Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 3√5 — Split 45 into a perfect square times a factor: 45 = 9 × 5. Take the square root of each part separately: √45 = √9 × √5 = 3√5, since √9 = 3. Writing the perfect-square factor itself (9) as the coefficient instead of its root would give 9√5 — that trap comes from forgetting the last step, rooting 9. Multiplying 3 and 5 together instead of keeping them as coefficient and radicand gives 15, which throws away the surd entirely. Doubling the correct coefficient by mistake gives 6√5.
- (a) 0.55, 58%, 3/5 — Converting all three to decimals: 3/5 = 0.6, 0.55 stays as 0.55, and 58% = 0.58. In order from smallest to largest, this is 0.55, then 58%, then 3/5. Writing the numbers in the reverse order, largest to smallest, gives 3/5, 58%, 0.55. Misconverting 3/5 as 0.5 instead of 0.6 makes it appear smaller than both other values, giving the order 3/5, 0.55, 58%. Misconverting 58% as 0.058 instead of 0.58, by moving the decimal point two extra places, makes it appear smallest of the three, giving the order 58%, 0.55, 3/5.
- (b) 63 — 10% of 180 = 18, so 5% = 9. 35% = (3 × 18) + 9 = 54 + 9 = 63. A candidate who uses 25% instead of 35% gets 45. A candidate who doubles 35% to get 70% by mistake gets 126. A candidate who subtracts 35 from 180 instead of finding a percentage gets 145.
- (b) 750,000,000 — Method: multiplying by 10⁸ moves the decimal point eight places to the right, and every empty place is filled with a zero. Working: 10⁸ = 100,000,000, and moving the decimal point in 7.5 eight places to the right gives 7.5 × 100,000,000. Answer: 750,000,000. The distractors: 7,500,000,000 comes from removing the decimal point first to make 75 and then writing eight zeros after it, which carries the digits one place too far; 600 comes from reading 10⁸ as 10 × 8 = 80 and working out 7.5 × 80; 0.000000075 comes from moving the decimal point eight places to the left, as though the index were negative.
- (a) 2/5 — Method: find the number of vegetable plots in each allotment, add them, then divide by the total number of plots in both allotments. Working: Allotment A: 3/5 × 20 = 12 vegetable plots. Allotment B: 1/5 × 20 = 4 vegetable plots. Total vegetable plots = 12 + 4 = 16. Total plots = 20 + 20 = 40. Fraction = 16/40 = 2/5. Answer: 2/5. 3/10 comes from using only Allotment A's 12 vegetable plots over the combined total of 40 plots, forgetting to add Allotment B's vegetable plots. 1/5 comes from using only Allotment B's ratio (1:4) as the fraction of vegetables, ignoring Allotment A altogether. 3/5 comes from working out the fraction of the combined plots that grow flowers instead of vegetables.
- (c) −1 — Method: find each cube root separately, keeping its sign, and then add the two results. Working: (−3) × (−3) × (−3) = −27, so ∛(−27) = −3, and 2 × 2 × 2 = 8, so ∛8 = 2. Adding gives −3 + 2 = −1. Answer: −1. The distractors: 5 comes from taking the cube root of a negative number as positive, giving 3 + 2; −5 comes from reading the minus sign as applying to the whole sum and working out −(3 + 2); −6 comes from multiplying the two roots, −3 × 2, instead of adding them.
- (c) 693 — Method: multiplying a bracket by a number multiplies every term inside it, so 7 × (100 − 1) = 7 × 100 − 7 × 1. Working: 7 × 100 = 700 and 7 × 1 = 7, so the calculation becomes 700 − 7 = 693. Answer: 693. The distractors: 699 comes from subtracting the 1 itself rather than 7 lots of it, giving 700 − 1 = 699; 707 comes from adding the second product instead of subtracting it, giving 700 + 7 = 707; 700 comes from rounding 99 up to 100 and then offering the estimate 7 × 100 as an exact value.
- (a) 2/5 — The ratio 2:3 has 2 + 3 = 5 parts in total, and the larger plot is 3 of those parts. Since the larger plot is 18 m², each part is 18 ÷ 3 = 6 m², so the total area is 5 × 6 = 30 m² and the smaller plot is 2 × 6 = 12 m². The fraction of the total area taken up by the smaller plot is 12/30, which simplifies to 2/5. Giving the fraction for the larger plot instead of the smaller one gives 3/5. Comparing the smaller plot to the larger plot instead of to the total area gives 2/3. Assuming the two plots split the area evenly, ignoring the given ratio altogether, gives 1/2.
- (b) 6.2 ≤ x < 6.3 — Truncating simply cuts off the digits after the required decimal place instead of rounding them, so every value from 6.2 up to (but not reaching) 6.3 truncates to 6.2. This gives the error interval 6.2 ≤ x < 6.3, with no allowance made on the lower side because truncation never rounds a smaller value up into this interval. Using 6.15 ≤ x < 6.25 applies the rounding rule of going half a unit either side, which does not apply to truncation. Writing 6.1 < x ≤ 6.2 puts the interval below 6.2 instead of above it. Writing 6.2 ≤ x ≤ 6.3 wrongly includes 6.3, which truncates down to itself, not to 6.2.
- (d) 6 — Method: the square root of a product can be found either by multiplying first and then rooting, or by rooting each factor and multiplying the two roots together. Working: 4 × 9 = 36, and 6 × 6 = 36, so the root is 6; the same value comes from √4 × √9 = 2 × 3. Answer: 6. The distractors: 36 comes from multiplying inside the root and then leaving the root untaken; 5 comes from rooting each factor and adding the results, 2 + 3, instead of multiplying them; 18 comes from rooting the 4 only and leaving the 9 untouched, giving 2 × 9.
- (a) 37.5 — The error intervals are 45 ≤ c < 55 and 17.5 ≤ d < 18.5. The maximum possible value of a difference comes from the largest possible value being reduced by the smallest amount: use the upper bound of c together with the LOWER bound of d, since subtracting less gives a bigger result: 55 − 17.5 = 37.5. Using the upper bound for both quantities, 55 − 18.5 = 36.5, forgets that subtracting a bigger number gives a smaller answer, not a bigger one. Using the lower bounds for both, 45 − 17.5 = 27.5, gives the lower bound of the difference instead of the upper one. Using the lower bound of c with the upper bound of d, 45 − 18.5 = 26.5, combines the two bounds the wrong way round entirely.
- (a) 1,500 ≤ m < 2,500 — Method: a four-digit figure written to 1 significant figure has been rounded to the nearest 1,000, so the mass lies within half of 1,000, that is 500, of the figure given. Working: 2,000 − 500 = 1,500 and 2,000 + 500 = 2,500. The lower limit is included, because 1,500 kg rounds up to 2,000 kg to 1 significant figure, while 2,500 kg rounds up to 3,000 kg, so the upper limit is not. Answer: 1,500 ≤ m < 2,500. The distractors: 1,950 ≤ m < 2,050 comes from rounding to the nearest 100 instead of to 1 significant figure; 1,000 ≤ m < 3,000 goes a whole 1,000 either side instead of half of it; 1,500 < m ≤ 2,500 has the two limits the wrong way round.
- (b) Yes, because 14.8 cm rounds to 15 cm to the nearest cm — Method: a recorded measurement is not an exact length; it stands for every length that rounds to it, so the two records agree if one rod can produce both. Working: Ben's record of 14.8 cm to the nearest 0.1 cm means the rod is between 14.75 cm and 14.85 cm, and 14.8 is nearer to 15 than to 14, so a rod of that length is recorded as 15 cm to the nearest centimetre. Both records can therefore come from the same rod. Answer: Yes, because 14.8 cm rounds to 15 cm to the nearest cm. The distractors: the claim that 14.8 cm rounds to 15.0 cm to 1 decimal place is false, since 14.8 cm is already written to 1 decimal place and stays 14.8 cm; the claim that it rounds to 14 cm is false, because 14.8 is 0.2 away from 15 and 0.8 away from 14; the claim that the two lengths are not the same treats each record as an exact length, when each is only a rounded record of one rod.
- (b) No — their possible jump lengths do not overlap — Method: each recorded jump stands for the lengths within half of 0.1 m, that is 0.05 m, of the figure recorded, and Priya is right only if the two ranges overlap. Working: Priya's jump is at least 3.8 − 0.05 = 3.75 m and below 3.85 m, because a jump of 3.85 m would have been recorded as 3.9 m; Nadia's jump is at least 3.85 m and below 3.9 + 0.05 = 3.95 m. Every length Priya could have jumped is below 3.85 m and every length Nadia could have jumped is at least 3.85 m, so Nadia jumped further whatever the exact lengths were. Answer: No — their possible jump lengths do not overlap. The distractors: the reason that a recorded jump is exactly the length jumped reaches the same verdict by treating a rounded record as exact, which is the idea this question tests; both jumps being 3.85 m would put 3.85 m inside Priya's range, when a jump of that length is recorded as 3.9 m; Priya jumping up to 3.9 m goes a whole 0.1 m above her record instead of half of it.
- (d) 6 × 10⁷ — Method: the coefficients and the powers of ten are handled separately — multiply the coefficients, and add the indices because the powers share the base 10. Working: 2 × 3 = 6 for the coefficients, and 10³ × 10⁴ = 10⁷ for the powers; 6 lies between 1 and 10, so the coefficient needs no adjustment. Answer: 6 × 10⁷. The distractors: 5 × 10⁷ comes from adding the coefficients, 2 + 3, instead of multiplying them; 6 × 10¹² comes from multiplying the indices, 3 × 4, instead of adding them; 6 × 10¹ comes from subtracting the indices, 4 − 3, which is the rule for dividing rather than for multiplying.
Build your own mix at the worksheet builder.