and 8 × 1,000,000,000 puts an 8 in front of those nine zeros. Answer: 8,000,000,000. The distractors: 800,000,000 comes from writing nine digits altogether instead of nine zeros after the 8; 720 comes from reading 10⁹ as 10 × 9 = 90 and then working out 8 × 90; 0.000000008 comes from treating the index as negative and carrying the decimal point nine places to the left.
- (c) 90 — Multiply the number of choices for each course: 5 × 6 × 3 = 90. 14 comes from adding the three numbers instead of multiplying them. 30 comes from multiplying only the starters and mains, 5 × 6, and forgetting the dessert. 18 comes from multiplying only the mains and desserts, 6 × 3, and forgetting the starter.
- (a) 25 — Method: squaring a square root removes the root, so a square root raised to the power 4 can be squared in two stages. Working: (√5)⁴ = ((√5)²)² = 5² = 5 × 5 = 25. Answer: 25. The distractors: 5 comes from squaring once and stopping, treating the fourth power as a square; 625 comes from raising 5 to the power 4 and ignoring the root sign altogether; 20 comes from multiplying 5 by the index 4 instead of raising 5 to that power.
- (b) 63 — 5 + 2 = 7, then 3² = 9, then 7 × 9 = 63. Ignoring the brackets and applying BIDMAS as if the expression were unbracketed gives 3² = 9, then 2 × 9 = 18, then 5 + 18 = 23. Squaring the bracket instead of the 3 gives 7² = 49, then 49 × 3 = 147 — the power belongs to the 3 alone. Multiplying by 3 before squaring the whole product gives 7 × 3 = 21, then 21² = 441.
- (b) 6.2 ≤ x < 6.3 — Truncating simply cuts off the digits after the required decimal place instead of rounding them, so every value from 6.2 up to (but not reaching) 6.3 truncates to 6.2. This gives the error interval 6.2 ≤ x < 6.3, with no allowance made on the lower side because truncation never rounds a smaller value up into this interval. Using 6.15 ≤ x < 6.25 applies the rounding rule of going half a unit either side, which does not apply to truncation. Writing 6.1 < x ≤ 6.2 puts the interval below 6.2 instead of above it. Writing 6.2 ≤ x ≤ 6.3 wrongly includes 6.3, which truncates down to itself, not to 6.2.
- (a) 12 — Method: build the number one place at a time, listing systematically: fix the tens digit, then run through every units digit that is still available. Working: any of the 4 digits can go in the tens place, and once it has been used only 3 digits are left for the units place, so there are 4 × 3 = 12 numbers; listing the numbers that begin with 1 gives 12, 13 and 14, and each of the other three starting digits gives 3 numbers in the same way. Answer: 12. The distractors: 16 comes from working out 4 × 4, which allows a digit to be used twice; 8 comes from multiplying the 4 digits by the 2 places in the number instead of multiplying the choices available at each place; 6 comes from treating a number and its reverse as the same, counting only the unordered pairs of digits.
- (d) 16π cm² — Method: for a circle, area = π × radius². Working: area = π × 4² = π × 16 = 16π cm². Answer: 16π cm². The student squared the radius but left out the π, which is why 16 cm² is not the exact area. 4π cm² comes from multiplying by the radius once instead of squaring it: π × 4 = 4π. 8π cm² comes from using the circumference formula 2 × π × radius instead of the area formula: 2 × π × 4 = 8π. 64π cm² comes from using the diameter (8 cm) as the radius in the area formula: π × 8² = 64π.
- (d) 60 mph — Average speed = distance ÷ time, with the time measured in hours. 45 minutes is 45/60 of an hour, which is 0.75 of an hour, so the journey takes 1.75 hours. Speed = 105 ÷ 1.75 = 60 mph. 52.5 mph rounds the time up to 2 hours, 72.4 mph writes 1 hour 45 minutes as 1.45 hours, and 183.75 mph multiplies the distance by the time instead of dividing.
- (d) 9 — List all the factors of 36 in pairs that multiply to give 36: 1 × 36, 2 × 18, 3 × 12, 4 × 9, and 6 × 6. This gives the factors 1, 2, 3, 4, 6, 9, 12, 18 and 36 — nine factors in total, with 6 counted only once even though it appears in a pair with itself. Forgetting that 36 is itself a factor of 36 and leaving it off the list gives 8. Counting the number of factor pairs, five of them, rather than the number of individual factors gives 5. Treating the repeated pair 6 × 6 as two separate factors, 6 and 6 again, gives 10 instead of 9. So 36 has 9 factors.
- (c) 7/30 — Let x = 0.2333... . Because only the 3 recurs, use two multiples of x that line up the recurring part exactly: 10x = 2.333... and 100x = 23.333... . Subtracting removes the recurring tail completely: 100x − 10x = 23.333... − 2.333... = 21, so 90x = 21, giving x = 21/90 = 7/30. Treating the decimal as if it terminated after two places, writing 0.23 as 23/100, ignores that the 3 carries on forever. Misreading which digits recur — treating 0.2333... as if the block '23' repeated, giving 0.232323... — leads to x = 23/99, which is a different, larger recurring decimal from the one given. A numerator slip in the subtraction, computing 22 instead of 21, gives x = 22/90 = 11/45.
- (a) 0.625 — Method: convert the fraction to a decimal so it can be compared properly with 0.6. Working: 5/8 = 0.625, and since 0.625 > 0.6, the larger value is 0.625. Answer: 0.625. 0.6 repeats Sam's incorrect claim, made by comparing single digits rather than full place value. 0.58 comes from converting 5/8 incorrectly, treating it as if it read 5 tenths and 8 hundredths. 0.85 comes from turning the fraction upside down and writing its digits straight after the decimal point, 8 then 5, instead of dividing.
- (b) 20 — Each length has its own error interval: 11.5 ≤ a < 12.5 and 6.5 ≤ b < 7.5. The upper bound of a sum is found by adding the upper bounds of both quantities: 12.5 + 7.5 = 20. Bounding only one of the two lengths and adding the other quantity's given value unbounded, 12.5 + 7 = 19.5, misses that both measurements carry their own uncertainty. Adding the lower bounds instead of the upper bounds, 11.5 + 6.5 = 18, gives the lower bound of the sum, not the upper one. Using a whole centimetre of error either side instead of half a centimetre, (12 + 1) + (7 + 1) = 21, comes from forgetting the error is half the rounding unit.
- (b) 3 — Method: list all valid two-digit numbers that can be made without starting with 0, then keep only the ones that are multiples of 5. Working: the two-digit numbers possible are 30, 35, 50 and 53. A number is a multiple of 5 only if it ends in 0 or 5: 30 ends in 0, 35 ends in 5, 50 ends in 0, but 53 ends in 3. So there are 3 multiples of 5. Answer: 3. 4 comes from including 53 as a multiple of 5 without checking that its last digit is not 0 or 5. 2 comes from leaving out 50, wrongly assuming 0 cannot be used as the second digit either. 6 comes from listing every two-digit arrangement of the three digits, including ones that start with 0, without applying either restriction.
- (c) 6 — The units digit must be even, so it can be 2 or 8, giving 2 choices. The tens digit can then be any of the remaining 3 digits, since one digit has been used for the units. Multiply: 2 × 3 = 6. 12 comes from working out how many two-digit numbers can be made in total, 4 × 3 = 12, ignoring the requirement that the number is even. 8 comes from choosing the units digit from 2 options and then wrongly allowing any of the 4 digits again for the tens digit, 2 × 4 = 8, which lets a digit repeat. 2 comes from counting only the choices for the units digit and forgetting the tens digit.
Build your own mix at the worksheet builder.