Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 13/40 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.325 = 325/1000 = 13/40 (dividing both numerator and denominator by 25). Answer: 13/40. 13/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 8/25 comes from rounding 0.325 down to 0.32 before converting. 3/8 comes from recalling the learned conversion 3/8 = 0.375 and matching it to 0.325 because both are three-place decimals beginning with 3, instead of converting the decimal given.
- (d) 9 — List all the factors of 36 in pairs that multiply to give 36: 1 × 36, 2 × 18, 3 × 12, 4 × 9, and 6 × 6. This gives the factors 1, 2, 3, 4, 6, 9, 12, 18 and 36 — nine factors in total, with 6 counted only once even though it appears in a pair with itself. Forgetting that 36 is itself a factor of 36 and leaving it off the list gives 8. Counting the number of factor pairs, five of them, rather than the number of individual factors gives 5. Treating the repeated pair 6 × 6 as two separate factors, 6 and 6 again, gives 10 instead of 9. So 36 has 9 factors.
- (c) Yes — the greatest possible total is 493.5 kg, under 500 kg — 493 kg correct to the nearest kg means the true total mass, m, satisfies 492.5 kg ≤ m < 493.5 kg. The greatest possible total is 493.5 kg, which is under the 500 kg safe working load, so the four people are definitely within it. 'The true total could be as high as 498 kg' comes from treating 'nearest kg' as an error of ±5 kg instead of ±0.5 kg. 'Cannot be decided without the exact total' overlooks that the error interval already gives the greatest possible total, so the decision can be made without knowing the exact figure. '493 kg is only an estimate, so it may be over 500 kg' ignores that the error interval is bounded — the true total cannot exceed 493.5 kg, well under 500 kg.
- (c) 22 — Without restriction there are 6 × 4 = 24 combinations. Two specific combinations are not available, so subtract 2: 24 − 2 = 22. 24 comes from ignoring the restriction completely. 23 comes from subtracting only 1 of the 2 excluded combinations. 18 comes from removing the whole sport trim level, 6 × 3 = 18, instead of removing just the two excluded combinations.
- (a) 200 g — One quarter of 160 g is 40 g. Increasing the amount means adding this on: 160 + 40 = 200 g. Finding the increase, 1/4 of 160 = 40 g, but stopping there without adding it to the original amount leaves just 40 g. Using 4/5 instead of 5/4 as the scaling fraction, 160 × 4/5 = 128 g, actually decreases the amount rather than increasing it. Increasing by a half instead of a quarter, 160 + 80 = 240 g, uses the wrong fraction of 160.
- (c) 11 — Method: work out the total number of combinations as if there were no restriction, then subtract the one combination that is not allowed. Working: without any restriction there are 4 backdrops × 3 outfits = 12 combinations. The grey backdrop with the formal suit is not allowed, removing 1 combination: 12 − 1 = 11. Answer: 11. 12 comes from forgetting to remove the combination that is not allowed. 8 comes from removing the entire formal suit outfit from the count instead of just the one combination with the grey backdrop. 10 comes from removing two combinations instead of just the one that is not allowed.
- (a) 4,000 nanometres — Method: the number of nanometres is the diameter divided by the length of one nanometre, and dividing powers of ten means subtracting the indices. Working: −6 − (−9) = 3, so 10⁻⁶ ÷ 10⁻⁹ = 10³, and the diameter is 4 × 10³ nanometres. Answer: 4,000 nanometres. The distractors: 400 nanometres comes from taking the difference between the indices as 2 instead of 3; 4 nanometres comes from changing the name of the unit without converting, leaving the coefficient untouched; 0.004 nanometres comes from dividing by 10³ instead of multiplying by it, as though a nanometre were the larger of the two units.
- (c) 23.375 — The error intervals are 7.5 ≤ base < 8.5 and 4.5 ≤ height < 5.5. The upper bound of the area uses the upper bound of both the base and the height, then halves the product: 8.5 × 5.5 ÷ 2 = 23.375 cm². Using the lower bound of both dimensions instead, 7.5 × 4.5 ÷ 2 = 16.875, gives the lower bound of the area rather than the upper one. Multiplying the two upper bounds together but forgetting to halve for the triangle formula, 8.5 × 5.5 = 46.750, treats the triangle as if it were a rectangle. Using the given values directly without applying any bound at all, 8 × 5 ÷ 2 = 20.000, ignores that each rounded measurement has its own range of possible values.
- (a) 1/3 — To subtract these fractions, first write 3/4 with a denominator of 12: 3/4 = 9/12. Then 9/12 − 5/12 = 4/12, which simplifies to 1/3. Subtracting the numerators and the denominators separately, (3 − 5)/(4 − 12), gives −2/−8, which simplifies to 1/4. Changing 3/4 to twelfths by only changing the denominator, without scaling the numerator to match, gives 3/12 − 5/12 = −2/12, which simplifies to −1/6. Adding the fractions instead of subtracting them, 9/12 + 5/12, gives 14/12, which simplifies to 7/6.
- (a) 8.15 ≤ y < 8.25 — Rounding to 1 decimal place means the error interval spans half of 0.1, so 0.05, either side of 8.2: 8.2 − 0.05 = 8.15 and 8.2 + 0.05 = 8.25. The lower bound uses ≤ because 8.15 itself rounds to 8.2, but the upper bound uses < because 8.25 would round up to 8.3. So the error interval is 8.15 ≤ y < 8.25. A candidate who used the wrong rounding band gave 8.1 ≤ y < 8.2. A candidate who used a strict inequality at both ends wrote 8.15 < y < 8.25, wrongly excluding 8.15 itself. A candidate who added the full 0.1 instead of half of it wrote 8.2 ≤ y < 8.3.
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
- (a) 0.625 — Method: convert the fraction to a decimal so it can be compared properly with 0.6. Working: 5/8 = 0.625, and since 0.625 > 0.6, the larger value is 0.625. Answer: 0.625. 0.6 repeats Sam's incorrect claim, made by comparing single digits rather than full place value. 0.58 comes from converting 5/8 incorrectly, treating it as if it read 5 tenths and 8 hundredths. 0.85 comes from turning the fraction upside down and writing its digits straight after the decimal point, 8 then 5, instead of dividing.
- (d) −1.4, −6/5, 0, 5/4, 1.3 — Method: convert the fractions 5/4 and −6/5 to decimals so every number is written the same way, then compare all five decimals. Working: 5/4 = 1.25 and −6/5 = −1.2. Comparing −1.4, −1.2, 0, 1.25 and 1.3 in size gives the order −1.4, −1.2, 0, 1.25, 1.3. Answer: −1.4, −6/5, 0, 5/4, 1.3. −6/5, −1.4, 0, 5/4, 1.3 swaps the two negative numbers, treating −6/5 as more negative than −1.4 even though −1.2 is closer to zero than −1.4. 1.3, 5/4, 0, −6/5, −1.4 lists the numbers from largest to smallest instead of smallest to largest. −1.4, −6/5, 0, 1.3, 5/4 swaps 5/4 and 1.3, comparing the numerator 5 directly with 1.3 instead of converting 5/4 to the decimal 1.25 first.
- (c) −1 — Method: find each cube root separately, keeping its sign, and then add the two results. Working: (−3) × (−3) × (−3) = −27, so ∛(−27) = −3, and 2 × 2 × 2 = 8, so ∛8 = 2. Adding gives −3 + 2 = −1. Answer: −1. The distractors: 5 comes from taking the cube root of a negative number as positive, giving 3 + 2; −5 comes from reading the minus sign as applying to the whole sum and working out −(3 + 2); −6 comes from multiplying the two roots, −3 × 2, instead of adding them.
- (d) 0.024 cm — Method: significant figures are counted from the first non-zero digit; the zeros in front of it only fix the place value and are not significant. Working: in 0.02384 the first significant figure is 2 and the second is 3, so the rounding is decided by the next digit, 8. As 8 is 5 or more, the second significant figure goes up from 3 to 4, in the same place value. Answer: 0.024 cm. The distractors: 0.023 cm comes from chopping the 84 off instead of rounding it; 0.02 cm comes from counting the leading zeros as significant figures, so the 2 is taken as the second figure and the rounding stops there; 0.0238 cm is 0.02384 correct to 3 significant figures, one figure too many.
Build your own mix at the worksheet builder.