Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 2 — Method: a fourth root undoes raising to the power 4, so look for the number that gives 16 when it is multiplied by itself four times. Working: 2 × 2 = 4, 4 × 2 = 8 and 8 × 2 = 16, which uses four factors of 2. Answer: 2. The distractors: 4 comes from taking the square root of 16 instead of its fourth root; 8 comes from halving 16, treating any root as a halving; 64 comes from multiplying 16 by 4 instead of taking a fourth root.
- (a) 37.5 — The error intervals are 45 ≤ c < 55 and 17.5 ≤ d < 18.5. The maximum possible value of a difference comes from the largest possible value being reduced by the smallest amount: use the upper bound of c together with the LOWER bound of d, since subtracting less gives a bigger result: 55 − 17.5 = 37.5. Using the upper bound for both quantities, 55 − 18.5 = 36.5, forgets that subtracting a bigger number gives a smaller answer, not a bigger one. Using the lower bounds for both, 45 − 17.5 = 27.5, gives the lower bound of the difference instead of the upper one. Using the lower bound of c with the upper bound of d, 45 − 18.5 = 26.5, combines the two bounds the wrong way round entirely.
- (d) 7/20 — Method: write the decimal over the power of ten that matches the number of digits after the point, then divide the numerator and the denominator by their highest common factor. Working: 0.35 has two digits after the point, so it is 35 hundredths and can be written as 35/100; the highest common factor of 35 and 100 is 5, and 35 ÷ 5 = 7 with 100 ÷ 5 = 20. Answer: 7/20. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 7/25 comes from dividing the numerator by 5 but the denominator by 4, using a different factor on the top and on the bottom; 35/10 comes from counting one decimal place instead of two and writing the digits over 10.
- (d) 6 — By Pythagoras' theorem, the square of the hypotenuse equals the sum of the squares of the other two sides: (√12)² + (√24)² = 12 + 24 = 36. The hypotenuse is √36 = 6 cm. Adding the two side lengths directly instead of squaring them first, treating the theorem as if it were a straight sum of the sides, gives √12 + √24 = 2√3 + 2√6. Multiplying the two squared values, 12 × 24 = 288, instead of adding them, then taking the root, gives √288 = 12√2. Adding the squares correctly to get 36 but forgetting to take the square root at the end leaves 36 as the answer instead of the hypotenuse itself.
- (c) 9 — Method: factors come in pairs that multiply to give the number, so work through the pairs in order; a factor paired with itself is counted only once. Working: the pairs are 1 × 100, 2 × 50, 4 × 25, 5 × 20 and 10 × 10. The first four pairs give eight different factors, and the last pair adds only one more, so the factors are 1, 2, 4, 5, 10, 20, 25, 50 and 100. Answer: 9. The distractors: 10 comes from counting the pair 10 × 10 as two separate factors; 8 comes from leaving 1 out of the list, on the view that 1 is not a proper factor; 4 comes from writing 100 = 2² × 5² and multiplying the two indices together instead of adding 1 to each index first.
- (b) 120 — Method: fill the positions on the shelf one at a time; each book placed leaves one fewer book available for the next position, and the product rule multiplies the choices. Working: there are 5 books for the first position, 4 for the second, 3 for the third, 2 for the fourth and 1 for the last, so the number of orders is 5 × 4 × 3 × 2 × 1 = 120. Answer: 120. The distractors: 25 comes from multiplying the 5 books by the 5 positions rather than multiplying the shrinking number of choices at each position; 60 comes from halving the correct product, as though each order had been counted twice in the way that pairs are; 720 comes from carrying the product one factor too far and working out 6 × 5 × 4 × 3 × 2 × 1, as though there were six books.
- (a) 12 — Method: build the number one place at a time, listing systematically: fix the tens digit, then run through every units digit that is still available. Working: any of the 4 digits can go in the tens place, and once it has been used only 3 digits are left for the units place, so there are 4 × 3 = 12 numbers; listing the numbers that begin with 1 gives 12, 13 and 14, and each of the other three starting digits gives 3 numbers in the same way. Answer: 12. The distractors: 16 comes from working out 4 × 4, which allows a digit to be used twice; 8 comes from multiplying the 4 digits by the 2 places in the number instead of multiplying the choices available at each place; 6 comes from treating a number and its reverse as the same, counting only the unordered pairs of digits.
- (c) 2700 cm² — Convert both lengths to the same unit before multiplying: 0.6 m = 60 cm. The area is 45 × 60 = 2700 cm². Multiplying without converting 0.6 m to centimetres at all, treating it as 0.6 cm, gives 45 × 0.6 = 27 cm². Converting 0.6 m to centimetres by multiplying by 10 instead of 100 gives 6 cm, and 45 × 6 = 270 cm². Converting 0.6 m to centimetres by multiplying by 1000 instead of 100 gives 600 cm, and 45 × 600 = 27000 cm².
- (a) 2 × 3² × 5 — Method: divide repeatedly by the smallest prime number until only prime factors remain. Working: 90 ÷ 2 = 45, 45 ÷ 3 = 15, 15 ÷ 3 = 5, and 5 is prime, so 90 = 2 × 3 × 3 × 5, written as 2 × 3² × 5. 2 × 3 × 15 stops before the 15 is broken down into 3 × 5, so it is not fully factorised. 3 × 3 × 10 stops before the 10 is broken down into 2 × 5. 2 × 45 stops after only one division. Answer: 2 × 3² × 5.
- (a) 71 — 2.9⁴ = (2.9²)². First, 2.9² = 8.41. Then square that: 8.41² = 70.7281, since 841² = 707281 and the decimal point moves four places. To 2 significant figures this rounds to 71, because the figure after the first two significant figures (7 and 0) is a 7, which rounds the 0 up to 1. Rounding the working down instead of up — taking 70.7281 to 70 — ignores that the next figure is 5 or more. Rounding 2.9 up to 3 before doing any working at all, then computing 3⁴ = 81, uses a much cruder approximation and overshoots the true value. Rounding 8.41 all the way down to 8 before squaring, 8² = 64, rounds far too aggressively and loses the accuracy needed for 2 significant figures.
- (d) 6 — Method: the square root of a product can be found either by multiplying first and then rooting, or by rooting each factor and multiplying the two roots together. Working: 4 × 9 = 36, and 6 × 6 = 36, so the root is 6; the same value comes from √4 × √9 = 2 × 3. Answer: 6. The distractors: 36 comes from multiplying inside the root and then leaving the root untaken; 5 comes from rooting each factor and adding the results, 2 + 3, instead of multiplying them; 18 comes from rooting the 4 only and leaving the 9 untouched, giving 2 × 9.
- (d) 9 — List all the factors of 36 in pairs that multiply to give 36: 1 × 36, 2 × 18, 3 × 12, 4 × 9, and 6 × 6. This gives the factors 1, 2, 3, 4, 6, 9, 12, 18 and 36 — nine factors in total, with 6 counted only once even though it appears in a pair with itself. Forgetting that 36 is itself a factor of 36 and leaving it off the list gives 8. Counting the number of factor pairs, five of them, rather than the number of individual factors gives 5. Treating the repeated pair 6 × 6 as two separate factors, 6 and 6 again, gives 10 instead of 9. So 36 has 9 factors.
- (b) 3/5 — Method: add all three parts for the total, add together the parts that are not green, then write this over the total. Working: total parts = 4 + 5 + 6 = 15. Not green = 4 + 5 = 9. Fraction = 9/15 = 3/5. Answer: 3/5. 2/5 comes from finding the fraction that IS green (6/15 = 2/5) instead of not green. 4/15 comes from only counting the red baubles as 'not green' and forgetting the gold ones. 9/10 comes from adding only two of the three ratio parts to find the total (4+6=10), missing out the gold part, while still using 9 for the numerator.
- (b) 88.8 — Multiply as whole numbers first, ignoring the decimal point: 37 × 24. Split it as 37 × 20 = 740 and 37 × 4 = 148, so 37 × 24 = 740 + 148 = 888. 3.7 has 1 decimal place and 24 has none, so the answer needs 1 decimal place: 88.8. Counting the 2 digits in "3.7" as though that were the number of decimal places gives 8.88 instead of 1 decimal place. Leaving the decimal point out altogether gives 888. Misreading 37 × 4 as 138 rather than 148 gives a running total of 878, placed with 1 decimal place as 87.8. So 3.7 × 24 = 88.8.
- (d) −1.4, −6/5, 0, 5/4, 1.3 — Method: convert the fractions 5/4 and −6/5 to decimals so every number is written the same way, then compare all five decimals. Working: 5/4 = 1.25 and −6/5 = −1.2. Comparing −1.4, −1.2, 0, 1.25 and 1.3 in size gives the order −1.4, −1.2, 0, 1.25, 1.3. Answer: −1.4, −6/5, 0, 5/4, 1.3. −6/5, −1.4, 0, 5/4, 1.3 swaps the two negative numbers, treating −6/5 as more negative than −1.4 even though −1.2 is closer to zero than −1.4. 1.3, 5/4, 0, −6/5, −1.4 lists the numbers from largest to smallest instead of smallest to largest. −1.4, −6/5, 0, 1.3, 5/4 swaps 5/4 and 1.3, comparing the numerator 5 directly with 1.3 instead of converting 5/4 to the decimal 1.25 first.
Build your own mix at the worksheet builder.