Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 1 : 2 — 2/5 of 50 is 20, so there are 20 red counters and 50 − 20 = 30 blue counters. Taking 5 red counters out leaves 15 red and 30 blue, so red : blue = 15 : 30. Dividing both parts by 15 gives 1 : 2. 2 : 3 is the ratio before any counters are removed, 2 : 1 has the two parts the wrong way round, and 4 : 5 comes from taking the 5 counters out of the blue instead of the red.
- (c) 36 — Method: set the outcomes out in a grid with one die along the top and the other down the side, so that every cell of the grid is one outcome, and count the cells. Working: the red die can land in 6 ways, so the grid has 6 columns, and the blue die can also land in 6 ways, so the grid has 6 rows; the number of cells is 6 × 6 = 36. Answer: 36. The distractors: 12 comes from adding 6 and 6 instead of multiplying them; 6 comes from counting the outcomes of a single die and forgetting that the second die also has to land; 21 comes from treating the two dice as indistinguishable, so that a red 2 with a blue 3 and a red 3 with a blue 2 are counted as one outcome.
- (b) 14.5 ≤ l < 15.5 — A measurement given to the nearest metre could have been rounded from anywhere up to half a metre below or above it: 15 − 0.5 = 14.5 and 15 + 0.5 = 15.5. Every value from 14.5 up to (but not reaching) 15.5 rounds to 15, so the error interval is 14.5 ≤ l < 15.5, with the lower bound included and the upper bound excluded. Making both ends strict, 14.5 < l < 15.5, wrongly excludes 14.5 itself, even though 14.5 does round to 15. Making both ends inclusive, 14.5 ≤ l ≤ 15.5, wrongly includes 15.5, which actually rounds up to 16, not 15. Using a whole metre either side instead of half a metre, giving 14 ≤ l < 16, comes from forgetting that the error is only half the rounding unit.
- (a) 8 × 10³ — Method: divide the capacity of the card by the size of one photograph, dividing the coefficients and subtracting the indices, then bring the coefficient back into the range 1 to 10. Working: 3.2 ÷ 4 = 0.8 and 10 − 6 = 4, which gives 0.8 × 10⁴; a coefficient of 0.8 is smaller than 1, so the decimal point moves one place to the right and the index falls by 1. Answer: 8 × 10³. The distractors: 8 × 10⁴ comes from correcting 0.8 to 8 without reducing the index, which makes the answer ten times too large; 1.28 × 10¹⁷ comes from multiplying the two numbers instead of dividing them, since 3.2 × 4 = 12.8 and 10 + 6 = 16; 8 × 10¹⁵ comes from dividing the coefficients but adding the indices instead of subtracting them.
- (c) 4.6 — Since 100 lies between 64 and 125, ∛100 lies between 4 and 5. Narrow it down: 4.6³ = 97.336, which is less than 100, so ∛100 is greater than 4.6. To decide how it rounds to 1 decimal place, test the midpoint: 4.65³ = 100.544, which is more than 100, so ∛100 is less than 4.65 and therefore rounds down to 4.6. Simply taking the midpoint of 4 and 5 without testing any cube gives 4.5. Going up to the next tenth because 4.6³ fell short of 100, without checking that 4.65³ already overshoots, gives 4.7. Comparing 100 with the two given cubes, 64 and 125, noticing that 100 is nearer to 125, and rounding straight to the nearest whole number gives 5.0 — but that comparison is between the cubes, not between the cube roots, and cubing stretches the gaps unevenly, so it says nothing about which value the cube root rounds to.
- (c) 0.7, 0.72, 3/4 — Method: numbers written in different forms cannot be compared as they stand, so every fraction is turned into a decimal by dividing the numerator by the denominator, and the decimals are then compared place by place from the left. Working: 3/4 means 3 ÷ 4 = 0.75, so the three values to compare are 0.7, 0.75 and 0.72; written to two decimal places they are 0.70, 0.75 and 0.72, and the hundredths digits 0, 5 and 2 put 0.70 first, 0.72 next and 0.75 last; written again in the forms the question used, the order from smallest is 0.7, then 0.72, then 3/4. Answer: 0.7, 0.72, 3/4. The distractors: 3/4, 0.7, 0.72 comes from turning 3/4 into 0.34 by writing the numerator and the denominator as the two digits after the point, which makes the fraction the smallest of the three; 0.72, 3/4, 0.7 comes from the belief that the more digits a decimal has the smaller it must be, which puts both 0.72 and 0.75 below 0.7 and 0.72 below 0.75; 3/4, 0.72, 0.7 comes from comparing the three values correctly but listing them largest first, against an instruction to start with the smallest.
- (c) 693 — Method: multiplying a bracket by a number multiplies every term inside it, so 7 × (100 − 1) = 7 × 100 − 7 × 1. Working: 7 × 100 = 700 and 7 × 1 = 7, so the calculation becomes 700 − 7 = 693. Answer: 693. The distractors: 699 comes from subtracting the 1 itself rather than 7 lots of it, giving 700 − 1 = 699; 707 comes from adding the second product instead of subtracting it, giving 700 + 7 = 707; 700 comes from rounding 99 up to 100 and then offering the estimate 7 × 100 as an exact value.
- (b) 18.5 ≤ T < 18.7 — Method: the error interval reaches half the rounding unit either side of the recorded value. Working: half of 0.2 is 0.1, so the interval runs from 18.6 − 0.1 to 18.6 + 0.1. Answer: 18.5 ≤ T < 18.7. (18.4 ≤ T < 18.8 comes from using the full rounding unit, 0.2, either side instead of half of it. 18.5 ≤ T ≤ 18.7 comes from including the upper bound with ≤ instead of excluding it with <. 18.6 ≤ T < 18.8 comes from treating the recorded value as the start of the interval and adding the whole rounding unit, 0.2, above it.)
- (a) They cannot both be describing the same path — Jon's measurement means the true length, l, satisfies 11.5 m ≤ l < 12.5 m. Mia's measurement means the true length satisfies 12.55 m ≤ l < 12.65 m. These two ranges do not overlap, so the two measurements cannot both be describing the same path. 'They must both be describing the same path' ignores that the two ranges do not overlap at all. 'Jon's measurement must be wrong' wrongly assumes Jon is the one at fault, when the mismatch does not show which measurement, if either, is wrong. 'Mia's measurement must be wrong' makes the same unjustified assumption in the other direction.
- (a) 1/3 — To subtract these fractions, first write 3/4 with a denominator of 12: 3/4 = 9/12. Then 9/12 − 5/12 = 4/12, which simplifies to 1/3. Subtracting the numerators and the denominators separately, (3 − 5)/(4 − 12), gives −2/−8, which simplifies to 1/4. Changing 3/4 to twelfths by only changing the denominator, without scaling the numerator to match, gives 3/12 − 5/12 = −2/12, which simplifies to −1/6. Adding the fractions instead of subtracting them, 9/12 + 5/12, gives 14/12, which simplifies to 7/6.
- (d) 28 — Method: round each number to the nearest whole number, then multiply the rounded numbers to get an estimate that can be compared with the assistant's answer. Working: 7.2 rounds to 7, and 3.9 rounds to 4, so the estimate is 7 × 4 = 28. Since 28 is much smaller than 56.16, the assistant's answer cannot be correct. 56 comes from rounding the assistant's answer to the nearest whole number, instead of rounding the two numbers being multiplied and then multiplying them. 35 comes from rounding both numbers correctly but then slipping in the seven times table, writing 7 × 5 = 35 in place of 7 × 4 = 28. 21 comes from rounding 3.9 down to 3 instead of 4, giving 7 × 3 = 21. Answer: 28.
- (d) x⁴ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided. Working: six factors of x on the top and two on the bottom cancel in pairs, leaving 6 − 2 = 4 factors of x. Answer: x⁴. The distractors: x³ comes from dividing the indices, 6 ÷ 2, instead of subtracting them; x⁸ comes from adding the indices, 6 + 2, as though the powers were being multiplied; x¹² comes from multiplying the indices, 6 × 2, as though a power were being raised to a power.
- (b) 4.05 — Method: line up the decimal points (or place value columns) before adding. Working: 3.60 + 0.45 = 4.05. Answer: 4.05. 3.65 is Priya's answer, from adding the digits without lining up the place value columns, which effectively treats 0.45 as 0.05. 4.5 comes from rounding both numbers up first, 3.6 to 4 and 0.45 to 0.5, and adding those instead of adding the exact values. 0.81 comes from adding the digits 36 and 45 together to get 81, then placing the decimal point in the wrong position.
- (c) 12.3 ≤ t < 12.4 — Method: truncating cuts the later digits off instead of rounding them, so nothing is ever pushed upwards. The displayed value is therefore the smallest the time can be, and the time can run up to, but not reach, the next value the display can show. Working: the display reads 12.3, so the actual time is at least 12.3 seconds; as soon as the time reaches 12.3 + 0.1 = 12.4 seconds the display would read 12.4, so 12.4 is not included. Answer: 12.3 ≤ t < 12.4. The distractors: 12.25 ≤ t < 12.35 is the interval for a time rounded to 1 decimal place, and this display does not round; 12.3 < t ≤ 12.4 excludes the one value the display certainly allows and includes the one it rules out; 12.3 ≤ t ≤ 12.4 treats 12.4 seconds as possible, but at 12.4 seconds the display would no longer read 12.3.
- (a) 18 — Method: round each number to the nearest whole number, then square each rounded number and add the results. Working: 2.9 rounds to 3 and 3.1 rounds to 3, so the estimate is 3² + 3² = 9 + 9. Answer: 18. The distractors: 36 comes from adding before squaring, working out (3 + 3)² instead of 3² + 3²; 12 comes from doubling each rounded number instead of squaring it, adding 6 and 6; 6 comes from adding the two rounded numbers and forgetting to square them at all.
Build your own mix at the worksheet builder.