Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 5.1 — ∛130 lies between 5 and 6, since 125 < 130 < 216, and closer to 5 because 130 is much nearer 125 than 216. To pin down the first decimal place, test the midpoint of the tenth, 5.05: 5.05³ = 5.05 × 5.05 × 5.05 ≈ 128.79. Since 130 is greater than 128.79, ∛130 lies above 5.05, so it rounds to 5.1 rather than 5.0. Rounding down to 5.0, on the assumption that a value close to the lower bound 125 must round down, ignores that 5.05³ is already less than 130. Estimating 5.2 overshoots the true root: 5.2³ = 140.608, which is well above 130, so ∛130 cannot round to 5.2. Taking 6.0, the upper of the two whole numbers the root lies between, ignores that 130 is far nearer to 5³ = 125 than to 6³ = 216, so the root sits just above 5, not just below 6.
- (a) 8.15 ≤ y < 8.25 — Rounding to 1 decimal place means the error interval spans half of 0.1, so 0.05, either side of 8.2: 8.2 − 0.05 = 8.15 and 8.2 + 0.05 = 8.25. The lower bound uses ≤ because 8.15 itself rounds to 8.2, but the upper bound uses < because 8.25 would round up to 8.3. So the error interval is 8.15 ≤ y < 8.25. A candidate who used the wrong rounding band gave 8.1 ≤ y < 8.2. A candidate who used a strict inequality at both ends wrote 8.15 < y < 8.25, wrongly excluding 8.15 itself. A candidate who added the full 0.1 instead of half of it wrote 8.2 ≤ y < 8.3.
- (d) 26 and 27 — Find the two consecutive perfect squares either side of 700: 26² = 676 and 27² = 729. Since 676 < 700 < 729, √700 lies between 26 and 27. Answering 7 and 8 comes from stripping the two zeros off 700 and using the 7 itself as the size of the root, instead of comparing 700 with the perfect squares around it — dividing the number under the root by 100 divides the root by 10, so the digits do not simply carry across. Answering 25 and 26 comes from checking 25² = 625, seeing that it is less than 700, and stopping there without also checking the square directly above it. Answering 35 and 36 comes from halving 700 to 350 and then treating that halved value as if it were ten times the true root, drifting into the thirties instead of the twenties.
- (c) 31 — Method: work out each power separately, remembering that any non-zero base raised to the power 0 is 1 and a base raised to the power 1 is itself, then add the three values. Working: 5⁰ = 1, 5¹ = 5 and 5² = 25, so the total is 1 + 5 + 25 = 31. Answer: 31. The distractors: 30 comes from taking 5⁰ as 0 instead of 1; 35 comes from taking 5⁰ as 5, treating a zero index as leaving the base unchanged; 125 comes from adding the indices first, as though the three terms were being multiplied, and working out 5³.
- (b) 11 — Method: roots and the multiplication are worked out before the addition and subtraction, and what is left is then worked through from left to right. Working: √144 = 12, √25 = 5 and 2 × 3 = 6, so the calculation becomes 12 − 6 + 5, which gives 6 + 5 = 11. Answer: 11. The distractors: 1 comes from carrying out the addition before the subtraction, giving 12 − (6 + 5) = 12 − 11 = 1; 35 comes from working from left to right with no priority, giving 12 − 2 = 10, then 10 × 3 = 30 and 30 + 5 = 35; 7 comes from combining the two roots as √(144 + 25) = √169 = 13 and then subtracting the product, giving 13 − 6 = 7.
- (c) −1 — Method: find each cube root separately, keeping its sign, and then add the two results. Working: (−3) × (−3) × (−3) = −27, so ∛(−27) = −3, and 2 × 2 × 2 = 8, so ∛8 = 2. Adding gives −3 + 2 = −1. Answer: −1. The distractors: 5 comes from taking the cube root of a negative number as positive, giving 3 + 2; −5 comes from reading the minus sign as applying to the whole sum and working out −(3 + 2); −6 comes from multiplying the two roots, −3 × 2, instead of adding them.
- (b) 3²⁰ is larger — Method: two powers with different bases and different indices can be compared once they are rewritten with a common index, which is possible whenever the indices share a factor. Working: 30 and 20 have a highest common factor of 10, so 2³⁰ = (2³)¹⁰ = 8¹⁰ and 3²⁰ = (3²)¹⁰ = 9¹⁰. Both are now tenth powers, and since 9 is larger than 8, 9¹⁰ is larger than 8¹⁰. Answer: 3²⁰ is larger. The distractors: 2³⁰ is larger comes from comparing only the indices and choosing the power with the bigger index; They are equal comes from multiplying base by index, 2 × 30 and 3 × 20, and finding 60 each time; They cannot be compared without a calculator comes from assuming that powers this large can only be ranked by evaluating them in full.
- (c) An under-estimate, by 8 — Method: work out the exact product, then compare it with the estimate; an estimate that is smaller than the exact value is an under-estimate, and the difference between them is the size of the error. Working: 48 × 21 = 48 × 20 + 48 = 960 + 48 = 1,008, and 1,008 − 1,000 = 8, so the estimate falls short. Answer: an under-estimate, by 8. The distractors: an over-estimate by 8 has the size of the error right but the direction wrong, and comes from assuming that rounding 48 up to 50 must push the estimate above the exact value, without allowing for 21 being rounded down; an over-estimate by 19 comes from working out 48 × 21 as 48 × 20 + 21 = 981, adding a 21 where another 48 belongs; the claim that the estimate is exactly right comes from arguing that one number was rounded up and the other down, so the two changes must cancel.
- (b) 25 g — Method: substitute the number of years into the model, raise the fraction to that power first, then multiply by the starting mass. Working: with n = 3 the model gives M = 200 × (1/2)³. Since (1/2)³ = 1/8, the mass is 200 ÷ 8 = 25. Answer: 25 g. The distractors: 12.5 g comes from halving four times instead of three, counting the first weighing as a year; 300 g comes from multiplying by 1/2 × 3 = 1.5 instead of raising 1/2 to the power 3; 0.125 g comes from working out (1/2)³ = 0.125 and stopping there, without multiplying by the starting mass.
- (c) 7 + 4√3 — Expand the brackets fully: (2 + √3)² = 2² + 2 × 2 × √3 + (√3)² = 4 + 4√3 + 3. Adding the two whole-number terms, 4 + 3 = 7, gives 7 + 4√3. Using (a + b)² = a² + b² and skipping the middle cross term entirely gives just 4 + 3 = 7, with no surd term at all. Treating (√3)² as if it stayed √3 rather than becoming 3, then merging it with the existing surd term, gives 4 + 5√3. Squaring only the surd term correctly but carrying the whole-number term as 2 instead of squaring it to 4 gives 2 + 3 + 4√3 = 5 + 4√3.
- (b) 14.5 ≤ l < 15.5 — A measurement given to the nearest metre could have been rounded from anywhere up to half a metre below or above it: 15 − 0.5 = 14.5 and 15 + 0.5 = 15.5. Every value from 14.5 up to (but not reaching) 15.5 rounds to 15, so the error interval is 14.5 ≤ l < 15.5, with the lower bound included and the upper bound excluded. Making both ends strict, 14.5 < l < 15.5, wrongly excludes 14.5 itself, even though 14.5 does round to 15. Making both ends inclusive, 14.5 ≤ l ≤ 15.5, wrongly includes 15.5, which actually rounds up to 16, not 15. Using a whole metre either side instead of half a metre, giving 14 ≤ l < 16, comes from forgetting that the error is only half the rounding unit.
- (d) 6 × 10⁷ — Method: the coefficients and the powers of ten are handled separately — multiply the coefficients, and add the indices because the powers share the base 10. Working: 2 × 3 = 6 for the coefficients, and 10³ × 10⁴ = 10⁷ for the powers; 6 lies between 1 and 10, so the coefficient needs no adjustment. Answer: 6 × 10⁷. The distractors: 5 × 10⁷ comes from adding the coefficients, 2 + 3, instead of multiplying them; 6 × 10¹² comes from multiplying the indices, 3 × 4, instead of adding them; 6 × 10¹ comes from subtracting the indices, 4 − 3, which is the rule for dividing rather than for multiplying.
- (b) 9 — Method: a negative index means take the reciprocal of the base first and then apply the positive power. Working: the reciprocal of 1/3 is 3, so (1/3)⁻² = 3² = 3 × 3 = 9. Answer: 9. The distractors: 1/9 comes from ignoring the minus sign and squaring 1/3 as it stands; −9 comes from reading the negative index as a minus sign on the result; 6 comes from multiplying the denominator by the index, 3 × 2, instead of squaring the reciprocal.
- (a) 120 — There are 6 choices for the first digit. The second digit must be different from the first, leaving 5 choices, and the third digit must differ from both of the first two, leaving 4 choices. By the product rule, the number of codes is 6 × 5 × 4 = 120. Allowing every digit to repeat, ignoring the 'no digit twice' rule entirely, gives 6 × 6 × 6 = 216. Adding the number of choices at each position instead of multiplying them, 6 + 5 + 4, gives 15. Treating the three chosen digits as one unordered set, rather than as digits in a fixed order on the padlock, divides by the 3! = 6 ways of arranging them: 120 ÷ 6 = 20.
- (b) 88.8 — Multiply as whole numbers first, ignoring the decimal point: 37 × 24. Split it as 37 × 20 = 740 and 37 × 4 = 148, so 37 × 24 = 740 + 148 = 888. 3.7 has 1 decimal place and 24 has none, so the answer needs 1 decimal place: 88.8. Counting the 2 digits in "3.7" as though that were the number of decimal places gives 8.88 instead of 1 decimal place. Leaving the decimal point out altogether gives 888. Misreading 37 × 4 as 138 rather than 148 gives a running total of 878, placed with 1 decimal place as 87.8. So 3.7 × 24 = 88.8.
Build your own mix at the worksheet builder.