Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 3:4 — The jacket costs 3/7 of £84, which is 3 × (84 ÷ 7) = 3 × 12 = £36. The bag then costs the rest of the money, £84 − £36 = £48. The ratio of the jacket to the bag is 36:48, which simplifies to 3:4. Writing the fraction spent on the jacket, 3/7, directly as the ratio, without working out that the bag's share is the remaining 4/7, gives 3:7. Giving the ratio the wrong way round, bag to jacket instead of jacket to bag, gives 4:3. Assuming the jacket and bag cost the same, ignoring the fraction given, gives 1:1.
- (a) 40 — Multiply the number of choices for each item: 4 × 5 × 2 = 40. 11 comes from adding the three numbers instead of multiplying them. 20 comes from multiplying only the crisps and chocolate bars, 4 × 5, and forgetting the drink. 10 comes from multiplying only the chocolate bars and drinks, 5 × 2, and forgetting the crisps.
- (a) The tape can only give the length to the nearest centimetre — Method: a measurement should never be written to a finer degree of accuracy than the instrument used can read. Working: the tape is marked in centimetres, so the smallest division Leah can read is 1 cm, which is 0.01 m and two decimal places in metres; writing 7.3157 m claims the length to the nearest tenth of a millimetre, four decimal places, which the markings cannot support. A record of 7.32 m, to the nearest centimetre, is what this tape justifies. Answer: The tape can only give the length to the nearest centimetre. The distractors: the nearest millimetre contradicts the markings described in the question, which are centimetres, and would still claim more accuracy than the tape offers; the rule that a length in metres must be written to 2 decimal places borrows the habit of writing money to the penny, when the accuracy of a length depends on the instrument; rounding to the nearest metre would throw away accuracy the tape genuinely provides.
- (b) 6.2 ≤ x < 6.3 — Truncating simply cuts off the digits after the required decimal place instead of rounding them, so every value from 6.2 up to (but not reaching) 6.3 truncates to 6.2. This gives the error interval 6.2 ≤ x < 6.3, with no allowance made on the lower side because truncation never rounds a smaller value up into this interval. Using 6.15 ≤ x < 6.25 applies the rounding rule of going half a unit either side, which does not apply to truncation. Writing 6.1 < x ≤ 6.2 puts the interval below 6.2 instead of above it. Writing 6.2 ≤ x ≤ 6.3 wrongly includes 6.3, which truncates down to itself, not to 6.2.
- (c) 87 litres — Work out how much water is drained: 8 × 6 = 48 litres. Subtract this from the starting amount: 120 − 48 = 72 litres. Then add the 15 litres from the hose: 72 + 15 = 87 litres. Subtracting the 15 litres instead of adding it, as though the hose also removed water, gives 120 − 48 − 15 = 57 litres. Stopping after the drain step, without adding the hose water back in, leaves the working at 72 litres. Adding the rate and the time instead of multiplying them, 8 + 6 = 14 litres drained, and then working from there gives 120 − 14 + 15 = 121 litres. So 87 litres of water is left in the tank.
- (c) 0.5, 0.45, −0.09, −0.15, −0.6 — Method: compare the decimals by their position on a number line, remembering that with negative decimals the one closer to zero is larger. Working: 0.5 and 0.45 are positive, so they come first, with 0.5 the larger of the two. Among the negatives, −0.09 is closest to zero, then −0.15, then −0.6 is furthest from zero and so the smallest. Answer: 0.5, 0.45, −0.09, −0.15, −0.6. 0.5, 0.45, −0.15, −0.09, −0.6 swaps −0.09 and −0.15, treating the negative decimal with more digits after the point as closer to zero. −0.6, −0.15, −0.09, 0.45, 0.5 lists the numbers from smallest to largest instead of largest to smallest. 0.5, 0.45, −0.6, −0.15, −0.09 orders the negative decimals by the size of the digit (0.6 > 0.15 > 0.09) as if they were positive, instead of recognising that a bigger negative decimal is further from zero and so smaller.
- (c) 0.0065 — Leading zeros are never significant, so counting from the first non-zero digit, the first two significant figures of 0.006482 are 6 and 4. Look at the next digit along, 8, to decide whether the second figure rounds up: since 8 is 5 or more, the 4 rounds up to 5, giving 0.0065. Rounding to 2 decimal places instead of 2 significant figures gives 0.01, which answers a different question. Wrongly counting one of the leading zeros as a significant figure and stopping one figure short gives 0.006. Keeping an extra digit, as in 0.00648, gives 3 significant figures rather than 2.
- (b) 9 — Method: a negative index means take the reciprocal of the base first and then apply the positive power. Working: the reciprocal of 1/3 is 3, so (1/3)⁻² = 3² = 3 × 3 = 9. Answer: 9. The distractors: 1/9 comes from ignoring the minus sign and squaring 1/3 as it stands; −9 comes from reading the negative index as a minus sign on the result; 6 comes from multiplying the denominator by the index, 3 × 2, instead of squaring the reciprocal.
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
- (a) −108 — Method: a power is worked out before any minus sign written in front of it, while a minus sign inside the brackets is part of the base. Working: (−3)⁴ = 81, because four negative factors multiply to a positive result, so −(−3)⁴ = −81. (−3)³ = −27, because three negative factors multiply to a negative result. Adding gives −81 + (−27) = −108. Answer: −108. The distractors: 54 comes from attaching the leading minus sign to the base, working out (−(−3))⁴ = 81 and then adding −27; −54 comes from taking (−3)³ as +27, forgetting that an odd power keeps the negative sign; 108 comes from believing that any power of a negative number is positive and that the leading minus belongs to the base, giving 81 + 27.
- (a) 11:20 — Method: find the flight time using time = distance ÷ speed, then add this to the departure time. Working: 2340 ÷ 780 = 3 hours; 08:20 + 3 hours = 11:20. Answer: 11:20. 08:40 comes from dividing speed by distance instead of distance by speed, giving a flight time of 1/3 hour (20 minutes) rather than 3 hours. 11:00 comes from adding the 3-hour flight time to the hour of the departure time only, 8 + 3 = 11, and losing the 20 minutes. 03:00 comes from finding the flight time correctly but giving it as a clock time on its own, forgetting to add it to the departure time.
- (c) 3 or −5 — Method: a point a fixed distance from another can lie on either side of it, so move the given distance in each direction from the starting point. Working: moving 4 units to the right gives −1 + 4 = 3, and moving 4 units to the left gives −1 − 4 = −5. Answer: 3 or −5. The distractors: 5 or −3 comes from starting at 1 instead of −1, giving 1 + 4 and 1 − 4; 3 only comes from moving to the right and forgetting that the point could lie to the left as well; 4 or −4 comes from measuring the distance from zero instead of from point A, which just repeats the given distance.
- (d) 360 km — Method: first find the kilometres per litre by dividing distance by fuel used, then multiply this rate by the new tank size. Working: 180 ÷ 6 = 30 km per litre; 30 × 12 = 360 km. Answer: 360 km. 30 km comes from finding the correct fuel consumption but stopping there, without scaling it up to the full tank. 2160 km comes from multiplying the original distance (180) by the tank size (12) directly, skipping the unit rate. 90 km comes from pairing the numbers the wrong way round: dividing the distance by the new tank size, 180 ÷ 12 = 15, and then multiplying by the original 6 litres, 15 × 6 = 90.
- (d) −1.7 — Since the numbers have different signs, find the difference between their sizes: 4.5 − 2.8 = 1.7, then keep the sign of the number further from zero. So −4.5 + 2.8 = −1.7. A candidate who drops the negative sign gets 1.7. A candidate who adds the magnitudes instead of finding the difference gets −(4.5 + 2.8) = −7.3. A candidate who takes the smaller digit from the larger in the tenths column, doing 8 − 5 = 3 instead of borrowing to make 15 − 8 = 7, gets 2.3 and so −2.3.
- (a) x⁶ — Method: work through the powers in order — multiplying powers of the same base means adding indices, and dividing powers of the same base means subtracting indices. Working: first, x⁵ × x³ = x⁸ (adding 5 and 3); then x⁸ ÷ x² = x⁶ (subtracting 2 from 8). x⁴ comes from swapping the two rules — subtracting for the multiplication, 5 − 3 = 2, and then adding for the division, 2 + 2 = 4. x¹⁰ comes from adding all three indices, 5 + 3 + 2 = 10, treating the division the same as a multiplication. 6x comes from correctly reaching a total index of 6 but then writing it as a coefficient of x instead of as its power. Answer: x⁶.
Build your own mix at the worksheet builder.