Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 150 m — Method: a fraction acts as an operator, so finding 3/7 of a length means dividing by the denominator and multiplying by the numerator. Working: 350 ÷ 7 = 50, so one seventh of the route is 50 m, and three sevenths is 50 × 3 = 150 m. Answer: 150 m. The distractors: 50 m comes from finding one seventh and stopping there instead of multiplying by 3; 1050 m comes from multiplying by the numerator without dividing by the denominator, giving 350 × 3 = 1050; 200 m comes from working out the stretch of the route the footpath does not run alongside, which is 4/7 of 350 m, instead of the stretch it does.
- (a) 1/2, 3/5, 2/3, 5/6 — Convert all four fractions to a common denominator of 30: 2/3 is 20/30, 3/5 is 18/30, 5/6 is 25/30, and 1/2 is 15/30. Ordering by these numerators, smallest to largest, gives 15/30, 18/30, 20/30, 25/30, which is 1/2, 3/5, 2/3, 5/6. Ordering by the size of the numerator in the original fractions, 1, 2, 3, 5, rather than converting to a common denominator, gives the wrong order 1/2, 2/3, 3/5, 5/6, because it ignores that the denominators are different. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 5/6, 2/3, 3/5, 1/2. Using the rule "the bigger the denominator, the smaller the fraction" to place the last two, so that 5/6 is put below 2/3 because 6 is bigger than 3, gives 1/2, 3/5, 5/6, 2/3 — that rule only holds when the numerators are the same, and here 20/30 really is smaller than 25/30. So the correct order, smallest to largest, is 1/2, 3/5, 2/3, 5/6.
- (c) An under-estimate, by 8 — Method: work out the exact product, then compare it with the estimate; an estimate that is smaller than the exact value is an under-estimate, and the difference between them is the size of the error. Working: 48 × 21 = 48 × 20 + 48 = 960 + 48 = 1,008, and 1,008 − 1,000 = 8, so the estimate falls short. Answer: an under-estimate, by 8. The distractors: an over-estimate by 8 has the size of the error right but the direction wrong, and comes from assuming that rounding 48 up to 50 must push the estimate above the exact value, without allowing for 21 being rounded down; an over-estimate by 19 comes from working out 48 × 21 as 48 × 20 + 21 = 981, adding a 21 where another 48 belongs; the claim that the estimate is exactly right comes from arguing that one number was rounded up and the other down, so the two changes must cancel.
- (b) 28 — Method: count the ordered choices with the product rule and then correct for the double counting, because the two captains have equal standing and so a pair is the same pair whichever captain is named first. Working: there are 8 players who could be named first and 7 who could be named second, giving 8 × 7 = 56 ordered choices; each pair has been counted twice, once in each order, so the number of pairs is 56 ÷ 2 = 28. Answer: 28. The distractors: 56 comes from stopping at 8 × 7 and never halving, which counts each pair of captains twice; 64 comes from working out 8 × 8, which allows the same player to be chosen as both captains; 16 comes from multiplying the 8 players by the 2 captaincies instead of pairing the players with one another.
- (a) 23 — Division undoes multiplication, so the missing number is 391 ÷ 17 = 23. Writing down 17 repeats the number already given instead of solving for the missing one. Subtracting instead of dividing gives 391 − 17 = 374. Multiplying instead of dividing gives 391 × 17 = 6647.
- (d) 12 — Method: if the bracelets are identical and no beads are left over, the number of bracelets must divide exactly into both totals, so it is the highest common factor of 24 and 36. Working: 24 = 2³ × 3 and 36 = 2² × 3²; taking the lower index of each shared prime gives 2² × 3 = 4 × 3 = 12. Each bracelet then has 2 red beads and 3 blue beads. Answer: 12. The distractors: 6 comes from taking each shared prime once rather than at its lower index, giving 2 × 3, which is a common factor but not the highest; 72 is the lowest common multiple of 24 and 36, from taking the higher index of each prime instead of the lower; 60 comes from adding the two bead totals instead of looking for a common factor.
- (d) 360 km — Method: first find the kilometres per litre by dividing distance by fuel used, then multiply this rate by the new tank size. Working: 180 ÷ 6 = 30 km per litre; 30 × 12 = 360 km. Answer: 360 km. 30 km comes from finding the correct fuel consumption but stopping there, without scaling it up to the full tank. 2160 km comes from multiplying the original distance (180) by the tank size (12) directly, skipping the unit rate. 90 km comes from pairing the numbers the wrong way round: dividing the distance by the new tank size, 180 ÷ 12 = 15, and then multiplying by the original 6 litres, 15 × 6 = 90.
- (c) 0.001 — Method: a negative index means 'one over' the positive power, so $10^{-3}$ means one over $10^{3}$. Working: ten cubed is 1000, and one over 1000 is 0.001. 1000 comes from ignoring the negative sign and working out ten cubed instead of its reciprocal. −1000 comes from ignoring what the negative index does to the size, while still writing a negative sign on the large value. −0.001 comes from correctly finding the size, 0.001, but wrongly keeping a negative sign because the index was negative. Answer: 0.001.
- (b) 0.83333... — Divide 5 by 6 using long division. 5.000... ÷ 6: 50 ÷ 6 = 8 remainder 2, giving the first decimal digit 8. Bring down a 0 to make 20, and 20 ÷ 6 = 3 remainder 2 — the remainder 2 has reappeared, so from here the digit 3 repeats forever. This gives 5/6 = 0.83333... . Stopping after two decimal places and writing 0.83 treats the division as if it terminated, when the remainder never reaches zero. Shifting the decimal point one place too far to the left gives 0.083333..., the same digits divided by an extra power of ten. A slip in the long division itself, misreading a remainder, can produce the wrong repeating digit, 0.85555... .
- (c) 25/36 — Method: square a fraction by squaring its numerator and its denominator separately, then add the two results over a common denominator. Working: (2/3)² = 4/9 and (1/2)² = 1/4; the lowest common denominator of 9 and 4 is 36, so 4/9 = 16/36 and 1/4 = 9/36, and 16 + 9 = 25. Answer: 25/36. The distractors: 49/36 comes from adding the two fractions first and squaring the total, giving (7/6)²; 5/13 comes from squaring correctly but then adding the numerators and the denominators, as (4 + 1)/(9 + 4); 7/3 comes from doubling each fraction instead of squaring it, giving 4/3 + 1.
- (a) 2a²b³ — Method: a fourth root applies to every factor inside it, and taking the fourth root of a power divides that power's index by 4. Working: 2 × 2 × 2 × 2 = 16, so the fourth root of 16 is 2; 8 ÷ 4 = 2 gives a², and 12 ÷ 4 = 3 gives b³. Answer: 2a²b³. The distractors: 2a⁴b⁶ comes from halving both indices, treating every root sign as a square root; 4a²b³ comes from taking the square root of 16 while dividing the letters' indices by 4; 2a²b⁴ comes from dividing b's index by 3 instead of by 4, as though b sat under a cube root.
- (a) 2/5 — The ratio 2:3 has 2 + 3 = 5 parts in total, and the larger plot is 3 of those parts. Since the larger plot is 18 m², each part is 18 ÷ 3 = 6 m², so the total area is 5 × 6 = 30 m² and the smaller plot is 2 × 6 = 12 m². The fraction of the total area taken up by the smaller plot is 12/30, which simplifies to 2/5. Giving the fraction for the larger plot instead of the smaller one gives 3/5. Comparing the smaller plot to the larger plot instead of to the total area gives 2/3. Assuming the two plots split the area evenly, ignoring the given ratio altogether, gives 1/2.
- (a) 4,000 nanometres — Method: the number of nanometres is the diameter divided by the length of one nanometre, and dividing powers of ten means subtracting the indices. Working: −6 − (−9) = 3, so 10⁻⁶ ÷ 10⁻⁹ = 10³, and the diameter is 4 × 10³ nanometres. Answer: 4,000 nanometres. The distractors: 400 nanometres comes from taking the difference between the indices as 2 instead of 3; 4 nanometres comes from changing the name of the unit without converting, leaving the coefficient untouched; 0.004 nanometres comes from dividing by 10³ instead of multiplying by it, as though a nanometre were the larger of the two units.
- (d) x⁽¹⁄²⁾ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided, and fractional indices are subtracted like any other fractions. Working: 3/4 − 1/4 = 2/4, which simplifies to 1/2, so the result is x⁽¹⁄²⁾. Answer: x⁽¹⁄²⁾. The distractors: x comes from adding the indices, 3/4 + 1/4 = 1, as though the powers were being multiplied; x³ comes from dividing the indices, so that 3/4 divided by 1/4 gives 3; x⁽³⁄¹⁶⁾ comes from multiplying the indices, 3/4 × 1/4.
- (d) 6 × 10⁷ — Method: the coefficients and the powers of ten are handled separately — multiply the coefficients, and add the indices because the powers share the base 10. Working: 2 × 3 = 6 for the coefficients, and 10³ × 10⁴ = 10⁷ for the powers; 6 lies between 1 and 10, so the coefficient needs no adjustment. Answer: 6 × 10⁷. The distractors: 5 × 10⁷ comes from adding the coefficients, 2 + 3, instead of multiplying them; 6 × 10¹² comes from multiplying the indices, 3 × 4, instead of adding them; 6 × 10¹ comes from subtracting the indices, 4 − 3, which is the rule for dividing rather than for multiplying.
Build your own mix at the worksheet builder.